Loren Data's SAM Daily™

FBO DAILY ISSUE OF APRIL 12, 2012 FBO #3792
SOURCES SOUGHT

D -- Request for Information (RFI) for Elevated Sensor Systems logistics sustainment support.

Notice Date

4/10/2012
 

Notice Type

Sources Sought
 

NAICS

541330 — Engineering Services
 

Contracting Office

ACC-APG - Aberdeen Division B, HQ CECOM CONTRACTING CENTER, 6001 COMBAT DRIVE, ABERDEEN PROVING GROU, MD 21005-1846
 

ZIP Code

21005-1846
 

Solicitation Number

S3R-0520
 

Response Due

4/25/2012
 

Archive Date

6/24/2012
 

Point of Contact

Gregory F. Kaiser Jr., 443-861-4728
 

E-Mail Address

ACC-APG - Aberdeen Division B
(gregory.f.kaiser2.civ@mail.mil)
 

Small Business Set-Aside

N/A
 

Description

Request for Information (RFI) for Elevated Sensor Systems logistics sustainment support Overview: The Army is conducting market research to determine the feasibility of utilizing the S3 program to satisfy the requirement described herein. The Army has current requirements (listed below) under existing strategic service sourcing (S3) task orders that will be combined under one effort for integrated logistics support services to gain efficiencies through economy of efforts. W15P7T-06-D-E402, Task Order 094, Project Manager Night Vision/Reconnaissance, Surveillance, and Target Acquisition Base Expeditionary Target Surveillance System-Combined Operator Support in Iraq W15P7T-06-D-E402, Task Order 112, Project Manager Night Vision/Reconnaissance, Surveillance, and Target Acquisition Base Expeditionary Target Surveillance System-Combined Trainers/Installers Support W15P7T-06-D-E403, Task Order 031, Training and Installation Services for the Ground-Based Operational Surveillance System (G-BOSS) W15P7T-06-D-E403, Task Order 035, Project Manager Night Vision/Reconnaissance, Surveillance, and Target Acquisition Base Expeditionary Target Surveillance System-Combined Operator Support in Iraq W15P7T-06-D-E403, Task Order 037, Command, Control, Communications, Computers, Intelligence Surveillance, Reconnaissance (C4ISR) Regional Support Centers (RSC) Field Support for Elevated Sensors in South West Asia The proposed contract will not include any options for extension of the performance period. The period of performance will be twelve (12) months from contract award. For the purposes of this RFI, the contractor should assume the work being conducted will occur at both CONUS and OCONUS locations, with 90% of the effort focused on OCONUS operations support. The contractor should also assume these efforts will be in support of Elevated Sensor systems throughout Southwest Asia (SWA), predominantly Afghanistan. Description: The Base Expeditionary Targeting Surveillance Systems-Combined (BETSS-C) and Ground Based Operational Surveillance Systems (GBOSS) Family of Systems is a force protection multiplier utilized by the Warfighter throughout SWA to identify threats against the operational force. Elevated Sensor systems provide base security cells with unique 3600, high resolution, day/night surveillance capability for enhanced target recognition and battlefield situational awareness, through a wide variety of network integration systems. Systems to be supported are as follows: Base Expeditionary Target Surveillance System - Combined (BETSS-C) system of systems, which consists of Rapid Aerostat Initial Deployment (RAID) Towers (80 foot and 107 foot), RAID Aerostats, Cerberus, Cerberus Lite Scout, Force Protection Suite (FPS), Standard Ground Station (SGS), Remote Ground Station (RGS), Mid-Range Thermal Imager (MRTI), MSTAR and Rapid Deployment Integrated Surveillance System (RDISS) networked cameras. Ground Based Operational Surveillance Systems (GBOSS) has four configurations and consists of either the 107 foot tower, the 80' tower, GBOSS Lite and Cerberus Lite. Rapid Equipping Force (REF) support consists of the following systems: Blackwolf, Cyclops, ESPY, Nightfinder, Omen, and Osprey. Each system incorporates a wide variety of Line Replaceable Units (LRUs) and components. Future Elevated Sensor systems, support equipment, LRUs and components may be added. Requirements: At a minimum, all contractor employees performing services under this contract must be US citizens and hold at least SECRET security clearance or shall be able to obtain an interim SECRET level clearance prior to their scheduled deployment date. The contractor shall provide contract and task planning, program management, administrative support services, cost control, cost reporting, program reviews, and technical status reporting, as well as quality assurance and data management support. The contractor shall establish and operate financial accounting and reporting mechanisms for allocating different types of funding across multiple sub tasks using specific task codes; track incurred costs, both labor and Other Direct Costs, maintain records of and provide overall charges for all costs associated with the execution of this task order. The contractor will establish a Web-based interface to allow select government personnel to access, view, and download reports from the contractor financial information database. The contractor shall perform required analysis and projections of task, and contract costs; provide reports for each system supported and for each support area, for all expenditures incurred; ensure customer funding by type is accounted for and reported; and participate in and prepare for informal and formal meetings throughout the contract period of performance. The Contractor shall participate in progress reviews and scheduled meetings / conferences and shall assist in providing a wide range of substantive oral and written presentations to various activities and organizations within the Department of Defense. The Contractor shall assist in the development of decision