SOLICITATION NOTICE
61 -- Potting Molds
- Notice Date
- 6/1/2007
- Notice Type
- Solicitation Notice
- Contracting Office
- N00253 610 Dowell Street Keyport, WA
- ZIP Code
- 00000
- Solicitation Number
- N0025307T0208
- Response Due
- 6/15/2007
- Archive Date
- 7/15/2007
- Description
- Naval Undersea Warfare Center Division Keyport is soliciting for Potting Mold Sets per drawings SA7143473, SA7143485 and PESK-6436 which are attached to this solicitation. This requirement is being issued as a combined synopsis/solicitation for commercial Items in accordance with FAR 12.6, as supplemented with additional information included in the attached solicitation. This announcement constitutes the only solicitation. The Defense Priorities and Allocations System (DPAS) applicable assigned rating for this requirement is DO-C9E. The solicitation number for this requirement issued as a request for quotation (RFQ) N00253-07-T-0208 is attached to this announcement. Provisions and clauses in effect through Federal Acquisition Federal Circulars 2005-16 are included in the attached solicitation. The applicable NAICS code for this requirement is 332710 and has a size standard of 500. The government prefers FOB Destination pricing to NUWC Keyport, WA 98345-7610. Requireme nts and evaluation procedures are listed in the attached solicitation, which is required to be completely filled out and returned before the solicitation closes. Questions should be submitted via e-mail to: LasotaDL@kpt.nuwc.navy.mil or faxed to (360) 396-2393. No paper copies will be mailed. Failure to respond to this RFQ and associated amendments if applicable prior to the closing date and time established may render an offer non-responsive and result in rejection. To access the clauses/provisions to be completed, download the Federal Acquisition Regulations at http://www.arnet.gov/far/. Download the Defense Federal Acquisition Regulations (DFARS) at: http://www.acq.osd.mil/dp/dars/dfars.html. Offerors are also advised that these representations and certifications can be completed electronically via the ORCA website at http://orca.bpn.gov. Molds are to meet all drawing requirements. Note: some drawing dimensions have been edited by hand. Appropriate threads & thread depth to be machined for fasteners called out on drawings. All threads to m eet ANSI B1.1. All fasteners to be alloy steel. All dowel pins to be hardened & ground alloy steel. Parts labeled C1010-C1020 to be mild steel. Mating cavity surfaces to be flat within .003?. All cavity features to line up within .005? and mold halves must be able to be split by hand. A minimum wall thickness of .13? to be maintained around cavity for all holes to prevent holes from breaking into cavity. All slip fit dowel pin holes to be LC 3 fit per ANSI B4.1. All press fit dowel pin holes to be FN 1 fit per ANSI B4.1. All mold cavities to have a 32 finish per ASTM B46.1. Use ASME Y14.38M in place of MIL-STD-12. NUWC Keyport reserves the right to perform a pre-award survey to insure vendor is capable of making molds. ADDITIONAL INFORMATION: Vendor is to provide the following information for evaluation: 1. Description of Offerors physical plant and manufacturing processes. 2. Understanding of built to print specifications. 3. Description of previous machine work of similar complexity. Cost and Schedule are to be equally weighted. Technical approval is required. NOTE 1 applies.
- Record
- SN01308731-W 20070603/070604110212 (fbodaily.com)
- Source
-
FedBizOpps Link to This Notice
(may not be valid after Archive Date)
| FSG Index | This Issue's Index | Today's FBO Daily Index Page |