Loren Data's SAM Daily™

FBO DAILY ISSUE OF SEPTEMBER 01, 2006 FBO #1740
SOURCES SOUGHT

19 -- USCGC SHRIKE (WPB-87342) DRYDOCK REPAIRS

Notice Date

8/30/2006
 

Notice Type

Sources Sought
 

NAICS

336611 — Ship Building and Repairing
 

Contracting Office

Department of Homeland Security, United States Coast Guard (USCG), Commanding Officer (vpl), USCG Maintenance and Logistics Command - Atlantic, 300 East Main Street Suite 600, Norfolk, VA, 23510-9102
 

ZIP Code

23510-9102
 

Solicitation Number

HSCG80-07-Q-3FA012
 

Response Due

9/11/2006
 

Archive Date

9/10/2007
 

Description

The U.S. Coast Guard is considering whether or not to set aside an acquisition for HUBZone concerns or for Service-Disabled Veteran-owned Small Business concerns. The estimated value of this procurement is between $100,000.00 and $250,000.00. The NAICS Code is 336611. The small business size standard is less than 1,000 employees. The acquisition is for drydock repairs of the USCGC SHRIKE (WPB-87342), an 87 FOOT PATROL BOAT. The homeport of the vessel is Cape Canaveral, FL. The performance period is FORTY TWO (42) calendar days and is expected to begin on or about 8 Jan 2007 and end on or about 18 Feb 2007. The scope of the acquisition is for the overhauling, renewing and repairing of various items aboard the USCGC SHRIKE (WPB-87342). This work will include, but is not limited to: Routine drydocking; Welding repairs; Remove, inspect, and reinstall propeller shafts; Inspect water lubricated shaft bearings; Remove, inspect and reinstall propellers; Preserve Transducer Hull rings; Overhaul and renew valves; Remove, inspect and reinstall rudder assemblies; Preserve RIB wet notch deck and stern door interior surface; Preserve underwater body; Coating system visual inspection; Painting of draft marks; Preserve aluminum mast; Renew cathodic protection system; Inspect transducer fairing; Provide temporary logistics; Remove, inspect and reinstall stern launch door pivot pins, bushings and washers; Inspect hull plating; Preserve forward peak compartment; Renew Stern tube sea water piping; Composite labor rate; Lay days. The place of contract performance for this procurement is the contractor?s facility. All welding and brazing shall be accomplished by trained welders, who have been certified by the applicable regulatory code performance qualification procedures. At the present time, the acquisition is expected to be issued as a small business set aside. However, in accordance with FAR 19.1305 if your firm is HUBZone certified or a Service-Disabled Veteran-owned Small Business and intends to submit an offer on this acquisition, please respond by e-mail to Andres.n.medina@uscg.mil or by fax at (757) 628-4676. Questions may be referred to Mr. Andres Medina at (757) 628-4633. In your response you must include: (a) a positive statement of your intention to submit a bid for this solicitation as a prime contractor; (b) evidence of experience in work similar in type and scope to include contract numbers, project titles, dollar amounts, points of contact and telephone numbers; (c) past performance references with points of contact and telephone numbers. At least two references are requested, but more are desirable. Your response is required by Sept 11, 2006. Contractors are reminded that should this acquisition become a Hubzone set aside, FAR 52.219-3, Notice of Total Hubzone Set-aside, will apply, which requires that at least 50 percent of the cost of personnel for contract performance be spent for employees of the concern. Contractors are reminded that should this acquisition become a Service-Disabled Veteran-owned Small Business Set-Aside, FAR 52.219-27, Notice of Total Service-Disabled Veteran-Owned Small Business Set-Aside, will apply, which requires that at least 50 percent of the cost of personnel for contract performance be spent for employees of the concern. All of the above must be submitted in sufficient detail for a decision to be made on a HUBZone set-aside. Failure to submit all information requested may result in an unrestricted acquisition. A decision on whether this will be pursued as a HUBZone Small Business set-aside or on an unrestricted basis will be posted in FedBizOpps website at http://www.eps.gov.
 

Place of Performance

Address: At the Contractor's Facility.

Zip Code: 32937

Country: UNITED STATES
 

Record

SN01129668-W 20060901/060830220419 (fbodaily.com)
 

Source

FedBizOpps Link to This Notice
(may not be valid after Archive Date)

---

| FSG Index  |  This Issue's Index  |  Today's FBO Daily Index Page |