and information papers, plans, SOPs (external / internal), historical archives, and analytical and strategic planning documents as appropriate, on all missions and functions under this task order. The Contractor shall attend and participate, as requested, in meetings and conferences in the continental United States (CONUS) or outside the continental United States (OCONUS). The Contractor may participate in meetings with units, AFSB personnel and CECOM Field Support personnel, held on a daily / weekly basis, at each operating location under this task order. In support of these meetings and conferences, the Contractor may be required prepare various presentation materials. The contractor shall provide all administrative, managerial, logistics and business services necessary to execute full logistics sustainment support for the named Elevated Sensor systems, worldwide. The Contractor's Field Service Representatives (FSRs), system operators, trainers/instructors (T/Is) and other support staff (as example, logisticians and supply specialists) will operate the systems and /or mentor uniformed service system operators, train / instruct uniformed service members on the operation and maintenance of the sensor systems, install / erect the systems (including site location surveys), and maintain and repair the systems. Contractor employees will be hired for the duration of the contract (12 months), with all contractors being deployed to SWA. The contractor will be prepared to provide qualified personnel at contract award to attend training at a government determined training facility, in either or all three, simultaneously, of the disciplines (T/I, FSR, Operator) discussed herein. The government training facilities being utilized by the Government to train BETSS-C systems resides at Redstone Arsenal, AL; Fayetteville, NC; and Ft. Leonard Wood, MO. Training length for each discipline are as follows: T/I-16 weeks; FSR-19 weeks and Operators 4-weeks. Training may be conducted for at any one of the existing training facilities previously listed. The Government STRONGLY encourages the contractor to look for opportunities to leverage similar skills sets held by individuals on task to create or establish multi-skilled / multi-functional Field Service Representatives (FSRs) / Field Service Technicians (FSTs) / Installer-Trainers / Operators who are capable of executing all or multiple functions (install, maintain, operate, train) under this task order. The Government vision is to reduce the footprint of deployed contractors in the battle-space in support of BETSS-C requirements while assuring no degradation of Elevated Sensor systems' support to the Warfighter. The Government is seeking innovative contractor solutions for achieving this vision (with caveat that contractor may not propose to use staff on any other task order in support of this effort). The Contractor shall perform field support services for the BETSS-C and GBOSS Family of Systems, including but not limited to fault diagnosis, screening, repair, overhaul, refurbishment, installation of systems, calibration and alignment for a variety of C4ISR equipment and support equipment associated with those systems set forth in this PWS. The Contractor shall provide support for upgrades to existing weapons systems, installation of Modification Work Orders (MWOs) and minor alterations if required. Maintenance support shall primarily be in the area of electronics, and to a lesser extent mechanical support including generator and environmental control unit (ECU) repair and overhaul, installation of C4ISR and electronic equipment/systems as required. The Contractor shall establish a CONUS location in the Fort Bragg, NC area to receive inoperable BETSS-C systems and components. The Contractor shall repair or replace BETSS-C systems and components and return repaired or replaced systems and components to inventory to support maintenance operations. The Contractor shall procure required materials to affect repair and bring a PMC/NMC system back to FMC status. The Contractor shall create, fill and maintain a stockage list to provide and have readily available the required repair materials to support the repair service and maintain an OR rate of 90% or better. The Contractor shall acquire, receive, store, issue, ship and dispose of spares, repair parts, and supplies for all fielded BETSS-C systems. The Contractor shall identify and supply the required quantities of spare parts inventories to ensure minimal down time (Non-Mission Capable status) resulting from repair activities. The contractor shall process all NSN requisitions through the designated regional / installation / FOB Supply Support Activity (SSA) and manage all Overage Recoverable Listings with the SSA. The contractor shall be responsible for tracking and managing all supported systems and accountable components through use of a Property Book Unit Supply Enhanced (PBUSE) account. The contractor shall maintain and update all required PBUSE accountability records and transactions and shall takes all steps to account for all lost, damaged, or destroyed equipment / accountable components and to resolve accountability issues for same. The contractor shall ensure he has qualified personnel to transport hazardous cargo and waste. The contractor shall maintain the Material Safety Data Sheets (MSDS) library on every hazardous substance procured, stored or used within their area of responsibility and shall reduce excess hazardous waste and protect stocks from damage by weather and poor handling. The contractor shall maintain container labeling and storage labeling throughout its areas of responsibility. The contractor shall be responsible for ordering, shipping, storage, and installation of spare and repair parts associated with the Elevated Sensor systems. RFI Administrative Information: This is a Request for Information (RFI) only. Do not submit a proposal or quote. After reviewing the above overview and requirements, interested capable contractors are invited to provide responses to the following questions. Responses should follow this format and be submitted electronically as one complete document. This RFI is for informational purposes only and is not to be construed as a commitment by the Government to procure any items/services, or for the Government to pay for the information received. 