SOURCES SOUGHT
J -- Drydock and Repair of the USCGC Cable Boat (CG-72015)
- Notice Date
- 12/1/2004
- Notice Type
- Sources Sought
- NAICS
- 336611
— Ship Building and Repairing
- Contracting Office
- DHS - Direct Reports, United States Coast Guard (USCG), Commanding Officer (vpl), USCG Maintenance and Logistics Command - Atlantic, 300 East Main Street Suite 600, Norfolk, VA, 23510-9102
- ZIP Code
- 23510-9102
- Solicitation Number
- Cable72015
- Response Due
- 12/13/2004
- Archive Date
- 1/1/2006
- Small Business Set-Aside
- Total HUB-Zone
- Description
- The U.S. Coast Guard is considering whether or not to set aside an acquisition for HUBZone concerns only. The estimated value of this procurement is between $100,000.00 and $500,000.00. The small business size standard is less than 1,000 employees. The acquisition is for drydock repairs to the USCGC Cable Boat (CG-72015), a 72 Foot Cable Boat. All repairs are to be performed at the contractor?s facility. The vessel is geographically restricted to transiting the protected waters of its assigned area of operations; Lake Superior, Lake Michigan, Lake Huron and Lake Erie. The homeport of the USCGC CABLE BOAT is located in Sault Ste. Marie, Michigan. The performance period is forty-five (45) calendar days and is expected to begin on or about May 16, 2005. The scope of the acquisition is for the drydock repairs, which include, overhauling, cleaning, inspecting, and renewing of various items aboard the USCGC CABLE BOAT (CG-72015). This work includes, but is not limited to: Overhaul Ramp Door, Preserve Voids, Preserve Transducer Hull Rings and Renew Transducer, Overhaul MDE Sea Strainers, Seal Hull Plate Penetrations, Renew Frame below Starboard Fuel Tank, Upgrade Lazarette Ventilation, Sandblast, Preserve, and Insulate Lazarette, Insulate Engine Room Overhead, Install Dripless Shaft Seals and Pressure Regulator, Renew Raw Water Cooling Pipe and Renew Mufflers, Remove, Inspect, and Reinstall Propeller Shafts, Remove, Inspect, Repair, and Install Propellers and Rudders, Clean and Inspect Fuel Tanks, Renew Water-Lubricated Shaft Bearings, Clean, Inspect, and Test Grid Coolers, Preserve Underwater Body, Overhaul and Renew Valves, Weight Test Cable Inspection Platform, Align Main Propulsion Engine, Insulate Pilothouse Overhead, Provide Temporary Logistics, and Routine Drydocking. All welding and brazing shall be accomplished by trained welders, who have been certified by the applicable regulatory code performance qualification procedures. At the present time, the acquisition is expected to be issued under full and open competition procedures. However, in accordance with FAR 19.1305, if your firm is HUBZone certified and intends to submit an offer on this acquisition, please respond by e-mail to kstark@mlca.uscg.mil or by fax at (757) 628-4676. Questions may be referred to Ms. Kathryn Stark at (757) 628-4588. In your response please include: (a) a positive statement of your intention to submit an offer for this solicitation as a prime contractor; (b) evidence of experience in work similar in type and scope to include contract numbers, project titles, dollar amounts, points of contact and telephone numbers; (c) past performance references with points of contact and telephone numbers. At least two references are requested, but more are desirable. Your response is required by 13 December 2004. All of the above must be submitted in sufficient detail for a decision to be made on a HUBZone set aside. Failure to submit all information requested may result in an unrestricted acquisition. A decision on whether this will be pursued as a HUBZone small business set aside or on an unrestricted basis will be posted on FEDBIZOPS. Numbered Note 26 applies.
- Place of Performance
- Address: Contractor's facility
- Record
- SN00714944-W 20041203/041201211528 (fbodaily.com)
- Source
-
FedBizOpps.gov Link to This Notice
(may not be valid after Archive Date)
| FSG Index | This Issue's Index | Today's FBO Daily Index Page |