SOURCES SOUGHT
J -- DRYDOCK FOR USCGC DALLAS (WHEC 716) AND USCGC GALLATIN (WHEC 721)
- Notice Date
- 12/5/2008
- Notice Type
- Sources Sought
- NAICS
- 336611
— Ship Building and Repairing
- Contracting Office
- Department of Homeland Security, United States Coast Guard (USCG), Commanding Officer (vpl), USCG Maintenance and Logistics Command - Atlantic, 300 East Main Street, Suite 600, Norfolk, Virginia, 23510-9102
- ZIP Code
- 23510-9102
- Solicitation Number
- DRYDOCK_OF_USCGC_DALLAS_AND_USCGC_GALLATIN
- Point of Contact
- Nancy M Brinkman,, Phone: 757-628-4579, Michael E Monahan,, Phone: 757-628-4639
- E-Mail Address
-
Nancy.M.Brinkman@uscg.mil, michael.e.monahan@uscg.mil
- Small Business Set-Aside
- N/A
- Description
- The United States Coast Guard is considering whether or not to set aside an acquisition for HUBZone concerns, for Service-Disabled Veteran-Owned Small Business Concerns (SDVOSB), or for Small Business Concerns as well as Large Businesses. The acquisition is for DRYDOCK repairs to the USCGC DALLAS (WHEC-716) and USCGC GALLATIN (WHEC-721) 378 FOOT HIGH ENDURANCE CUTTERS. The NAICS Code is 336611. The project for the two 378’ High Endurance Cutters (Dallas & Gallatin) will be issued as one solicitation and the Coast Guard may award one or two contracts as a result of the solicitation. The estimated procurement value is between $5,000,000.00 and $10,000,000.00. Contractors will be allowed to submit quotes for one vessel or both vessels. This project is expected to have a geographic restriction but one has not been received. The geographic restriction is expected to be less then 500 nautical miles of the vessels homeport of Charleston, SC. Since the geographic restriction is not settled, contractors outside the assumed geographic restriction are encouraged to submit a reply. The performance period is expected to be about 4-5 months with a start date of 02 February 2009 or as close to that date as possible. A. The scope of the acquisition for the USCGC DALLAS (WHEC-716), 378 FOOT HIGH ENDURANCE CUTTER is for the overhauling, cleaning and repairing of various items aboard. This work will include, but is not limited to: 1.Preserve Antennas and Antenna Foundation. 2.Replacement/Repairs of Bridge Windows. 3.Renew Deck Covering System In Berthing Area 2-280-3-L. 4.Replacement/Repairs of Bridge Windows. 5.Repair of Deteriorated two horizontal Frames above P/W pumps. 6.Renew Supply Ventilation Ducting 3-190-2. 7.Renewal of Dirt Oil Tank Piping. 8.Rehab Fan Space. 9.Rewind Supply Fan 01-101-2. 10.Clean Heat Exchangers. 11.Renew Insulation In Upper Level Engine Room. 12.Renew Ventilation in Incinerator Space. 13.Renew Ventilation Closures to the Weather Deck. 14.Overhaul Bow Propulsion Unit. 15.Install Incinerator Sludge Tank Level Indicator. 16.Renew Duct heater 01-105-1. 17.Renew Pipe to Fireplug 1-32-2. 18.Renew Chill/Hotwater, Steam, Firemain System Insulation. 19.Renew poured wet decks. 20.Renew all damaged insulation in fan space 1-288-1-Q. 21.Renew damaged vent ducting in fan room 1-288-1-Q. 22.Test and Rewind Supply Fan 1-283-1. 23.Inspect and Overhaul Counter Measure Water Washdown System. 24.Bilge Cleaning, Prep, Prime and Paint, and Structural test of 4-56-0-Q. 25.Prep, Prime and Paint Deck in Compartment 3-96-2-Q. 26.Clean, Preserve, and Inspect Bilge in Compartment 5-96-0-E. 27.Clean, Preserve, and Inspect Bilge in Compartment 4-72-0-Q. 28.Clean, Preserve, and Inspect Bilge in Compartment 3-272-0-E. 29.Clean, Preserve, and Inspect Bilge in Compartment 5-192-0-E. 30.Prep, Prime, and Paint deck in 2-32-3-A. 31.Clean, preserve and inspect bilge forward Sewage. 