SOLICITATION NOTICE
59 -- Donaldson Torit Downflow Dust Collector
- Notice Date
- 8/19/2002
- Notice Type
- Solicitation Notice
- Contracting Office
- Department of Health and Human Services, Food and Drug Administration, Division of Contracts and Procurement Management, Office of Facilities, Acquisitions, and Central Svcs 5600 Fishers Lane, HFA-511, Rockville, MD, 20857
- ZIP Code
- 20857
- Solicitation Number
- Reference-Number-245086
- Response Due
- 9/3/2002
- Point of Contact
- Ida Cofield, Contract Specialist, Phone (301) 827-7156, Fax (301) 827-7151,
- E-Mail Address
-
icofield@oc.fda.gov
- Description
- This is a combined synopsis /solicitation for commercial items or services prepared in accordance with Simplified Acquisition Procedures as supplemented with additional information included in this notice. This announcement constitutes the only solicitation and a written solicitation will not be issued. This solicitation is issued as a Request for Quote (RFQ) No. 245086. The solicitation clauses and provisions are those in effect through Federal Acquisition Circular 97-27. The Standard Industrial Classification (SIC) Code for this acquisition is 5049 and the North American Classification System (NAICS) Code is 443112. The Food and Drug Administration (FDA) is issuing a Request for Quote for the following:Donaldson Torit Downflow series dust collector Model DFT 2-8,Filter Area 960 square feet Air to Media Ratio: 3.65:1, Filter Cartridge Material: Fibra Web, Filter Quantity 8, Design Condition 3500 cfm at 11.5 inch wg, Housing construction is 7,10,and 12 guage steel, rated for negative 20 inch wg, Finish exterior surfaces are painted with a blue finish. Interior surfaces are primed with blue. Discharged Hopper: Hopper is 12 gauge steel square on the top and octagonal on the bottom. Collector has one hopper per module, one total. Bottom discharge is a 14 inch octagonal opening with a bridge free design and internal ledges. Discharge hopper attaches to a 55 gallon drum cover with slide gate and latches, 55 gallon drum not included. Support Leg Structure- Legs provide 48 inch clearance below the hopper discharge flange and are designed for seismic zone 4, 100 mph wind load, and 30 lbs per square foot roof load. Dust Laden Air Inlet- A high inlet creates a general downward air flow pattern in the filter section to optimize filter performance. Top and front inlet locations are standard on each module. Each filter column is protected from direct dust impingement by an internal baffle plate. Fibra-Web Filters- cartridges feature an open pleat banded design which improves pulse cleaning effectiveness when fibrous particles are present. In addition, Eon Fine Fiber Technology by Donaldson Company intercepts small particles at the surface of the media. Each cartridge contains 120 square feet of media for a total of 960 square feet in the collector. Filter Cleaning- Cartridges are automatically cleaned by periodic pulses of compressed air flowing in the opposite direction of normal air flow. The proprietary ExtraLife cleaning system provides a uniform pulse for maximum cleaning effectiness. Cleaning Controls- Torit Delta P Control which provides digital indication of differential pressure and initiates compressed air cleaning at a preset filter restriction. The Torit Delta P Control also indicates when the system is cleaning and when the filter restriction reaches a preset high level indicator light. Filter Access-cartridges are accessed from outside the collector through round access ports on the front of the unit. Each port provides access to two filter cartridges. No tools are required for filter removal installation. Filters are angled 15 degrees for easier servicing. Required Service-The collector requires 9 scfm of 90 to 100 psig, clean, dry compressed air based on a 10 second pulse interval. Timer requires 110 VAC. The system weighs approximately 1790 pounds. Torit Direct Drive Fan Backward Inclined Direct drive fan designed to deliver 3500 ACFM at 11.5 inch wg total static pressure. Fan field mounts to the top/side of the collector. Fan motor is 10 hp 3450 rpm 208/230/460/60/3 TEFC. Exterior surfaces are painted with a standard blue finish. Includes outlet damper. Explosion Relief Vents One 24 inch by 47 inch explosion relief vent is located on the top side of unit. Explosion vents limit overpressure in the event of a deflagration in order to maintain the structural integrity of the collector. Bag In/Bag Out Filter Access- The bag in bag out feature allows the removal of filter cartridges while isolating the cartridges and dirty air side of the collector from the operator. This feature includes bagging rings on each access port, security straps to secure the bags, and factory modifications at the cartridge support yoke. UltraLok- 1 high by 2 wide housing with two HEPA filters and two pre-filters. Includes magnehelic gage. Bin Level Indicator-Electromechanical point level control for use with dry materials. The following FAR Clauses shall apply to this solicitation 52.212-1 Instructions to Offerors-Commercial, 52.212-3 Offeror Representations and Certifications-Commercial Items, 52.212-4 Contract Terms and Conditions-Commercial Items. All responsible sources that can provide and meet the above requirements shall submit written quotations by the due date referenced above. FAR provisions can be found at the following website:http://www/arnet.gov.
- Place of Performance
- Address: Food and Drug Administration, 60 8th Street, NE, Atlanta, GA
- Zip Code: 30309
- Country: US
- Zip Code: 30309
- Record
- SN00143818-W 20020821/020819213223 (fbodaily.com)
- Source
-
FedBizOpps.gov Link to This Notice
(may not be valid after Archive Date)
| FSG Index | This Issue's Index | Today's FBO Daily Index Page |