SOLICITATION NOTICE
31 -- COPPER BEARINGS - RENEWAL PORT&STARBOARD
- Notice Date
- 4/12/2019
- Notice Type
- Combine Synopsis/Solicitation
- NAICS
- 336611
— Ship Building and Repairing
- Contracting Office
- 300 East Main Street Suite 600 Norfolk VA 23510-9102
- ZIP Code
- 23510-9102
- Solicitation Number
- 70Z08019QP4554600
- Response Due
- 4/23/2019
- Point of Contact
- JESUS C. YUTIG, STOREKEEPER, Phone 4107626957
- E-Mail Address
-
JESUS.C.YUTIG@USCG.MIL
- Small Business Set-Aside
- Total Small Business
- Description
- The USCG Surface Forces Logistics Center, has a requirement to Open, Inspect, Report, and Install the following IAW the attached Scope of Work: Renew both Port and Starboard Cooper Bearings IAW attached work specification. Please see attached specifications to ensure proper inspect, report, and install of government furnished equipment. Period of Performance: July 22, 2019 - August 5, 2019. Place of Performance: CGC Mohawk, Miami, FL 3. REQUIREMENTS 3.1 General. 3.1.1 CIR. The Contractor shall submit a CIR for the inspections listed in the following paragraph(s): • 3.2.2 (Inspections). 3.1.2 Tech Rep. Not applicable. 3.1.3 Protective measures - general. The Contractor shall furnish and install all protective coverings to seal off and protect all non-affected vessel's components, equipment, and spaces in the vicinity of the work area against contamination during the performance of work. Upon completion of work, the Contractor shall remove all installed protective measures, inspect for the presence of contamination, and return all contaminated equipment, components, and spaces to original condition of cleanliness. 3.1.4 Interferences. The Contractor shall handle all interferences in accordance with SFLC Std Spec 0000, paragraph 3.3.5 (Interferences). Known interferences include, but are not limited to the below-listed: • Dry store cages. • Deck plates. 3.1.5 Shaft support measures. The Contractor shall provide adequate temporary supports to the intermediate and propeller tail shafts located at forward and aft of the pedestal bearing. 3.2 Pedestal bearing renewals particulars. The Contractor shall accomplish the following using Coast Guard Drawings 905 WMEC 243-001 and 244-001, and TP 2816 as guidance: 3.2.1 Pedestal bearing disassembly. Disassemble the pedestal bearing and remove the upper and lower half inner races, two half clamping rings, cage joint "U" clips, half cage with rollers, half outer races, half seals, top and bottom half cartridges. 3.2.2 Inspection. Visually inspect the thrust shaft journal surface and all bearing components for signs of misalignment, wear, damage or deterioration. Submit a CIR. 3.2.3 Re-assembly and reinstallation. 3.2.3.1 Reassemble the pedestal bearing with the provided Government-furnished components. 3.2.3.2 Furnish and renew all seals, O-rings and gaskets. 3.2.3.3 Reinstall and lubricate the roller bearing as specified in TP-2816, Section 244, Bearing Lubrication. 3.2.4 Alignment check. Check the bearing reactions and properly align the intermediate shaft during bearing reinstallation using Coast Guard Drawing 905 WMEC 243-005 as guidance. 3.3 Government's right for changing out additional components. The Contractor shall be aware that the Government reserves the right to furnish new additional bearing components such as cartridges for installation in place of the existing one. If the Government exercises this right, the Contractor shall turn over the removed components to the Coast Guard PA as an MTI item. 3.4 Operational test - post repairs. After completion of work, the Contractor shall thoroughly test, in the presence of the Coast Guard Inspector and demonstrate all items or shipboard devices that have been disturbed, used, repaired, altered, or installed to be in satisfactory operating condition. Submit a CFR. Submit quotes to Jesus.C.Yutig@uscg.mil and include the following information: NOTE: THIS NOTICE WAS NOT POSTED TO FEDBIZOPPS ON THE DATE INDICATED IN THE NOTICE ITSELF (12-APR-2019); HOWEVER, IT DID APPEAR IN THE FEDBIZOPPS FTP FEED ON THIS DATE. PLEASE CONTACT 877-472-3779 or fbo.support@gsa.gov REGARDING THIS ISSUE.
- Web Link
-
Link To Document
(https://www.fbo.gov/spg/DHS/USCG/COUSCGMLCA/70Z08019QP4554600/listing.html)
- Place of Performance
- Address: Place of Performance is: CGC MOHAWK 100 Trumbo Point Rd. Key West, FL 33040-0005 US C/O USCG Sector Key West, FL
- Country: US
- Country: US
- Record
- SN05280385-F 20190414/190412230038 (fbodaily.com)
- Source
-
FedBizOpps Link to This Notice
(may not be valid after Archive Date)
| FSG Index | This Issue's Index | Today's FBO Daily Index Page |