MODIFICATION
60 -- Interferometer Electronics and Laser
- Notice Date
- 6/24/2014
- Notice Type
- Modification/Amendment
- Contracting Office
- 100 Bureau Drive, Gaithersburg, MD 20878
- ZIP Code
- 20878
- Solicitation Number
- NB684070-14-03512
- Response Due
- 6/30/2014
- Archive Date
- 12/27/2014
- Point of Contact
- Name: Client Services, Title: Client Services, Phone: 1.877.933.3243, Fax: 703.422.7822
- E-Mail Address
-
Clientservices@fedbid.com;
- Small Business Set-Aside
- N/A
- Description
- AMENDMENT NOTICE:This is a combined synopsis/solicitation for commercial items prepared in accordance with the format in FAR Subpart 12.6, as supplemented with additional information included in this notice.The solicitation number is NB684070-14-03512 and is issued as an invitation for bids (IFB), unless otherwise indicated herein.The solicitation document and incorporated provisions and clauses are those in effect through Federal Acquisition Circular FAC 2005-74. The associated North American Industrial Classification System (NAICS) code for this procurement is 334413 with a small business size standard of 0.00 employees.This requirement is unrestricted and only qualified offerors may submit bids.The solicitation pricing on www.FedBid.com will start on the date this solicitation is posted and will end on 2014-06-30 14:00:00.0 Eastern Time or as otherwise displayed at www.FedBid.com.FOB Destination shall be GAITHERSBURG, MD 20899 The DOC National Institute of Standards and Technology requires the following items, Meet or Exceed, to the following: LI 001: Interferometer Electronics and Laser 1. Short Title: Interferometer electronics and laser 2. Purpose The mass and force group requires interferometer electronics and a compatible laser in order to measure forces from photon momentum exchange. The new hardware must be VME compatible, and include direct access to the P2 bus via 68-pin SCSI-type cable. Specifications: ? System must include a high-accuracy phase meter board for doing heterodyne interferometry for measurement of displacement and velocity. ? System must support 0.15 nm position resolution with at least 37 bit digital readout. ? System must support cyclic error compensation for polarization mixing errors. ? System must have at least 4 position measurement axis channels. ? System must have separate laser so that interferometer optics can be placed inside vacuum chamber. ? Central control capable of running a PID control algorithm digitally at 20 kHz ? Data age 3 microseconds or less, and time resolution of less than 30 nanoseconds. ? System laser frequency stability of less than 3 ppb over 1 hour. ? System laser must be CW with two frequencies orthogonally polarized. ? System laser must have wavelength accuracy of < 2 ppm. ? System laser must be air cooled. ? System must be directly compliant with VMEbus hardware and software communications protocol. ? System must include electronics to directly interface to digital information on P2 bus using 68-pin SCSI type cable., 1, EA; Solicitation and Buy Attachments ***Question Submission: Interested offerors must submit any questions concerning the solicitation at the earliest time possible to enable the Buyer to respond. Questions must be submitted by using the 'Submit a Question' feature at www.fedbid.com. Questions not received within a reasonable time prior to close of the solicitation may not be considered.*** For this solicitation, DOC National Institute of Standards and Technology intends to conduct an online competitive reverse auction to be facilitated by the third-party reverse auction provider, FedBid, Inc. FedBid has developed an online, anonymous, browser based application to conduct the reverse auction. An Offeror may submit a series of pricing bids, which descend in price during the specified period of time for the aforementioned reverse auction. DOC National Institute of Standards and Technology is taking this action in an effort to improve both vendor access and awareness of requests and the agency's ability to gather multiple, competed, real-time bids.All responsible Offerors that respond to this solicitation MUST submit the pricing portion of their bid using the online exchange located at www.FedBid.com. There is no cost to register, review procurement data or make a bid on www.FedBid.com.Offerors that are not currently registered to use www.FedBid.com should proceed to www.FedBid.com to complete their free registration. Offerors that require special considerations or assistance may contact the FedBid Helpdesk at 877-9FEDBID (877-933-3243) or via email at clientservices@fedbid.com. Offerors may not artificially manipulate the price of a transaction on www.FedBid.com by any means. It is unacceptable to place bad faith bids, to use decoys in the www.FedBid.com process or to collude with the intent or effect of hampering the competitive www.FedBid.com process.Should offerors require additional clarification, notify the point of contact or FedBid at 877-9FEDBID (877-933-3243) or clientservices@fedbid.com.Use of FedBid: Buyers and Sellers agree to conduct this transaction through FedBid in compliance with the FedBid Terms of Use. Failure to comply with the below terms and conditions may result in offer being