32.Preserve and Inspect Deck Bulkhead 2-320-0-E. 33.Inspect and Renew Permanent ballast area. 34.Renew foundation to Hot water storage tank 5-254-1. 35.Renew Watertight fitting 3-168-2-Q. 36.Renew Anchor Windlass Pedestals and Surrounding Deck. 37.Renewal of corroded potable water tank foundation. 38.Renew and Prep, Prime and Paint Various Fuel Vents, Brackets, And Pedestals. 39.Renew Various Exterior Vents. 40.Overhaul Portside Single Point Davit. 41.Preserve, Prime and Paint Inside Surface of Aft Potable Water Tanks. 42.Inspect and Clean Fuel Oil Storage Tanks. 43.Renew Pipe Insulation In Various Locations. 44.Renew Lagging And Insulation In Fan Room 2-160-1-Q. 45.Renew sewage piping. 46.Renew Weather Deck Drain Piping. 47.Renew Various Fuel Oil Sounding Tubes. 48.Renew Sewage Piping In Central Supply. 49.Renew Sewage Vacuum Piping In Sickbay. 50.Installation of Check Valve for Auxiliary Fuel Oil Boost Pump. 51.Replace all Salt-water piping on Both Ship Service Diesel Generator's. 52.Overhaul #2 and #3 Fire pump Leslie Valve and Controller. 53.Inspect and Repair #2 Clutch Output Shaft. 54.Renew Lagging on Steam pipes in fan room #2. 55.Replace Ship Service Diesel Generator Salt Water Check Valves. 56.Overhaul Vent Fans and Motor. 57.Clean and Inspect Fuel Tanks. 58.Clean and Inspect dirty oil and waste oil tanks. 59.Renew propulsion shaft seals. 60.General Maintenance of Controllable Pitch Propeller System. 61.General Maintenance of Hubs. 62.Overhaul sea strainers. 63.Hangar Overhaul. 64.Hangar door and track overhaul. 65.Routine Drydocking. 66.Temporary logistics. 67.Preserve Underwater Body 100-percent. 68.Clean & Inspect Grey Water Holding Tanks. 69.Clean & Inspect Sewage Holding Tanks. 70.Inspect and Repair Propulsion Shaft Fairwaters and Rope Guards. 71.Leak Test Underwater Appendages. 72.Inspect Aviation Fuel Service Tanks. 73.Inspect Main Propulsion Fuel Service Tanks. 74.Clean & Inspect Propulsion Mechanical Shaft Seals. 75.Perform UT Side Scan. 76.Remove, inspect and reinstall propulsion shafts. 77.Remove, inspect and reinstall rudders. 78.Renew water lubricated shaft bearings. B. The scope of the acquisition for the USCGC GALLATIN (WHEC-721), 378 FOOT HIGH ENDURANCE CUTTER is for the overhauling, cleaning and repairing of various items aboard. This work will include, but is not limited to: 1.Renew Stern tube. 2.Renew Fantail deck. 3.Renew Transducer rings. 4.Renew deck in 304 fan space. 5.Fuel piping in Diesel Oil Purify Room. 6.Renew aft turbid water tank overboard piping. 7.Renew Emergency Gas Turbine sea strainer. 8.Renew hull plating in Engine Room. 9.Renew hull plating in fuel tank 5-104-0-F. 10.Renew ventilation ducting. 11.Renew watertight fittings. 12.Renew sewage and waste water pipe. 13.Prep, Prime and Paint forward sewage bilge. 14.Prep, Prime and Paint bow prop bilge. 15.Prep, Prime and Paint A/C flat deck. 16.Prep, Prime and Paint aft sewage. 17.Renew Anchor windlass deck. 18.Renew Fwd starboard ventilation ducting. 19.Overhaul Auxiliary Sea Water strainers and sea valves. 20.Renew kickpipes exterior deck O1. 21.Overhaul port fan plenum. 22.Overhaul starboard fan plenum. 23.Overhaul fan room 01-97-2-Q. 24.Overhaul fan room 01-97-1-Q. 25.Overhaul fan room 2-160-1-Q. 26.Renew bridge window frames. 27.Renew Fan ducting. 28.Renew deck in 304 -1. 29.Renew Quick Acting Watertight Door and fan coil replacement. 