SOURCES SOUGHT
66 -- X-ray Laser Enhanced Altosecond Pulse Generation (xLEAP) for LCLS
- Notice Date
- 6/8/2016
- Notice Type
- Sources Sought
- NAICS
- 423450
— Medical, Dental, and Hospital Equipment and Supplies Merchant Wholesalers
- Contracting Office
- Department of Energy, SLAC National Accelerator Lab, SLAC National Accelerator Lab, 2575 Sand Hill Road, Menlo Park, California, 94303, United States
- ZIP Code
- 94303
- Solicitation Number
- SLAC_26662(LL)
- Archive Date
- 6/23/2016
- Point of Contact
- Lorenza S. Ladao,
- E-Mail Address
-
lladao@SLAC.stanford.edu
(lladao@SLAC.stanford.edu)
- Small Business Set-Aside
- N/A
- Description
- SLAC seeks vendors that can provide the following: One (1) Each of X-ray Laser Enhanced Altosecond Pulse Generation (xLEAP)for the LCLS. The seed laser for the xLEAP amplifier should use a Master Oscillator Power Amplifier (MOPA) architecture based on a SESAM mode locked femtosecond ring Erbium-fiber oscillator, octave spanning continuum generation in a Highly Non Linear Fiber (HNLF), spectral filtering (to reach appropriate spectral bandwidth and central wavelength) and amplification in Tm:Ho:fiber amplifier modules (to reach appropriate output energy). The design of the Er-fiber oscillator should allow rep rate stabilization (via cavity length control) for synchronization to the SLAC RF main frequency. Access to the narrow band spectral filter to tune the central wavelength or possibly change the spectral bandwidth of the seed source, is desirable. Laser Oscillator Specifications Parameter Value Oscillator output central wavelength 2052 nm Average minimum output power >100 mW Pulse width ~2 ps1) Pulse repetition rate 68 MHz Linear Polarization >95% Output coupling Collimated free-space Amplitude noise <0.5% rms ~ Synchronization The oscillator will be synchronized to the SLAC RF by SLAC Requires feature: Built-in piezo electric transducer (PZT) and internal photodiodes. In addition to PZT an option for coarse cavity length (repetition rate) adjustment shall be implemented. Control of PZT and slow cavity length control are required.3) Piezo response bandwidth >10 KHz Residual timing jitter relative to reference (RMS) 4) <200 fs 10Hz-10MhZ THIS IS NOT A REQUEST FOR QUOTE. VENDORS INTERESTED IN BEING CONSIDERED AS A POTENTIAL SOURCE SHOULD IDENTIFY THEMSELVES AS AN "INTERESTED PARTY" VIA THE FBO PORTAL. DO NOT CONTACT THE SUBCONTRACT ADMINISTRATOR.
- Web Link
-
FBO.gov Permalink
(https://www.fbo.gov/spg/DOE/SLAC/STAN/SLAC_26662(LL)/listing.html)
- Place of Performance
- Address: SLAC National Accelerator Laboratory, 2575 Sand Hill Road, Menlo Park, California, 94025, United States
- Zip Code: 94025
- Zip Code: 94025
- Record
- SN04142171-W 20160610/160608234013-d4de4214a78aaf8d24d819e783959c53 (fbodaily.com)
- Source
-
FedBizOpps Link to This Notice
(may not be valid after Archive Date)
| FSG Index | This Issue's Index | Today's FBO Daily Index Page |