determined as non-responsive. Contracting Officer's Authority. The Contracting Officer is the only person authorized to make or approve any changes in any of the requirements of this contract, and, notwithstanding any provisions contained elsewhere in this contract, the said authority remains solely in the Contracting Officer. In the event the contractor makes any changes at the direction of any person other than the Contracting Officer, the change will be considered to have been made without authority and no adjustment will be made in the contract terms and conditions, including price. Contracting Officer's Representative (COR) (APR 2010) (a) ___________ is hereby designated as the Contracting Officer's Representative (COR). The COR may be changed at any time by the Government without prior notice to the contractor by a unilateral modification to the contract. The COR is located at: ____________________ ____________________ ____________________ Phone Number:____________________ E-mail:____________________ (b) The responsibilities and limitations of the COR are as follows: (1) The COR is responsible for the technical aspects of the contract and serves as technical liaison with the contractor. The COR is also responsible for the final inspection and acceptance of all deliverables and such other responsibilities as may be specified in the contract. (2) The COR is not authorized to make any commitments or otherwise obligate the Government or authorize any changes which affect the contract price, terms or conditions. Any contractor request for changes shall be referred to the Contracting Officer directly or through the COR. No such changes shall be made without the express written prior authorization of the Contracting Officer. The Contracting Officer may designate assistant or alternate COR(s) to act for the COR by naming such assistant/alternate(s) in writing and transmitting a copy of such designation to the contractor. Insert the clause 1352.209?73, Compliance with the Laws, in all solicitations and contracts. As prescribed in 48 CFR 1309.507?2(c), insert the following clause: Compliance With the Laws (APR 2010) The contractor shall comply with all applicable laws, rules and regulations which deal with or relate to performance in accord with the terms of the contract. As prescribed in 48 CFR 1309.507?2(d), insert the following clause: Organizational Conflict of Interest (APR 2010) (a) Purpose. The purpose of this clause is to ensure that the contractor and its subcontractors: (1) Are not biased because of their financial, contractual, organizational, or other interests which relate to the work under this contract, and (2) Do not obtain any unfair competitive advantage over other parties by virtue of their performance of this contract. (b) Scope. The restrictions described herein shall apply to performance or participation by the contractor, its parents, affiliates, divisions and subsidiaries, and successors in interest (hereinafter collectively referred to as ?contractor?) in the activities covered by this clause as a prime contractor, subcontractor, co-sponsor, joint venturer, consultant, or in any similar capacity. For the purpose of this clause, affiliation occurs when a business concern is controlled by or has the power to control another or when a third party has the power to control both. (c) Warrant and Disclosure. The warrant and disclosure requirements of this paragraph apply with full force to both the contractor and all subcontractors. The contractor warrants that, to the best of the contractor's knowledge and belief, there are no relevant facts or circumstances which would give rise to an organizational conflict of interest, as defined in FAR Subpart 9.5, and that the contractor has disclosed all relevant information regarding any actual or potential conflict. The contractor agrees it shall make an immediate and full disclosure, in writing, to the Contracting Officer of any potential or actual organizational conflict of interest or the existence of any facts that may cause a reasonably prudent person to question the contractor's impartiality because of the appearance or existence of bias or an unfair competitive advantage. Such disclosure shall include a description of the actions the contractor has taken or proposes to take in order to avoid, neutralize, or mitigate any resulting conflict of interest. (d) Remedies. The Contracting Officer may terminate this contract for convenience, in whole or in part, if the Contracting Officer deems such termination necessary to avoid, neutralize or mitigate an actual or apparent organizational conflict of interest. If the contractor fails to disclose facts pertaining to the existence of a potential or actual organizational conflict of interest or misrepresents relevant information to the Contracting Officer, the Government may terminate the contract for default, suspend or debar the contractor from Government contracting, or pursue such other remedies as may be permitted by law or this contract. (e) Subcontracts. The contractor shall include a clause substantially similar to this clause, including paragraphs (f) and (g), in any subcontract or consultant agreement at any tier expected to exceed the simplified acquisition