SOLICITATION NOTICE
49 -- Chemical Agent Resistant Coating (CARC) Application System
- Notice Date
- 5/10/2002
- Notice Type
- Solicitation Notice
- Contracting Office
- USPFO for Mississippi, 144 Military Drive, Jackson, MS 39208-8860
- ZIP Code
- 39208-8860
- Solicitation Number
- DAHA22-02-T-0034
- Response Due
- 5/30/2002
- Archive Date
- 6/29/2002
- Point of Contact
- Joe Smith, 601-313-1556
- E-Mail Address
-
Email your questions to USPFO for Mississippi
(joe.smith@ms.ngb.army.mil)
- Small Business Set-Aside
- Total Small Business
- Description
- NA DESC: This is a combined synopsis/solicitation for commercial items prepared in accordance with the format in Far Subpart 12.6 as supplemented with additional information included in the notice. This announcement constitutes the only solicitation. Quotes are being requested and a written solicitation will not be issued. Solicitation No. DAHA22-02-T-0034 applies and is issued as a Request for Quotation. This document and incorporated provisions and clauses are those in effect through Federal Acquisition C ircular 2001-01. This solicitation is 100% set aside for small business. The NAICS is 421830, Small Business size 500 employees. The resultant contract is for the purchase and installation of: (1) Chemical Agent Resistant Coating (CARC) Application Syste m consisting of: Two 4:1 ratio stainless steal air operated fluid pumps that delivers 3.8 gallons per minute and one 1:1 ratio high performance double diaphragm solvent flush pump, delivering 4 gallons per minute to fed four paint stations. Paint and solv ent will be fed through stainless steel tubing to each paint station. The tubing will loop to all four paint stations and return back to the paint mixing room feeding back to the two recirculating valves on the pumps. Four paint stations, each booth will have two stations with one station on each side of the booths. Each station will have two HVLP spray guns (guns requires 50? x ?? I.D. Fluid Hose w/couplers and 50? x 5/16? I.D. Air hose w/couplers). All stations will be equipped with two back pressure fluid regulators (0-500 psi) with pressure gage, 3/8? inlet and outlet, two three way valves which will allow the painter to change from a paint position to a flush position, and three atomizing regulators (80 psi max) with pressure gage, ?? inlet and outl et, two to control atomizing air to spray guns and one to be used for all other spray equipment. Two portable application systems consisting of: 1:1 ratio high performance double diaphragm fluid pump, a 2 in 1 fluid regulator, a gun air regulator, five ga llon suction rods, two wheel carts and one HVLP spray gun (gun requires 50? x ?? I.D. fluid hose w/couplers and 50? x 5/16? I.D. air hose w/couplers). Two portable two-component pumping systems for primer with fixed ratio proportioning pump, delivering .6 GPM at 30 Cycles per minute. Solvent flush pump, static mixer, ratio test kit, gun air regulators, pump air regulator, catalyst battle, five gallon suction rods, two gun manifold, two HVLP spray guns (guns requires 50? x ?? I.D. fluid hose w/couplers and 50? x 5/16? I.D. air hose w/couplers, and a portable stand with casters. The fluid nozzle orifice for the High Volume Low Pressure Spray Guns will be 1.2mm and pattern width 300mm. Agitated pressure pot with at least a 19.8 gallon stainless steel, singl e regulated with an agitator, certified and permanently labeled for 110 PSIG maximum working pressure. Constructed of heavy stainless steel and electropolished. Hose fittings will be Schrader type. Additional two HVLP spray guns with hoses for back up. (2) Air Supply System and Solvent Recovery System consisting of: two wall mounted Air Filtration units, one to service each spray booth. Respirable breathing air stations will be located in each booth to support up to four painters simultaneously. (3) On e assembled solvent distillation unit capable of processing solvents up to 300 deg. F., with capacity up to fifty-five gallons of solvent per eight hur shifts. Distillation Unit: High conductivity boiling