30.Overhaul Mag sprinkler. 31.Renew Quick Acting Watertight Door in CIWS mag. 32.Renew Ammo passing scuttle. 33.Renew Auxiliary Saltwater piping in Engine Room. 34.Renew Deck in 2-304-3-A. 35.Renew Fantail deck. 36.Renew Dado in messdeck. 37.Renew Dado in galley. 38.Renew bulkhead cracks in CIWS mag. 39.Repair deck hole in 2-280-0-L. 40.Renew Vacuum piping. 41.Renew Commissary stores bilge suction. 42.Renew MK92 Quick Acting Watertight Door. 43.Renew Deck in 3-188-1-A. 44.Renew flight deck tie downs. 45.Renew engine room insulations. 46.Renew plenum insulations. 47.Renew dry stores insulations. 48.Renew hull plating in laundry. 49.Clean ventilation system. 50.Renew flight deck box girder. 51.Repair hole in ready service mag. 52.Repair Bulkhead 168. 53.Prep, Prime and Paint Freeboard. 54.Structural repairs to service tanks. 55.Structural repairs to JP-5 tank. 56.Renew piping. 57.Overhaul Thruster unit. 58.Repair turbine exhaust. 59.Perform UT side scan inspection of U/W body. 60.Clean and Inspect Chain Lockers. 61.Clean and Inspect Fuel Tanks. 62.Clean and Inspect dirty oil and waste oil tanks. 63.Renew propulsion shaft seals. 64.General Maintenance of Controlled Pitch Propeller System. 65.General Maintenance of Hubs. 66.Overhaul sea strainers. 67.Overhaul evaporator. 68.Remove, Inspect, and Install Anchor Chains. 69.Preserve Anchor chains. 70.Overhaul Hangar. 71.Overhaul Hangar door and track. 72.Routine Drydocking. 73.Temporary logistics. 74.Preserve Underwater Body 100-percent. All welding and brazing shall be accomplished by trained welders who have been certified by the applicable regulatory code performance qualification procedures. In accordance with FAR 19.1305, if your firm is HUBZone certified or FAR 19.1404 if you firm is SDVOSB or FAR 19.501 if your firm is a Small Business Concern or a Large Business Concern and intends to submit an offer on this acquisition, please respond by e-mail to Nancy.M.Brinkman@uscg.mil or by fax (757) 628-4676. Questions may be referred to Nancy Brinkman at (757) 628-4579. In response please include the following: (a) a positive statement of your intent to submit a bid for this solicitation as a prime contractor; (b) evidence of experience in work similar in type and scope to include contract numbers, project titles, dollar amounts, points of contact and telephone numbers; (c) past performance references with points of contact and phone numbers. At least two (2) references are requested, but more are desirable. We request all contractors who are interested to submit a response by 12:00 Noon, Eastern Standard Time on Thursday, December 11, 2008. All of the above must be submitted in sufficient detail for a decision to be made on a HUBZone, a Service-Disabled Veteran-owned Small Business set aside, a Small Business Concern or Large Business Concern. A decision on whether this will be pursued as a HUBZone or SDVOSB small business set aside, or a Small Business set aside will be posted on the FedBizOps website at http://www.fedbizopps.gov.
- Web Link
-
FedBizOpps Complete View
(https://www.fbo.gov/?s=opportunity&mode=form&id=f654a20b35048ab6b3047e21e87e3d72&tab=core&_cview=1)
- Place of Performance
- Address: CONTRACTORS FACILITY, United States
- Record
- SN01714796-W 20081207/081205221359-f654a20b35048ab6b3047e21e87e3d72 (fbodaily.com)
- Source
-
FedBizOpps Link to This Notice
(may not be valid after Archive Date)
| FSG Index | This Issue's Index | Today's FBO Daily Index Page |