SOLICITATION NOTICE
58 -- Stalker Radar Detector
- Notice Date
- 6/11/2008
- Notice Type
- Combined Synopsis/Solicitation
- NAICS
- 334511
— Search, Detection, Navigation, Guidance, Aeronautical, and Nautical System and Instrument Manufacturing
- Contracting Office
- Department of the Army, Army Contracting Agency, South Region, ACA, Fort Bliss, ACA, Fort Bliss, Directorate of Contracting, Attn: ATZC-DOC, Building 2021, Club Road, Fort Bliss, TX 79916-6812
- ZIP Code
- 79916-6812
- Solicitation Number
- W911SG81081300
- Response Due
- 6/18/2008
- Archive Date
- 8/17/2008
- Point of Contact
- Dorothy Dailey, 915-568-2703
- Small Business Set-Aside
- Total Small Business
- Description
- This is a combined synopsis/solicitation for commercial items prepared in accordance with the format in Subpart 12.6, as supplemented with additional information included in this notice. This announcement constitutes the only solicitation; proposals are being requested and a written solicitation will not be issued. Quotes shall be submitted electronically to Dorothy.Dailey @us.army.mil and are due by Wednesday, 18 June 2008 at 4:00 p.m. MDT. No phone calls will be accepted. The solicitation document and incorporated provisions and clauses are those in effect through Federal Acquisition Circular FAC 2005-24. The associated North American Industrial Classification System (NAICS) code for this procurement is 334511 with a small business standard of 750 employees. This requirement is a Small Business set-aside, and only qualified offerors may submit quotes. All quotes are due by Wednesday, 18 June 2008 at 4:00 p.m. MDT. Please quote the following: CLIN 0001, Brand Name or Equal-Manufacturer: Stalker, Model- DSR 2X Radar; Type: Dual AntennaDirection Sensing Moving/Stationary Doppler Radar; Operating Frequency: 33.4GHz-36.0 GHz (Ka Band); Stability: +/- 100 MHz (Ka Band); Power Requirements with (2) antennas: 10.0 to 16.4 VDC (currents are typical at 12.0 VDC), XMIT on FRONT & REAR, no targets stationary 1.35A, XMIT on FRONT & REAR, no targets moving 1.40A, XMIT on FRONT & REAR, with 25mph targets stationary 1.75A, XMIT on FRONT & REAR, 25 mph patrol with 15 mph targets 1.53A, XMIT on FRONT with 25 mph patrol and XMIT on REAR with no target 1.46A, HOLD on FRONT & HOLD on REAR stationary.78A, HOLD on FRONT & HOLD on REAR moving.82A, XMIT-1 antenna, HOLD-1 anntenna no target stationary 1.05A, XMIT-1 antenna, HOLD-1 anntenna no target moving 1.10A, XMIT-1 antenna, HOLD-1 anntenna 25 mph target stationary; Environmental: -30 degrees C to +70 degrees C-90% relative humidity operating, -40 degrees C to +85 degrees C, non operating; Display: Five multi-color (red, green, amber) 3-digit light emitting diode (LED) windows for target, fast/lock, and patrol, plus red LED modeindicators and LED target direction arows; Mechanical: Display Unit-weight.05 lbs, size-1.65 inches in height-1.05 inches depth, 5.50 inches wide, Counting Unit-weight 1.6 lbs, height- 1.65 inches, 3.35 inches depth, 5.50 inches width, Antenna-1.4 lbs. weight, 2.60 inches x 4.75 inches in dimensions, Remote-0.4 lbs weight, 1 inch height, 6.20 inch length, 2.25 inch width; Accuracy: +1, -2 mph stationary, +/-2 mph moving, +1.6 km/h, -3.2 km/h stationary, +/-3.2 km/h moving; Automatic Self Test: performed every 10 minutes while transmitting; Stationary Speed Range: 12 mph to 200 mph Standard or 2 mph to 200 mph (set up menu selectable), stationary fastest speed-same speed range as stationary speed; Moving Speed Range: Patrol Speed-once acquired, will track to 150 mph. Acquisition speed selectable with PS 5/20 key.5 in patrol window for patrol speed acquisition