1. Please provide the following Point of Contact information: Company: Address: Point of Contact: Phone Number: Fax Numbers: Email Address: 2. Please identify your company's small business size standard based on the applicable NAICS code of 541330 -- Professional, Scientific, and Technical Services/ -- Engineering Services. The Small Business Size Standard for this NAICS code is 541330 $4,500,000.00. For more information refer to http://www.sba.gov/content/table-small-business-size-standards. Large Business Concern Small Business Concern 8(a) Small Disadvantaged Business (SDB) Woman-Owned Small Business Historically Underutilized Business Zone (HUBZone) Veteran-Owned Small Business Service-Disabled Veteran-Owned Small Business 3. If you identify your company as a Small Business or any of the SB subcategories as stipulated in Question # 2, then is your company interested in a prime contract for the Elevated Sensors System Support? 4. Under the current SB recertification regulations, do you anticipate your company remaining a small business, under NAICS Code 541330 -- Professional, Scientific, and Technical Services -- Engineering Services? If you are a SB answer questions 4A.through 4C. All others skip to Question #5. A.If your company is awarded the contract, will you be able to perform at least 50% (percent) of the work required in house? B.If you are a small business can you go without a payment for 90 days? 5. Does your company have experience as a prime contractor administering Multiple Award Contracts (MACs)? 6. If you answered "yes" to Question # 5, please provide as much of the following information as possible; A. MAC contract number(s); B. aggregate dollar value of entire MAC contract; C. aggregate dollar value of task orders you prime on each MAC; D. number of task orders you prime on MAC; E. Is the work on each MAC similar in scope to that of the Draft PWS/SOW? 7. Does your company possess the capabilities to independently provide the entire range of hardware or services called for in the PWS? ______ YES _______ NO 8. If you answered YES to Question # 7, what hardware and/or services called for in the PWS/SOW can your company provide? Please provide specific examples. 9. If you answered NO to Question # 7, what hardware and/or services called for in the PWS/SOW can your company provide? Please provide specific examples. 10. Can you acquire enough space to perform this task prior to contract award or within 15 calendar days after contract award? 11. Please provide details regarding proposed joint ventures, teaming arrangements, strategic alliances, or other business arrangements to satisfy requirements of the entire PWS/SOW. Offerors are encouraged to identify teams, indicating each team member's size status based upon the North American Industrial Classification System (NAICS) code of the work that the team member may be doing. 12. Is your company currently providing similar services to another government agency (you may also include contract #s for government) or other non-government customer? If so, please identify the agency or non-government customer. If you are unwilling to share your customer's identity, please address whether your company offers the same or similar services commercially 13. Interested companies may also provide a "White Paper" (no more than 10 pages in length) describing how its products and technical expertise could produce and deliver such a capabilities as described in the DRAFT PWS/SOW. Also, identify your company's past and current customers to which you provided similar products, including a customer/company name and point of contact, phone number and address/e-mail where they can be contacted. 14. What are the core competencies of your employees that support your current Elevated Sensor systems? Also, provide the total number of individuals currently employed by your company that support your satellite systems program. 15. Describe any experience operating in hostile, contingency or combat environment, in support of military operations worldwide. 16. Does your company needs to have a TOP SECRET facility or access to one should it be required? 17. If you are planning on teaming with other companies, Please list the process used in selecting the members? 18. Does your company have a DCAA approved accounting system? 19. Please provide positive or negative feedback regarding the DRAFT PWS/SOW such as recommended changes, noted exceptions, ambiguities, etc. ***All information should be provided via electronic mail to the Contracting Officer, Mohammad B. Qaddoumi, email: mohammad.b.qaddoumi.civ@mail.mil, and the Contracting Specialist, Gregory F. Kaiser Jr., email: gregory.f.kaiser2.civ@mail.mil at no later than close of business, 24 April 2012.
 

Web Link

FBO.gov Permalink
(https://www.fbo.gov/notices/b687f5cfd4e00fdf81aabf115e1d70a1)
 

Place of Performance

Address: ACC-APG - Aberdeen Division B HQ CECOM CONTRACTING CENTER, 6001 COMBAT DRIVE ABERDEEN PROVING GROU MD

Zip Code: 21005-1846
 

Record

SN02717906-W 20120412/120410234729-b687f5cfd4e00fdf81aabf115e1d70a1 (fbodaily.com)
 

Source

FedBizOpps Link to This Notice
(may not be valid after Archive Date)

---

| FSG Index  |  This Issue's Index  |  Today's FBO Daily Index Page |