SOURCES SOUGHT
J -- DRYDOCK & REPAIRS OF USCGC CUTTYHUNK (WPB 1322)
- Notice Date
- 11/5/2003
- Notice Type
- Sources Sought
- Contracting Office
- DHS - Direct Reports, United States Coast Guard (USCG), Commander (vpl), USCG Maintenance and Logistics Command - Pacific, Coast Guard Island Building 50-7, Alameda, CA, 94501-5100
- ZIP Code
- 94501-5100
- Solicitation Number
- Reference-Number-DTCG85-04-R-625CUTTYHUNK
- Response Due
- 11/14/2003
- Archive Date
- 11/29/2003
- Point of Contact
- Janyce DeCanto, Contracting Officer, Phone (510) 437-3773, Fax (510) 437-3392, - Rebecca Budde, Contracting Officer, Phone 510-437-3988, Fax 510-437-3392,
- E-Mail Address
-
jdecanto@d11.uscg.mil, rbudde@d11.uscg.mil
- Small Business Set-Aside
- Total HUB-Zone
- Description
- The U.S. Coast Guard is looking for certified HUBZone firms that may be interested and have the capabilities to perform DRYDOCK REPAIRS to USCGC CUTTYHUNK (WPB 1322), a 110?patrol boat, homeported in Port Angeles, Washington. Responses to this notice will be used for this procurement. The performance period will begin 28 April 2004 and complete 22 June 2004. The work items include but not limited to: production control, Gantt bar chart, sea trials, appendages (underwater) air test, appendages (underwater) preserve, internal, hull plating renewal, hull plating, underwater body inspect, spray rail and stern flap installation, voids (non-accessible) preserve, internal, tanks (MP fuel service) clean and inspect, tanks (MP fuel stowage and overflow) clean and inspect, propulsion shaft seal system replacement, propeller clean/inspect, exhaust flapper valve and spray ring assemblies replacement, fathometer transducers general maintenance, pressure gauges and thermometers (critical) calibration, aft berthing ventilation, sea strainer (all sizes) overhaul, sea valve (<=2.5 inches) renewal, sea valve (>2.5 inches) overhaul, rudder/rudder stock removal and reinstallation, fin stabilizers (general) maintenance, sewage pump inspection and overhaul, bilges preserve, potable water tank preservation, tanks (sewage) preserve, cathodic protection/capac system inspect/service, temporary services, drydock provide, drydocking/hauling. The HUBZone firm must meet the limitations for subcontracting requirements (FAR 52.219-14), which states: at least 50% of the cost of contract performance incurred for employees of the concern. The NAICS code assigned to this procurement will be 336611 (Ship Repair) with a size standard 1, 000 employees. The HUBZone small business concern as defined in CFR Title 13, Part 126.103. In accordance with CFR Title 13, part 126.200, at least 35% of a HUBZone certified firms employees must reside within a HUBZone. Firms that have been certified as a small business HUBZone by the Small Business Administration and have the interest and capabilities to perform the work under such a requirement, should submit the following information: (a) HUBZone certificate, (b) Company Name and Address; (c) Company point of contact, including telephone and facsimile numbers and e-mail address; (d) a positive statement of your intent to submit a offer for this requirement as a prime contractor; (e) evidence of experience in work similar in type and scope to include contract numbers, project titles, dollar amount, point of contact and telephone numbers; an (f) past performance references with points of contact and telephone numbers. This information should be forwarded to not later than 14 November 2003 to Janyce DeCanto at jdecanto@d11.uscg.mil or by fax (510) 437-3392. Failure to submit all information requested may result in an unrestricted acquisition. A decision on whether this will be pursued as a HUBZone small business set aside or on an unrestricted basis will be posted in the www.esp.gov.
- Record
- SN00464842-W 20031107/031105212935 (fbodaily.com)
- Source
-
FedBizOpps.gov Link to This Notice
(may not be valid after Archive Date)
| FSG Index | This Issue's Index | Today's FBO Daily Index Page |