SOLICITATION NOTICE
78 -- RECOVERY--78--ARRA 1179 Install a concrete boundary and a rubber play surface in two playgrounds at Tuttle Creek Lake near Manhattan, Kansas.
- Notice Date
- 9/3/2009
- Notice Type
- Presolicitation
- NAICS
- 561730
— Landscaping Services
- Contracting Office
- US Army Engineer District, Kansas City, ATTN: CENWK-CT, 700 Federal Building 60l East 12th Street, Kansas City, MO 64106-2896
- ZIP Code
- 64106-2896
- Solicitation Number
- W912DQ09T1030
- Response Due
- 9/21/2009
- Archive Date
- 11/20/2009
- Point of Contact
- Gregory Wurst, 785-539-8511
- E-Mail Address
-
US Army Engineer District, Kansas City
(gregory.j.wurst@usace.army.mil)
- Small Business Set-Aside
- Total Small Business
- Description
- RECOVERY--THIS NOTICE IS PROVIDED FOR INFORMATION PURPOSES ONLY. THIS OPPORTUNITY IS AVAILABLE ONLY TO CONTRACTORS UNDER W912DQ09T1030. The Corps of Engineers is soliciting bids for the placement of rubber playground surface on two playgrounds in the Outlet Park Area, Tuttle Creek Lake, Manhattan, Kansas. The contractor will furnish materials, labor, tools, and equipment necessary to do the job. The materials for the base rock (3 clean), drainage rock (CA5), and rubber playground surface materials will be provided by the Corps of Engineers. The base rock material is stored off site 1.5 miles from job site and will have to be transported to the worksites by the contractor. Other materials are approximately mile from the worksites. The work must be completed by 15 September 2009. The playground locations are shown on the enclosed map. A site visit before bids are submitted is highly recommended, this can be arranged by calling 785-539-8511 X3164. The contractor will be responsible for the removal of the existing wood chips on playground areas down to clean soil and haul wood chips to designated area. There are approximately 43 yds of wood chips. Construct a 1 x 1 concrete boarder around the playground area to the specifications provided by the Corps of Engineers (see attached drawings). Place two #4 bars 4 off center in the concrete border, 6 below surface. Tie all joints and a cross bar every 6 with tie wire. The concrete surface shall have a broom finish and all corners rounded. Haul and place a compacted 6 lift of 3 clean base rock inside the concrete boarder, compacted with a vibrating plate compactor to the specified height. Haul and place a compacted 3 lift of CA5 rock, compacted with a vibrating plate compactor to the specified height. Mix and place a 2 thick layer of 8-14 Mesh Buffing Rubber, mix at a ratio of 200 lbs of 8-14 and 2 gal (22 lbs) of urethane binder. Each sq ft should contain 4.4 lbs of 8-14 buffing rubber and 0.48 lbs of urethane. Stomp compact with 14 x 14 plywood boards (can use Corps), let cure before walking on or adding top layer. Mix and place a 1 thick top layer of 1-3 MM Black TTCR and color material. Mix at a ratio of 200 lbs 1-3 crumb rubber, 5 lbs of color material and 5 gal (44 lbs) urethane binder. Each sq ft should contain 3.8 lbs of 1-3 rubber,.08 lbs of color material, and 1.20 lbs of urethane. Trowel to a slick finish using concrete hand trowels. Let cure before walking on surface.
- Web Link
-
FBO.gov Permalink
(https://www.fbo.gov/spg/USA/COE/DACA41/W912DQ09T1030/listing.html)
- Place of Performance
- Address: US Army Engineer District, Kansas City ATTN: CENWK-CT, 700 Federal Building 60l East 12th Street Kansas City MO
- Zip Code: 64106-2896
- Zip Code: 64106-2896
- Record
- SN01939730-W 20090905/090904001223-450c6054c6a336bc19f5effb97096610 (fbodaily.com)
- Source
-
FedBizOpps Link to This Notice
(may not be valid after Archive Date)
| FSG Index | This Issue's Index | Today's FBO Daily Index Page |