SOLICITATION NOTICE
93 -- Toteboxes
- Notice Date
- 11/22/2004
- Notice Type
- Solicitation Notice
- NAICS
- 326199
— All Other Plastics Product Manufacturing
- Contracting Office
- Defense Logistics Agency, Logistics Operations, Defense Distribution Center, 2001 Mission Drive DDC CSS-A, Bldg 81, New Cumberland, PA, 17070-5001
- ZIP Code
- 17070-5001
- Solicitation Number
- SP3100-05-R-0003
- Response Due
- 1/7/2005
- Description
- The Defense Distribution Center Susquehanna Site located in New Cumberland, PA has a requirement for 5000 each toteboxes. The totebox covered by this specification is an open top container designed for transporting packages on various types of conveyors whereon they are subject to contact with powered steel rollers and diverters, and impact with totebox stops, other totes, platform trucks, tote carts, and other vehicles within the Eastern Distribution Center (EDC). 5,000 (ea.) totes shall be equipped with identification tabs (barcoded labels, four (4) per tote), which allow the toteboxes to be directed and guided around the conveyor circuits automatically by scanner controls. Tote shall be injection-molded using an existing government-owned single cavity injection mold, which was fabricated to manufacture the existing totes for the EDC. The mold is stored at DDSP in New Cumberland, Pa. It will be the responsibility of the Government to transport the mold to the place of manufacture, and then back to DDSP after the totes have been made. The packing crate for the mold is reusable, and the Gov?t expects this to be used for the return trip. While in the possession of the contractor, liability for any damage to the mold will belong to the contractor. The mold is considered to be in the possession of the contractor from the time it is received from DDSP until it is returned. The mold is valued at approximately $110,000.00. The totebox bottom shall be rigid with a smooth flat surface on the outside. Flatness of the bottom shall vary not more than 1/32 inch in a downward (convex) direction or 1/16 inch in an upward (concave) direction when viewed from the outside. The overall outside dimension of the tote shall not exceed 15-5/8 inches by 27-1/2 inches at the top and 14-3/8 inches by 25-1/8 inches at the bottom with maximum height of 9-3/8 inches and three-inch lip. The overall inside dimension of the tote shall not be less than 14-1/8 inches by 25-7/8 inches at the top. Minimum thickness to be not less than .150 inches. The totebox material shall be ABS-Polymerland ABS1GP. The use of regrind material, generated during manufacture of the tote, is allowable to the extent that it does not reduce the tote performance or decrease the tote quality below that specified. Colorant will be used to color the tote orange, similar to the existing totes. The elctronic request for solicitation package will be available on-line for release to the general public on or about 06 DEC 2004 To receive an award resulting from this solicitation, contractors MUST be registered in the Central Contractor Registration (CCR) database. Registeration is available via the Internet at www.ccr.gov. This solcitation will be posted to FED BIZ OPPS at www.eps.gov.
- Place of Performance
- Address: Defense Distribution Depot Susquehanna, 2001 Mission Drive, Building 2001, New Cumberland, PA, ,
- Zip Code: 17070-5001
- Country: USA
- Zip Code: 17070-5001
- Record
- SN00711511-W 20041124/041122211537 (fbodaily.com)
- Source
-
FedBizOpps.gov Link to This Notice
(may not be valid after Archive Date)
| FSG Index | This Issue's Index | Today's FBO Daily Index Page |