speed of 5 to 95 mph, 20 in patrol window for patrol speed acquisition speefs of 20 to 95 mph. Opposite Lane Target Speed-200 mph max closing, for 5 mph patrol speed, 20 mph to 195 mph, for 70 mph patrol speed, 15 mph to 130 mph. Opposite Lane Fastest Speed-same speed range as opposite lane speed, Same Lane Target Speed-relates to patrol speed +/- 70% of patrol speed within 5 mph of patrol speed, for 50 mph patrol speed 15-45 mph and 55-85 mph same lane patrol speed must be greater than 15 mph; Microwave Specifications: Antenna-conical horn with corrective lens; Polarization-circular; 3 db Beam Width-12 degrees +/- 1 degree; Microwave Source-gunn-effect diode; Receiver Type-two direct conversion homodyne receivers using four low-noise Schotiky barrier diodes; Power Output-10 mW minimum, 25 mW nominal, and 50 mW maximum; Power Density-2 mW/cm2 maximum at 5 cm from lens; Display Messages: HLd-the HLd message display in one of the middle windows indicates tha the transmitter for that antenna is in hold mode or turned off; V Lo-a V Lo message indicates the input voltage is too low. Operation is inhibited while the V Lo message is displayed but normal operation will resume automatically when the input voltage is restored. All other speed windows will be blanked. RFI-the RFI message indicates the presence of an interfering signal. Operation is inhibited during an RFI indication. All other speed windows will be blanked. PASS-PASS is displayed at the end of a succesful internal test cycle along with a happy tone. FAIL-a FAIL message (along with full tone) indicates that a circuit malfunction has been detected in which case speed readings are inhibited and the unit should be removed from service and repaired. FAIL will remain in the message window until reset by being powered off. HOT-the HOT message is used to indicate that the counting unit I outside of its rated temperature range. After the counting unit cools down, it will automatically begin normal operation. Remote Control Functions: Consists of MOV/STA mode, START/STOP, OPP/FAST LOCK, HOLD/LOCK RELEASE, UP/DOWN, SAME/FAST LOCK, MENU, VOLUME/TEST, PS BLANK, and LIGHT., Delivery of items is within 15 days ARO for 30 units each. The incorporated provisions and clauses are those in effect through Federal Acquisition Circular 2005-24. The following FAR and DFAR clauses and/or provisions apply to this solicitation: 52.211-6, 52.212-4, 52.212-5, 52.219-6, 52.222-3, 52.222-19, 52.222-21, 52.222-26, 52.222-35, 52.22236, 52.222-39, 52.222-50, 52.232-33, 252.232-7003, 252.211-7003.The full text of a clause or provision may be accessed electonically at this address: http:/ /farsite.hill.af.mil. Vendors shall include with their quote a completed copy of FAR proviion 52.212-3, Offeror Representations and Certifications-Commercial Items. Vendors must be registered in the Central Registration (CCR) database to receive this award. FOB Destination is Fort Bliss, TX 79916-6812. Quotes will be evaluated based on price and meeting the equipments specifications. Bid must be good for 30 calendar days after submission.
- Web Link
-
FedBizOpps Complete View
(https://www.fbo.gov/?s=opportunity&mode=form&id=bbcb72ed3d812123552910c4921783d7&tab=core&_cview=1)
- Place of Performance
- Address: ACA, Fort Bliss Directorate of Contracting, Attn: ATZC-DOC, Building 2021, Club Road Fort Bliss TX
- Zip Code: 79916-6812
- Zip Code: 79916-6812
- Record
- SN01591681-W 20080613/080611222638-bbcb72ed3d812123552910c4921783d7 (fbodaily.com)
- Source
-
FedBizOpps Link to This Notice
(may not be valid after Archive Date)
| FSG Index | This Issue's Index | Today's FBO Daily Index Page |