Loren Data's SAM Daily™

FBO DAILY ISSUE OF DECEMBER 11, 2009 FBO #2939
SOLICITATION NOTICE

Y -- RECOVERY--Y--PROJECT NUMBER 38234, Replace Heat and Air Units Barracks Bldg 4703 RECOVERY PROJECT LISTINGS: 38234, 13858, 19803, 38236, 38243, Fort Meade, Maryland

Notice Date

12/9/2009
 

Notice Type

Presolicitation
 

NAICS

236220 — Commercial and Institutional Building Construction
 

Contracting Office

US Army Corps of Engineers, Baltimore, 10 South Howard Street, Baltimore, MD 21203
 

ZIP Code

21203
 

Solicitation Number

W912DR-10-R-0028
 

Response Due

12/30/2009
 

Archive Date

2/28/2010
 

Point of Contact

Donna Leketa, 4109625626
 

E-Mail Address

US Army Corps of Engineers, Baltimore
(donna.leketa@usace.army.mil)
 

Small Business Set-Aside

HUBZone
 

Description

Range of project is between $1,000,000.00 to $5,000,000.00. Period of Performance is 365 days from Notice to Proceed. Issuance on or about December 30, 2009. Questions concerning this project can be emailed to Donna leketa at Donna.Leketa@usace.army.mil. Building 4703, Fort Meade, Maryland: This project will be design-build. Selectively demolish of some existing controls in the mechanical room. Coordinate with Pepco Government Services (PGOV) and Trane on existing and new UMCS connections. Salvage two existing Lochinvar gas-fired boilers in the mechanical room and associated hot water pumps, and deliver this equipment to Ft. Meade DPW. Demolish all exposed heating hot water piping and appurtenances in the mechanical room. Demolish all PTAC units in the sleeping rooms, and their associated supplemental hot water heating coil, and cap the existing heating hot water piping at these units at the floor. Demolish all hot water convectors in the bathrooms and demolish and cap heating hot water piping at the floor. Demolish ceiling tiles and core drill exterior wall in the bathrooms as necessary to facilitate installation of new ceiling exhaust fans. Install new PTACs with electric heating coils in all sleeping rooms, and electric baseboard heating in all bathrooms and stairwells. Install new bathroom exhaust fans. Upgrade building electric service from transformer to building, and add a new panel for all new electric loads. Coordinate with Baltimore Gas and Electric to upgrade electric service to building transformer. Patch, repair, and replace building finishes as necessitated by the scope of this project. Install new moisture resistant ceiling tiles in bathroom. Lead and asbestos are currently assumed to be present in some areas of the building, and limited abatement will be required to facilitate the scope of this project. Building 4704, Fort Meade, Maryland: This project will be design-build. Selectively demolish of some existing controls in the mechanical room. Coordinate with Pepco Government Services (PGOV) and Trane on existing and new UMCS connections. Salvage two existing Lochinvar gas-fired boilers in the mechanical room and associated hot water pumps, and deliver this equipment to Ft. Meade DPW. Demolish all exposed heating hot water piping and appurtenances in the mechanical room. Demolish all PTAC units in the sleeping rooms, and their associated supplemental hot water heating coil, and cap the existing heating hot water piping at these units at the floor. Demolish all hot water convectors in the bathrooms and demolish and cap heating hot water piping at the floor. Demolish ceiling tiles and core drill exterior wall in the bathrooms as necessary to facilitate installation of new ceiling exhaust fans. Install new PTACs with electric heating coils in all sleeping rooms, and electric baseboard heating in all bathrooms and stairwells. Install new bathroom exhaust fans. Upgrade building electric service from transformer to building, and add a new panel for all new electric loads. Coordinate with Baltimore Gas and Electric to upgrade electric service to building transformer. Patch, repair, and replace building finishes as necessitated by the scope of this project. Install new moisture resistant ceiling tiles in bathroom. Lead and asbestos are currently assumed to be present in some areas of the building, and limited abatement will be required to facilitate the scope of this project. Building 4707, Fort Meade, Maryland: This project will be design-build. Selectively demolish of some existing controls in the mechanical room. Coordinate with Pepco Government Services (PGOV) and Trane on existing and new UMCS connections. Salvage two existing Lochinvar gas-fired boilers in the mechanical room and associated hot water pumps, and deliver this equipment to Ft. Meade DPW. Demolish all exposed heating hot water piping and appurtenances in the mechanical room. Demolish all PTAC units in the sleeping rooms, and their associated supplemental hot water heating coil, and cap