SOLICITATION NOTICE
43 -- SLEEVE,SHAFT,PUMP
- Notice Date
- 3/3/2003
- Notice Type
- Solicitation Notice
- Contracting Office
- DEFENSE SUPPLY CENTER COLUMBUS; MARITIME SOLICITATIONS/AWARDS P.O. BOX 16704; COLUMBUS, OH 43216; US
- ZIP Code
- 00000
- Solicitation Number
- SPE760-03-T-6178
- Archive Date
- 4/16/2003
- Point of Contact
- Mario Santizo, (614)692-8156
- E-Mail Address
-
Email your questions to Mario Santizo
(Mario.Santizo@dscc.dla.mil)
- Small Business Set-Aside
- Total Small Business
- Description
- SLEEVE, SHAFT, PUMP. COMPOSITE MATERIAL. IF AQLS ARE LISTED IN THE SPECIFICATION(S) OR DRAWING(S) THEY MAY BE USED TO ESTABLISH THE AUTHORIZED SAMPLE SIZE, HOWEVER, THE ACCEPTANCE NUMBER FOR THIS CONTRACT IS ZERO; I.E., THIS CONTRACT REQUIRES A SAMPLING PLAN THAT ACCEPTS ON ZERO DEFECTS AND REJECTS ON ONE OR MORE DEFECT(S). "FINAL INSPECTION AND ACCEPTANCE OF MATERIAL SHALL BE AT THE ACTUAL MANUFACTURING FACILITY. TECHNICAL INSPECTION IS REQUIRED. THE CONTRACTOR SHALL MAKE DRAWINGS AND TECHNICAL INFORMATION AVAILABLE TO VERIFY THAT MATERIAL MEETS ALL TECHNICAL REQUIREMENTS. COUNT, KIND, AND CONDITION INSPECTIONS ARE NOT ACCEPTABLE. THIS NOTE TAKES PRECEDENCE OVER MASTER SOLICITATION PART ONE PROVISIONS, NOTE 6, QUOTATIONS BY NON-MANUFACTURERS (APR 1984, DCSC 52.217-9C01)". "QUOTES MUST BE BASED UPON FURNISHING AN ITEM MANUFACTURED BY AN APPROVED SOURCE AND FROM AN APPROVED MATERIAL CITED ON THE DRAWING REFERENCED BELOW. THE CITED DRAWING SPECIFIES WHICH MATERIALS ARE ACCEPTABLE AND PROVIDES INSTRUCTIONS FOR QUALIFYING ADDITIONAL MATERIALS AND SOURCES. OFFERS TO FURNISH MATERIALS OTHER THAN THOSE APPROVED MAY NOT BE CONSIDERED. CERTIFICATE OF QUALITY COMPLIANCE APPLIES - DLAR 52.246-9000 . DLAD CLAUSE 52.246-9004, PRODUCT VERIFICATION TESTING IS HEREBY INCORPORATED, AND MAY BE INVOKED AT THE DISCRETION OF THE PROCUREMENT ACTIVITY. . CONTRACTOR/MANUFACTURER IS REQUIRED TO ESTABLISH AND MAINTAIN A CALIBRATION SYSTEM THAT MEETS THE REQUIREMENTS OF ANSI/NCSL Z540-1-1994, AMERICAN NATIONAL STANDARD FOR CALIBRATION - CALIBRATION LABORATORIES AND MEASURING AND TEST EQUIPMENT - GENERAL REQUIREMENTS, OR ISO 10012-1, QUALITY ASSURANCE REQUIREMENTS FOR MEASURING EQUIPMENT- PART 1, METROLOGICAL CONFIRMATION SYSTEM FOR MEASURING EQUIPMENT. ADEQUATE DATA FOR THE EVALUATION OF ALTERNATE OFFERS IS NOT AVAILABLE AT THE PROCUREMENT AGENCY. THE OFFEROR MUST PROVIDE A COMPLETE DATA PACKAGE INCLUDING DATA FOR THE APPROVED AND ALTERNATE PART FOR EVALUATION.
- Place of Performance
- Address: SEE ADDITIONAL DELIVERY INFO; ; , AA 00000; US
- Zip Code: 00000
- Country: US
- Zip Code: 00000
- Record
- SN00267864-W 20030305/030303213040 (fbodaily.com)
- Source
-
FedBizOpps.gov Link to This Notice
(may not be valid after Archive Date)
| FSG Index | This Issue's Index | Today's FBO Daily Index Page |