Loren Data's SAM Daily™

FBO DAILY ISSUE OF MAY 02, 2008 FBO #2349
DOCUMENT

62 -- Open Market quotes requested for Electric Hand Lantern Flashlights - Solicitation 1

Notice Date

4/30/2008
 

Notice Type

Solicitation 1
 

NAICS

335122 — Commercial, Industrial, and Institutional Electric Lighting Fixture Manufacturing
 

Contracting Office

General Services Administration, Federal Supply Service (FSS), General Products Center (7FC), 819 Taylor Street, Room 7A37, Fort Worth, Texas, 76102
 

ZIP Code

76102
 

Solicitation Number

0523
 

Point of Contact

Dolores G. LUKACH, Phone: 817 574-2571
 

E-Mail Address

dolores.lukach@gsa.gov
 

Description

SEE attached Request for Quote for all Details; Submit Quote on RFQ document. ITEM PURCHASE DESCRIPTIONS NSN: 6230-00-500-0523 (dtd 04/05/07) LANTERN, ELECTRIC: Electric hand lantern, dry cell operated, single concentrated light beam. Shall be in accordance with the following characteristics: Design. The lantern shall be a complete unit including battery case, light bulb, switch, handle, and reflector assembly. A positive means shall be provided for holding the ANSI/NEDA 908 6-volt lantern battery in the battery case. Switch. The switch shall have an ON and OFF position. The switch shall be capable of electrical operation after 25,000 cycles at a rate of 15  1 cycles per minute from OFF to ON and back to OFF. The switch shall be of a push-button design, wherein the switch is “clicked” between ON and OFF positions. Slide switches shall not be permitted. Impact resistance. The lantern, stabilized at a temperature of 0  2F (-17.8  1.1C), shall be able to withstand an impact of 1 ft-lb (1.36 J) using a 1 lb (0.454 kg) steel ball without sustaining any damage. The impact is applied to the base (side opposite the handle), the end opposite the reflector and the lens ring side. Durability drop. The lantern (battery included), stabilized at a temperature of 75  2F (23.9  1.1C), shall be able to withstand the following testing without sustaining any damage: lantern is dropped from a minimum height of 3 feet (0.915 m) into a box of loose dry sand with a minimum depth of 1 ft (0.305 m). The lantern is dropped three times on the base and three times on the end opposite the reflector. Concentrated beam. The concentrated beam shall have a maximum diameter of 10 inches (0.254 m) at a distance of 60 inches (1.52 m) from the lantern lens. Beam candlepower. The minimum beam candlepower (candelas) of the concentrated beam shall be 5,000 at 5.2 volts under the following conditions: The test distance is 10 feet (3.05 m) between the lantern and the photoreceptor. The photoreceptor is calibrated using the standard lamp with a color temperature of 2856 K. The photoreceptor has a minimum diameter of 1 inch and is equipped with light filter to yield a response curve matching that of the International Commission of Illumination Standard observer. The calculation is as follows: I = E x D2, where I = Luminous intensity of the light beam in candelas. E = Illuminance reading of photometer calculated in foot-candles. D = Distance between the lantern lens and photometer. Measurement system. The values stated in inch-pound units are to be regarded as the standard. The metric values stated in parentheses are for informational purposes only. Testing equipment may be specified in metric units without mention of equivalent inch-pound units. Metric products. Products manufactured to metric dimensions will be considered on an equal basis with those manufactured using inch-pound units, providing they fall within the tolerances specified and all other requirements of this document are met. If a product is manufactured to metric dimensions and those dimensions exceed the tolerances specified in the inch-pound units, a request should be made to the contracting officer to determine if the product is acceptable. Workmanship. The lantern shall be free from any defects, imperfections, or material that would adversely affect performance, serviceability, or appearance, or cause any undesirable effects during use. Unit of issue - EA (Each)
 

Web Link

FedBizOpps Complete View
(https://www.fbo.gov/?s=opportunity&mode=form&id=2d8000edeaa2d9830abebe184d8814d3&tab=core&_cview=1)
 

Document(s)

Solicitation 1
 

File Name: RFQ - 0523 OM (RFQ 6230 - 0523 OM .doc)

Link: https://www.fbo.gov//utils/view?id=912ea8db8d7d675ecf93eca82de6b6ce

Bytes: 291.00 Kb
 

Note: If links are broken, refer to Point of Contact above or contact the FBO Help Desk at 877-472-3779.
 

Record

SN01563560-W 20080502/080430220451-2d8000edeaa2d9830abebe184d8814d3 (fbodaily.com)
 

Source

FedBizOpps Link to This Notice
(may not be valid after Archive Date)

---

| FSG Index  |  This Issue's Index  |  Today's FBO Daily Index Page |