SAMDaily.us | SRCSGT | 67 | High Speed Camera

SAMDAILY.US - ISSUE OF OCTOBER 21, 2021 SAM #7264
SOURCES SOUGHT

67 -- High Speed Camera

Notice Date: 10/19/2021 12:02:00 PM
Notice Type: Sources Sought
NAICS: 333316 — Photographic and Photocopying Equipment Manufacturing
Contracting Office: FA2823 AFTC PZIO EGLIN AFB FL 32542-5418 USA
ZIP Code: 32542-5418
Solicitation Number: FA2823-22-Q-A002
Response Due: 10/25/2021 2:00:00 PM
Archive Date: 11/30/2021
Point of Contact: James Barnes, Misty Pounders
E-Mail Address: James.Barnes.49@us.af.mil, misty.pounders.1@us.af.mil
(James.Barnes.49@us.af.mil, misty.pounders.1@us.af.mil)
Small Business Set-Aside: SBA Total Small Business Set-Aside (FAR 19.5)
Description: SOURCES SOUGHT/REQUEST FOR INFORMATION The Department of Defense, United States Air Force (USAF), Air Force Materiel Command (AFMC), Air Force Test Center (AFTC), is currently conducting market research seeking capabilities statement from all potential sources, including small businesses (SB), 8(a), HUBZone, Economically Disadvantaged Woman-Owned (EDWOSB), Woman-Owned (WOSB), Service Disabled Veteran Owned (SDVOSB) small businesses that are capable of providing a High Speed Camera. Technical Specifications: The contractor shall provide High Speed Camera equipment that meets the following technical specifications below: �� 4 Gpx/second �� Max speed at full resolution of 2560 x 1600 is 1,100 fps �� 1920 x 1080 captures over 2,100 fps �� Max speed at reduced resolution of 128 x 4 is 290,000 fps �� Min frame rate of 24 fps �� CMOS sensor �� 2560 x 1600 pixels �� 10 �m pixel size �� 25.6 mm x 16.0 mm �� 12-bit depth �� ISO Monochrome 6,400 D �� ISO Color 1,250 D �� E.I range 1,250-6,400 (color); 6,400 - 32,000 (mono) �� TE cooled �� CAR in 128 x 4 increments �� 1 �s minimum exposure �� Global electronic shutter �� Exposure Index (E.I.) for controlling apparent ISO �� Extreme Dynamic Range (EDR) �� Auto Exposure �� Shutter Off mode for PIV �� 18 GB, 36 GB, 72 GB high-speed internal RAM �� On-board removable CFast 2.0 cards, up to 512GB �� 11.4 seconds at maximum frame rate, largest resolution and into maximum internal memory �� 10Gb Ethernet �� Segment memory for up to 63 cines in multi-cine mode �� Continuous recording �� Programmable I/O �� HD-SDI and HDMI video �� Event marking �� Frame timestamp (IRIG SMPTE or MISP) �� IRIG in/out (modulated and unmodulated) �� Shutter off mode for PIV exposure �� 1.71 ?s straddle time �� Standard Internal mechanical shutter for automatic/remote Current Session Reference (CSR) �� Image-Based Auto-Trigger (IBAT) �� One 12 VDC, 6W auxiliary power port �� Secondary IP address �� Field-based firmware upgrades �� Programmable trigger location (pre/post trigger recording) �� Image-Based Auto-Trigger �� Trigger from software �� Trigger from on-camera controls �� Hardware trigger BNC �� 20 ns timing accuracy �� Frame synchronization to internal or external clock �� IRIG in/out (modulated or unmodulated) �� Supports Cine RAW, Cine Compressed, AVI, h.264 mp4, Apple ProRes .mov, Multipage TIFF, MXF PAL, MXF NTSC, Uncompressed QuickTime, Windows BMP, OS/2 BMP, PCX, TGA, TIFF, LEAD, JPEG, JTIF, RAW, DNG, DPX �� Size (without lens): 5.0 x 5.0 x 5.0 inches (L x W x H); 12.7 x 12.7 x 12.7 cm �� Weight: 5.6 lbs (2.5 kg) �� Operating Temperature: -10�C - 50�C �� Shock:MIL-STD-202G Method 213-B. Rated 30G with shutter; 100G without shutter; sawtooth wave, 11ms, +/- 10 pulses all axes (60 total) �� Vibration: Rated 12Grms; Figure 2A-1, Test Condition D, 15 min per axis (without lenses) All interested vendors shall submit a response demonstrating their capability to provide the required equipment that meets the specifications to the Primary Point of Contact listed below. Proposals are not being requested or accepted at this time. As stipulated in FAR 15.201(e), responses to this notice are not considered offers and cannot be accepted by the Government to form a binding contract. No solicitation (Request for Proposal) exists at this time; therefore, do not request a copy of the solicitation. The decision to solicit for a contract shall be solely within the Government's discretion. The NAICS Code assigned to this acquisition is 333316, Photographic and Photocopying Equipment Manufacturing, with a small business size standard of 1000 employees. Respondents should indicate their