Loren Data's SAM Daily™

FBO DAILY ISSUE OF MARCH 17, 2004 FBO #0842
SOLICITATION NOTICE

49 -- 4 EACH DOWNDRAFT BENCHES TO BE USED DURING THE SANDING OF AIRCRAFT ROTOR BLADES IN PREPARATION OF REPAIR OR PAINTING. TO INCLUDE SETUP, INSTALLATION AND TRAINING ON SITE IN SPRINGFIELD, MO

Notice Date

3/15/2004
 

Notice Type

Solicitation Notice
 

NAICS

336413 — Other Aircraft Parts and Auxiliary Equipment Manufacturing
 

Contracting Office

USPFO for Missouri, 7101 Military Circle, Jefferson City, MO 65101-1200
 

ZIP Code

65101-1200
 

Solicitation Number

W912NS-04-T-0051
 

Response Due

4/2/2004
 

Archive Date

6/1/2004
 

Point of Contact

SHIRLEY ZBINDEN, 573-638-9632
 

E-Mail Address

USPFO for Missouri
(shirley.zbinden@mo.ngb.army.mil)
 

Small Business Set-Aside

Total Small Business
 

Description

This is a combined synopsis/solicitation for commercial items prepared in accordance with the format in Subpart 12.6, as supplemented with additional information included in this notice. This announcement constitutes the only solicitation; proposals are being requested and a written solicitation will not be issued. The solicitation number W912NS-04-T-0051 is issued as a Request for Quote and incorporates provisions and clauses that are in effect through Federal Acquisition Circular 01-20 The North American Industry Classification System code is 336413. This is 100% set-aside for small b usiness. CLIN 0001 is for 4 each downdraft benches that will be utilized during the sanding of aircraft rotor blades in preparation for repair and painting. Each bench is to be 36 ½ feet by 52 inches deep with a working height of 38 inches. Each benc h must be a continuous run and minimum of 36 ½ feet. Access is only needed to the back side for servicing. The benches must be ducted to a central collector system and the collector system provided shall have explosion preventions. The benches must b e 240 VAC, 3 phase and the work surface capable of holding a minimum of 1,000 pounds. A minimum airflow of 3,000 cubic feet per minute is required. DA oscillating type sanders will be used. The filter system must have a minimum 40% control efficiency. Mass emission rate at maximum throughout must be less than 0.30 grans/dscf. As previously =stated the collector system must have explosion prevention and duct to a central collector/system. The collector must have a drum-full indicator and capable of wo rking in a colder climate, like the Midwest. An air makeup unit is required for use with the downdraft benches. Please keep in mind that this equipment will be utililzed in a controlled environment. The makeup of the rotor blades that will be worked on is some Kevlar, fiberglass, metal, nickel, adhesive (corrosive), sealing compound (combustible 200 degrees), acetone (negative 4), hazardous CARC paint which contains chromium. MSDS are available upon request to the undersigned. Drawings of the building are available upon request to Shirley Zbinden, 57-3638-9632 or email Shirley.zbinden@mo.ngb.army.mil. Warranty must be a minimum of 5 years. Offerors who fail to follow the format of this requirement may be found unacceptable. This will be a best value award based on following evaluation factors (listed in order of importance): Meeting technical requirements of the Government; past performance of vendor for same/similar item; location of servicing department for future servicing of equipment and price. Technical and past performance when combined are equal to price. Offerors must submit a completed copy of the provision at FAR 51.212-3, Offeror Representations and Certifications Commercial Items with offer. Offerors must submit a minimum of 3 past r eferences with whom you have completed jobs, preferably downdraft bench projects. References should include individuals’ names, company, phone number, type of work and date completed. The following FAR clauses are applicable 52.204-7 Central Contract or Registration; 52.212-1 Instructions to Offerors – Commercial Items; 52.212-4 Contract Terms and Conditions Commercial Items; 52.212-5 Contract Terms and Conditions Required to Implement Statutes or Executive Orders Commercial Items, paragraph b, (5 ), (13), (14), (15), (16), (17), (18), (19), (29), (31); 52.212-2 Evaluation – Commercial Items (see evaluation factors listed above). DFAR clauses 252.212-7000 Offeror Representations and Certifications – Commercial Items; 52.203-3 Gratuities; 252.212-7001 Contract Terms and Conditions and 252.225-7007 Buy American Act - Trade Agreements – Balance of Payments. Only contractors who are registered in the Central Contractor Registration (CCR) at https://www.ccr.dlis.dla.mil can be awarded a contract. A copy of this solicitation is available for downlo ading at http://www.uspfo-mo.org. Your offer, along with descriptive literature and past performance shall be faxed or emailed no later than April 2, 2004 at 5:00PM CST. Fax number (573) 638-9619 and email shirley.zbinden@mo.ngb.army.mil.
 

Web Link

Link to FedBizOpps document.
(http://www.eps.gov/spg/USA/NGB/DAHA23/W912NS-04-T-0051/listing.html)
 

Place of Performance

Address: USPFO for Missouri 7101 Military Circle, Jefferson City MO

Zip Code: 65101-1200

Country: US
 

Record

SN00545639-F 20040317/040315225158 (fbodaily.com)
 

Source

FedBizOpps.gov Link to This Notice
(may not be valid after Archive Date)

---

| FSG Index  |  This Issue's Index  |  Today's FBO Daily Index Page |