Loren Data's SAM Daily™

FBO DAILY ISSUE OF APRIL 09, 2006 FBO #1595
MODIFICATION

34 -- Vertical Machining Center

Notice Date

4/7/2006
 

Notice Type

Modification
 

NAICS

333512 — Machine Tool (Metal Cutting Types) Manufacturing
 

Contracting Office

Department of Commerce, National Institute of Standards and Technology (NIST), Acquisition Management Division, 100 Bureau Drive, Building 301, Room B129, Mail Stop 1640, Gaithersburg, MD, 20899-1640
 

ZIP Code

20899-1640
 

Solicitation Number

SB1341-06-Q-0301
 

Response Due

4/19/2006
 

Archive Date

5/4/2006
 

Point of Contact

Todd Hill, Contracting Officer, Phone 301-975-8802, Fax null,
 

E-Mail Address

todd.hill@nist.gov
 

Small Business Set-Aside

Total Small Business
 

Description

The purpose of this amendment is to respond to questions from industry regarding clarifications of the requirements as follows: 1) Question -- The solicitation includes a requirement for “1.11 Maximum table weight load capacity 4000 lbs”. Would anything less satisfy the Government’s requirement? Answer -- The Government hereby restates requirement 1.11 as follows: “Maximum table weight load capacity shall be at least 2000 lbs but not more than 4000 lbs. (The maximum of 4000 lbs is dictated by the maximum load limit that NIST has the ability to get to the Vertical Machining Center) 2) Question -- Does the Government prefer “Box Ways” or “Linear Way” construction? Answer -- Either method is acceptable. 3) Question -- What materials does the Government anticipate machining on this equipment? Answer-- For informational purposes only, the Government will primarily machine Aluminum along with some steel and plastics. 4) Question -- The solicitation includes requirements for “1.21 Rapid speed on all axis 500 inches per minute” and “1.22 Maximum cut rate of 650 inches per minute”. Why is the rapid speed less than the max cut speed? Answer: The Government inadvertently reversed these requirements. The Government hereby restates requirements 1.21 and 1.22 as follows: 1.21 Rapid speed on all axis 650 inches per minute 1.22 Maximum cut rate of 500 inches per minute 5) All other terms of this solicitation remain unchanged. NOTE: THIS NOTICE WAS NOT POSTED TO FEDBIZOPPS ON THE DATE INDICATED IN THE NOTICE ITSELF (07-APR-2006); HOWEVER, IT DID APPEAR IN THE FEDBIZOPPS FTP FEED ON THIS DATE. PLEASE CONTACT fbo.support@gsa.gov REGARDING THIS ISSUE.
 

Web Link

Link to FedBizOpps document.
(http://www.fbo.gov/spg/DOC/NIST/AcAsD/SB1341-06-Q-0301/listing.html)
 

Place of Performance

Address: Building 301, Shipping and receiving, Gaithersburg, MD

Zip Code: 20899-0001

Country: USA
 

Record

SN01023965-F 20060409/060407223534 (fbodaily.com)
 

Source

FedBizOpps Link to This Notice
(may not be valid after Archive Date)

---

| FSG Index  |  This Issue's Index  |  Today's FBO Daily Index Page |