Loren Data's SAM Daily™

FBO DAILY ISSUE OF APRIL 11, 2004 FBO #0867
SOLICITATION NOTICE

C -- A/E Services for Billings, Bemidji, and Portland Areas (under $100K)

Notice Date

4/9/2004
 

Notice Type

Solicitation Notice
 

NAICS

541310 — Architectural Services
 

Contracting Office

Department of Health and Human Services, Indian Health Service, Seattle Office of Engineering Services, 2201 6th Avenue Mail Stop RX-24, Rm 710, Seattle, WA, 98121
 

ZIP Code

98121
 

Solicitation Number

102-AE-04-0007
 

Response Due

5/31/2004
 

Archive Date

6/15/2004
 

Point of Contact

Monica Weaver, Contracting Officer, Phone 206.615.2504, Fax 206.615.2466, - Casey Lafran, procurement technician, Phone 206-615-2462, Fax 206-615-2466,
 

E-Mail Address

Monica.Weaver@des.ihs.gov, clafran@des.ihs.gov
 

Description

The Division of Engineering Services?Seattle is seeking qualification statements from Architect and Engineering (A/E) firms to be included in the data file for requirements of the Billings, Bemidji, and Portland Areas of the Indian Health Service not to exceed the simplified acquisition threshold, $100,000. A/E Firms must be located within one of the states served by the three Area Offices: Washington, Oregon, Idaho, Montana, Wyoming, Minnesota, Wisconsin, and Michigan. All work shall be completed by or under the direction of a licensed professional engineer or registered architect. A/E firms interested in being considered for award of individual contracts for the services described below must submit two (2) copies of a completed SF 254, along with other relevant information in response to the evaluation criteria shown below, to the Division of Engineering Services, at the address shown above. An evaluation of firms will not be completed upon receipt of 254 submittals, except to ensure that the firm is located within the area of consideration and that the identified professionals are licensed or registered. All firms interested in being considered for award of contracts under the simplified acquisition threshold that meet the minimum qualification standards are encouraged to submit a response. At the time a requirement is identified, a set-aside decision will be made (buy-Indian, HUBZone, or unrestricted), based on the qualification statements in the data files. The services required at locations within the Area Office jurisdictions may include: engineering design support services for the design of maintenance and improvement projects for existing health care facilities, quarters and other related facilities; pre-design studies (e.g. energy audits/studies, code compliance, geo-technical investigation and reports, legal surveys, master plan studies and reports); civil/structural and architectural design for small buildings and health care facilities; mechanical design for HVAC and water and sewer interior piping for health care facilities; fire protection engineering services for health care facilities; and construction administration and inspection. Award of individual A/E service contracts shall be for specific projects based upon the review of the 254 forms on file with Engineering Services and evaluated for the selection criteria listed below by the designated Area Office evaluation chairperson or board and approved by the Contracting Officer. Individual contract amounts will be within the simplified acquisition threshold, and depending on the scope of work for each project. Contracts will be awarded to the most highly qualified firm. SELECTION CRITERIA: The award decision for each A/E contract will be based upon the following selection criteria, as they apply to the instant acquisition, listed below in descending order of importance. 1. Professional qualifications necessary for satisfactory performance of required services. 2. Specialized experience and technical competence in all applicable aspects of improvements and remodeling of hospitals, clinics, health stations, health centers, staff quarters, and other related facilities, including experience by all disciplines in design, construction methods, and system design for cold, rural, and remote locations. 3. Geographical proximity of design firm and consultant(s) principal office(s) to the project location. 4. Demonstrated expertise and experience in working as a team with listed sub consultants/subcontractors and ability to effectively manage multiple firm teams. 5. Capacity to respond and accomplish the work in the required time. 6. Demonstrated past performance in the last three (3) years on comparable projects with government agencies and private industry in terms of cost control, quality control, and compliance with performance schedules.
 

Place of Performance

Address: Washington, Oregon, Idaho, Montana, Wyoming, Minnesota, Wisconsin, and Michigan

Zip Code: 98121

Country: USA
 

Record

SN00563118-W 20040411/040409211734 (fbodaily.com)
 

Source

FedBizOpps.gov Link to This Notice
(may not be valid after Archive Date)

---

| FSG Index  |  This Issue's Index  |  Today's FBO Daily Index Page |