threshold. The terms ?contract,? ?contractor,? and ?Contracting Officer? shall be appropriately modified to preserve the Government's rights. (f) Prime Contractor Responsibilities. The contractor shall obtain from its subcontractors or consultants the disclosure required in FAR Part 9.507?1, and shall determine in writing whether the interests disclosed present an actual, or significant potential for, an organizational conflict of interest. The contractor shall identify and avoid, neutralize, or mitigate any subcontractor organizational conflict prior to award of the contract to the satisfaction of the Contracting Officer. If the subcontractor's organizational conflict cannot be avoided, neutralized, or mitigated, the contractor must obtain the written approval of the Contracting Officer prior to entering into the subcontract. If the contractor becomes aware of a subcontractor's potential or actual organizational conflict of interest after contract award, the contractor agrees that the Contractor may be required to eliminate the subcontractor from its team, at the contractor's own risk. (g) Waiver. The parties recognize that this clause has potential effects which will survive the performance of this contract and that it is impossible to foresee each circumstance to which it might be applied in the future. Accordingly, the contractor may at any time seek a waiver from the Head of the Contracting Activity by submitting such waiver request to the Contracting Officer, including a full written description of the requested waiver and the reasons in support thereof. As prescribed in 48 CFR 1313.106?2?70, insert the following provision: Evaluation Utilizing Simplified Acquisition Procedures (Date) All solicitations using simplified acquisition procedures in FAR Part 13 must include provision 1352.213?70, Evaluation Utilizing Simplified Acquisition Procedures, or similar language setting out evaluation criteria.The Government will issue an order resulting from this request for quotation to the responsible offeror whose quotation results in the best value to the Government, considering both price and non-price factors. Insert provision 1352.213?71, Instructions for Submitting Quotations under the Simplified Acquisition Threshold?Non-Commercial, or similar language in all solicitations for non-commercial purchase orders under the simplified acquisition threshold. The contracting officer shall indicate whether electronic submissions of quotations will be accepted. Paragraph (b)(4) of provision 1352.213?71 may be tailored based on the evaluation factors. As prescribed in 48 CFR 1313.302?1?70, insert the following provision: Instructions for Submitting Quotations Under the Simplified Acquisition Threshold?Non-Commercial (Date) (a) North American Industry Classification System (NAICS) code and small business size standard. The NAICS code and small business size standard for this acquisition is ____. (b) Submission of quotations. Submit quotations to the office specified in this solicitation at or before the exact time specified in this solicitation. At a minimum, quotations must show? (1) The solicitation number; (2) The name, address, and telephone number of the offeror; (3) Acknowledgment of solicitation amendments; (4) A technical description showing that the offeror can supply the requirements in the specifications or statement of work in sufficient detail to allow the Government to evaluate the quotation in accordance with the evaluation factors stated in the solicitation. (5) Past performance information, when included as an evaluation factor, to include recent and relevant contracts for the same or similar items and reference information (including contract numbers, points of contact with telephone numbers and other relevant information). (6) Price and any supporting details for the price, as requested in the solicitation. (c) Offerors are responsible for submitting quotations, and any modifications thereto, so as to reach the Government office designated in the solicitation by the time specified. The offeror's initial quotation should contain the offeror's best terms from a price and technical standpoint. The Government may reject any or all quotations if such action is in the public interest; accept other than the lowest quotation; and waive informalities and minor irregularities in quotations received. Insert a clause substantially similar to 1352.246?70, Place of Acceptance, in contracts and solicitations to indicate where the acceptance of supplies and/or services will take place. As prescribed in 1346.503, insert the following clause: Place of Acceptance (APR 2010) (a) The Contracting Officer or the duly authorized representative will accept supplies and services to be provided under this contract. (b) The place of acceptance will be:
- Web Link
-
FBO.gov Permalink
(https://www.fbo.gov/spg/DOC/NIST/AcAsD/NB684070-14-03512/listing.html)
- Place of Performance
- Address: GAITHERSBURG, MD 20899
- Zip Code: 20899-0001
- Zip Code: 20899-0001
- Record
- SN03405057-W 20140626/140625022510-7be791b9eb11c3d5246b9db8ccb3b365 (fbodaily.com)
- Source
-
FedBizOpps Link to This Notice
(may not be valid after Archive Date)
| FSG Index | This Issue's Index | Today's FBO Daily Index Page |