SRCSGT | 99 | Fabrication of sandstone or Aquai Creek Sandstone in various sizes for the restoration and repair of historic cemetery headstones at Congressional Cemetery, Washington, D.C.

FBO DAILY ISSUE OF FEBRUARY 07, 2007 FBO #1899
SOURCES SOUGHT

99 -- Fabrication of sandstone or Aquai Creek Sandstone in various sizes for the restoration and repair of historic cemetery headstones at Congressional Cemetery, Washington, D.C.

Notice Date: 2/5/2007
Notice Type: Sources Sought
Contracting Office: Historic Preservation Training Center Gambrill House 4801-A Urbana Pike Frederick MD 21704
ZIP Code: 21704
Solicitation Number: N2680070074
Response Due: 2/23/2007
Archive Date: 2/5/2008
Small Business Set-Aside: Total Small Business
Description: This is a sources sought notice and NOT a Request for Proposal. The purpose of this announcement is to determine the potential of qualified Offerors that can provide fabrication of various architectural elements of Historic Cemetery Monuments. The National Park Service, Historic Preservation Training Center has a requirement for the fabrication of three separate elements of a type of sandstone to yet be determined, or salvaged Aquai Creek Sandstone. The Government would furnish the raw material that would consist of stone in dimensional blocks requiring the Offeror to fabricate specific elements as follows: (1) Conical Capstone Fabrication, not more than 70 each , raw material dimension 24" x 24" x 12". Final fabrication shall be in a circular form; (2) Inset Panel Fabrication, no more than 200 each, raw material dimension of Upper Body Stone Sections 30" x 30" x 30" with the following specific requirements: Fabricate four inset panels per cube: One panel per three sides at 18" x 18" square to a smooth finished depth of one inch; One panel per one side at 18" x 18" square to a rough finished depth of two inches. Each panel inset shall be square at all sides, and a true 90 degrees at all intersecting corners with a smooth flat surface finish all sides. All saw or tooling marks shall be removed to smooth honed finish. All stone bedding planes shall run horizontally on four panel sides; (3) Lower Body Stone Water Table Fabrication, raw material dimension of 48" X 48" X 11 ? ". Material shall be tapered on all sides out 9" and down ?". Responses to this announcement shall be sent in writing, no later than 12:00 p.m. on February 23, 2007 to: Sheila Rushlow, Contracting Officer, Historic Preservation Training Center, 4801A Urbana Pike, Frederick, MD 21701 Response shall include: (1) Six photographs of previous cut sandstone which demonstrates the ability to do angle or conical work equal to, or with a greater degree of difficulty to the work identified above; (4) Identify either in-house or subcontractor capability to cut stone; and (4) Identify either in-house or subcontractor capability to provide all handling, packing and freight requirements for shipping to: Congressional Cemetery, Washington, D.C.
Web Link: Please click here to view more details.
(http://ideasec.nbc.gov/j2ee/announcementdetail.jsp?serverId=NP144302&objId=2421755)
Place of Performance: Address: Fabricator's Facility; Zip Code: 21740; Country: United States
Record: SN01226093-W 20070207/070205222917 (fbodaily.com)
Source: FedBizOpps Link to This Notice
(may not be valid after Archive Date)

| FSG Index | This Issue's Index | Today's FBO Daily Index Page |

Loren Data's SAM Daily™

99 -- Fabrication of sandstone or Aquai Creek Sandstone in various sizes for the restoration and repair of historic cemetery headstones at Congressional Cemetery, Washington, D.C.