chamber, fully insulated and Teflon coated. She ll and tube heat exchanger, electric cast encapsulated heating coil with lifetime warranty, gravity feed via 316ss pipe with solvent compatible discharge hose, adjustable temperature controller, explosion-proof electronics, adjustable cycle time, auto shut down, vapor temperature gauge, boiling chamber view glass, cooling water flow and heater operation indicator lights. Closed-loop water/glycol recalculation sys tem, designed for use with solvents with boiling points above 150 deg. F. Utility requirement: 220/1/60 voltage. Eight painters hoods w/breathing tubes and coolers. This equipment is to be installed at building 6505, Camp Shelby, MS. POC for any technica l questions is CPT Brown @ 601-558-2983. Also he would be the contact for site visits. The following clauses apply: FAR 52.212-1, Instructions to Offerors-Commercial Items (Oct 2000), FAR 52.212-2 Evaluation ?Commercial Items (Jan 1999). The following fact ors will be used to evaluate Offers: (1) Past performance- Offers are required to submit three(3) references where work for same or similar projects were completed to customer satisfaction. (2) Technical. Offers must demonstrate how their product will meet the requirements of the RFQ. Also a site visit is highly recommended to verify all existing job conditions and dimensions. Failure to attend a site visit does not relieve the contractor of his/her contractual rights. All Equipment must meet OSHA and EPA S tandards. (3) Price. Technical and past performance, when combined are equal important as cost or price. FAR 52-212-3, Offeror Representations and Certifications-Commercial Items, FAR 52-212-4, Contract Terms and Conditions-Commercial Items, FAR 52.212-5, Contract Terms and Conditions Required to Implement Statutes or Executive Orders-Commercial Items , FAR 52.222-21, Prohibition of Segregated Facilities, FAR 52.222-26, Equal Opportunity, FAR 52.222-35, Equal Opportunity for Special Disabled Veterans, Veter ans of the Vietnam Era and other Eligible Veterans, FAR 52.222-36, Affirmative action for Workers with Disabilities, 52.222-37, Employment Reports on Special Disabled Veterans, Veterans of the Vietnam Era and Other Eligible Veterans, FAR 52.222-19, Child L abor-Cooperation with Authorities and Remedies, FAR 52.225-13, Restriction on Certain Foreign Purchases, FAR 52.232-33, Payment by Electronic Funds Transfer-Central Contractor Registration, FAR 52.239-1, Privacy or Security Safeguards, FAR 52-247-64, Prefe rence for Privately Owned U.S.-Flag Commercial Vessels, DFARS 252-204-7004- Required Central Contractor Registration, DFARS 252-225-7001, Buy American Act and Balance of Payment Program, DFARS 252-225-7012, Preference for Certain Domestic Commodities, DFA RS 252-247-7024, Notification Of Transportation of Supplies by Sea. Award can only be made to hose offerors that are registered through the Central Contractor Registration System. For those not registered, you may log onto the Internet at www.ccr.gov or t elephone (888) 227-2423. All offerors must include a completed copy of FAR 52.212-3, Offeror Representations and certifications ?Commercial Items. Quotes are due no later than 4:30 CST, May 30, 2002. Address quotes to USPFO-MS, Attn: NGMS-PFO-PC (Mr. Joe Smith), 144 Military Drive, Jackson, Mississippi 39232-8861. POINTS OF CONTACT: Technical questions may be addressed to Captain Jon Brown (601) 558-2983; E-mail jon.brown@ms.ngb.army.mil. Questions regarding contractual documents may be addressed to Joe Smith, Contract Specialist, at (601) 313-1556 or E-mail joe.smith@ms.ngb.army.mil. The Contracting Office?s web site is located at www.ngms.state.ms.us/public/uspfo/purchasing/index.htm.
- Place of Performance
- Address: USPFO for Mississippi 144 Military Drive, Jackson MS
- Zip Code: 39208-8860
- Country: US
- Zip Code: 39208-8860
- Record
- SN00075140-W 20020512/020510213201 (fbodaily.com)
- Source
-
FedBizOpps.gov Link to This Notice
(may not be valid after Archive Date)
| FSG Index | This Issue's Index | Today's FBO Daily Index Page |