the existing heating hot water piping at these units at the floor. Demolish all hot water convectors in the bathrooms and demolish and cap heating hot water piping at the floor. Demolish ceiling tiles and core drill exterior wall in the bathrooms as necessary to facilitate installation of new ceiling exhaust fans. Install new PTACs with electric heating coils in all sleeping rooms, and electric baseboard heating in all bathrooms and stairwells. Install new bathroom exhaust fans. Upgrade building electric service from transformer to building, and add a new panel for all new electric loads. Coordinate with Baltimore Gas and Electric to upgrade electric service to building transformer. Patch, repair, and replace building finishes as necessitated by the scope of this project. Install new moisture resistant ceiling tiles in bathroom. Lead and asbestos are currently assumed to be present in some areas of the building, and limited abatement will be required to facilitate the scope of this project. Building 4709, Fort Meade, Maryland: This project will be design-build. Selectively demolish of some existing controls in the mechanical room. Coordinate with Pepco Government Services (PGOV) and Trane on existing and new UMCS connections. Salvage two existing Lochinvar gas-fired boilers in the mechanical room and associated hot water pumps, and deliver this equipment to Ft. Meade DPW. Demolish all exposed heating hot water piping and appurtenances in the mechanical room. Demolish all PTAC units in the sleeping rooms, and their associated supplemental hot water heating coil, and cap the existing heating hot water piping at these units at the floor. Demolish all hot water convectors in the bathrooms and demolish and cap heating hot water piping at the floor. Demolish ceiling tiles and core drill exterior wall in the bathrooms as necessary to facilitate installation of new ceiling exhaust fans. Install new PTACs with electric heating coils in all sleeping rooms, and electric baseboard heating in all bathrooms and stairwells. Install new bathroom exhaust fans. Upgrade building electric service from transformer to building, and add a new panel for all new electric loads. Coordinate with Baltimore Gas and Electric to upgrade electric service to building transformer. Patch, repair, and replace building finishes as necessitated by the scope of this project. Install new moisture resistant ceiling tiles in bathroom. Lead and asbestos are currently assumed to be present in some areas of the building, and limited abatement will be required to facilitate the scope of this project. Building 4415, Fort Meade, Maryland: This project will be design-build. Demolish existing summer/winter switchover controls, valves, and associated appurtenances and piping. Demolish existing two-pipe fan coil units and replace them with four-pipe fan coil units. Provide new heating hot water and chilled water distribution piping as required to facilitate this scope. The existing boiler and chiller are to remain. Remove and replace all piping insulation. Provide a new split system dedicated outdoor-air system to ventilate the entire building. Replace all lay in ceiling tiles in the building. Install new control valves and thermostats on existing hot water convector units. Patch, repair, and replace building finishes as necessitated by the scope of this project. New controls installed under this contract will be Lon. Coordinate with Trane to integrate the building Lon controls into the Trane Bacnet UMCS. Available thru Federal Business Opportunities System https://www.fbo.gov/index. The solicitation will be provided in an electronic format, free of charge, to all authenticated account holders of Federal Business Opportunities (FBO) System (https://www.fbo.gov/index). To familiarize vendors with the newly released FBO system, please download the Vendor Guide found here (http://www.nab.usace.army.mil/EBS/FBO Vendor Guide.pdf). Please note that all Corps of Engineers acquisitions are considered Sensitive, But Unclassified Documents, and require users to have a valid MPIN entered in the FBO system to access package. The media through which the Government chooses to issue this solicitation will be the Internet only. This solicitation will not be issued in paper. No phone of fax requests for copy of solicitation will be accepted.
 

Web Link

FBO.gov Permalink
(https://www.fbo.gov/spg/USA/COE/DACA31/W912DR-10-R-0028/listing.html)
 

Place of Performance

Address: US Army Corps of Engineers, Baltimore 10 South Howard Street, Baltimore MD

Zip Code: 21201
 

Record

SN02020345-W 20091211/091209235144-33f3d3b9841ed3fbd85d0b7ec2bb2a25 (fbodaily.com)
 

Source

FedBizOpps Link to This Notice
(may not be valid after Archive Date)

---

| FSG Index  |  This Issue's Index  |  Today's FBO Daily Index Page |