size in relation to this size standard and indicate socio-economic status (i.e. SB, 8(a), HUBZone, EDWOSB, WOSB, or SDVOSB). Respondents are further requested to indicate their status as a Foreign-owned/Foreign-controlled firm and any contemplated use of foreign national employees on this effort. The Government reserves the right to consider a small business set-aside based upon responses hereto for any subsequent action. All prospective contractors must be registered in the System for Award Management (SAM) database to be awarded a DoD contract. No set-aside decision has been made. Note that a key factor in determining an acquisition to be a Small Business Set Aside is that small business prime contractors must perform at least 50% of the effort, as defined in FAR Clause 52.219-14. Any information submitted by respondents to this sources sought is voluntary. This sources sought notice is not to be construed as a commitment by the Government, nor will the Government reimburse any costs associated with the submission of information in response to this notice. Respondents will not be individually notified of the results of any government assessments. The Government's assessment of the capability statements received will factor into whether any forthcoming solicitation will be conducted as a full and open competition or as a set-aside for small business, or any particular small business program. CAPABILITIES STATEMENT: All interested vendors shall submit a capabilities statement that explicitly demonstrates their capability to provide the required equipment. The capabilities statement should be brief and concise, yet clearly demonstrate an ability to meet the stated requirement. The response must not exceed 4 pages. Responses must be submitted electronically to the following e-mail address: James.Barnes.49@us.af.mil and misty.pounders.1@us.af.mil. Correspondence sent via email shall contain a subject line that reads "" FA2823-22-Q-A002 High Speed Camera."" If this subject line is not included, the e-mail may not get through e-mail filters at Eglin AFB. Filters are designed to delete emails without a subject or with a suspicious subject or attachment. Attachments with files ending in .zip or .exe are not allowable and will be deleted. Ensure only .pdf, .doc, .docx, .xsls, or .xls documents are attached to your email. All other attachments may be deleted. The Government may or may not use any responses to this sources sought as a basis for a subsequent project/requirement. Any project/requirement developed from the sources sought responses may be the subject of a subsequent acquisition; any such subsequent acquisition will be posted in beta.sam.gov separately. Responses to this sources sought will not be returned. The Government is under no obligation to acknowledge receipt of the information received, or provide feedback to the respondents with respect to any of the information submitted under this sources sought. No requests for a bid package or solicitation will be accepted; a bid package or solicitation does not exist at this time. In order to protect the integrity of any possible future acquisition, no additional information will be provided and no appointments for presentations will be made in reference to this sources sought. Only government employees will review submitted responses to this sources sought. Respondents are advised that employees of commercial firms under contract with the Government may be used to administratively process submissions and perform other administrative duties requiring access to other contractor's proprietary information. These administrative support contractors include nondisclosure agreements prohibiting their contractor employees from disclosing any information submitted by other contractors or using such information for any purpose other than that for which it was furnished. RESPONSES ARE DUE NO LATER THAN 4:00pm CDT on 25 October 2021.
Web Link: SAM.gov Permalink
(https://beta.sam.gov/opp/e2fc60c98c30459e958257603c6d4caa/view)
Place of Performance: Address: Eglin AFB, FL 32542, USA; Zip Code: 32542; Country: USA
Record: SN06160663-F 20211021/211019230114 (samdaily.us)
Source: SAM.gov Link to This Notice
(may not be valid after Archive Date)

| FSG Index | This Issue's Index | Today's SAM Daily Index Page |

Loren Data's SAM Daily™

67 -- High Speed Camera