MODIFICATION
59 -- F-22 Cable Assemblies
- Notice Date
- 4/25/2018
- Notice Type
- Modification/Amendment
- NAICS
- 335931
— Current-Carrying Wiring Device Manufacturing
- Contracting Office
- Department of the Air Force, Air Force Materiel Command, AFLCMC / AFSC / AFNWC - HILL AFB, ., Hill AFB, Utah, 84056, United States
- ZIP Code
- 84056
- Solicitation Number
- FA8224-18-R-8058
- Archive Date
- 6/9/2018
- Point of Contact
- Shelly Bachison, Phone: 941115865091
- E-Mail Address
-
shelly.bachison@us.af.mil
(shelly.bachison@us.af.mil)
- Small Business Set-Aside
- Total Small Business
- Description
- Q: Do the cable jackets from the Icore drawings have the same requirements as the adapater cables. A: Yes, the cable jackets for these cables have the same cable jacket requirements as the cable adapters. Q: The drawing Schematic doesn't indicate an overall shield braid, like the 32 adapter drawings...is that correct? A: Yes, that is correct. The drawing shows shielded twisted pair wire. (we only require one shield, either shielded twisted pair or an overall shield) If they don't use twisted pair wire, they will have to provide a shield over the wiring to pin 21 and backshell (refer to drawings for pin 21 and backshell, the cables over 12 inches are not connected to backshell on the other side). CONCERN: The y-transition adapters on page 9 of the SOW depicts a dimension of less than 3" from the center on the y boot transition to the face of the P1 connector. If you utilized conduit with internal strain relief (also needed for shield termination) fitting, a connector coupler, the P1 connector, there's no way to hold a 3" or less dimension...The y-transition along would be a minimum of 1.5". Engineer advised: this can be done and has been done by other manufacturers. This is very important due to flexibility requirement. With a short cable and boot over 3 inches it does not pass the flexibility requirement. Q: What is the source of supply/ Cage Code for part numbers P100005-0001, 153244-04166-01, P140449, 103374-350013, P100000-0003, 1033374-350025, 103374-350013? A: The SOW and answered questions posted on FBO.gov for this requirement state that brand name or equal substitute parts are permissible when manufacturing these cables subject to approval at technical evaluation. Tyco electronics is one of the possible suppliers of these alternative parts. The part numbers listed are Icore's, however as I previously stated substitutions are permissible.
- Web Link
-
FBO.gov Permalink
(https://www.fbo.gov/spg/USAF/AFMC/OOALC/FA8224-18-R-8058/listing.html)
- Place of Performance
- Address: F2DCCF -309 SMXG/OBA, Attn: Thomas King, 7278 4th St BLDG 100 Rm 108, HIll Air Force Base, Utah, 84056, United States
- Zip Code: 84056
- Zip Code: 84056
- Record
- SN04900690-W 20180427/180425230833-064bd789ce9372f6ed6b02215ba14090 (fbodaily.com)
- Source
-
FedBizOpps Link to This Notice
(may not be valid after Archive Date)
| FSG Index | This Issue's Index | Today's FBO Daily Index Page |