SOLICITATION NOTICE
17 -- Improved Low Loss Launch Valve Steam Heads
- Notice Date
- 1/25/2022 5:25:57 AM
- Notice Type
- Presolicitation
- NAICS
- 333999
— All Other Miscellaneous General Purpose Machinery Manufacturing
- Contracting Office
- NAVAIR WARFARE CTR AIRCRAFT DIV JOINT BASE MDL NJ 08733 USA
- ZIP Code
- 08733
- Solicitation Number
- N68335-22-R-0105
- Response Due
- 2/8/2022 9:00:00 AM
- Point of Contact
- Meryl Czaplinski, Phone: 7323237263
- E-Mail Address
-
meryl.s.czaplinski.civ@us.navy.mil
(meryl.s.czaplinski.civ@us.navy.mil)
- Description
- The Naval Air Warfare Center Aircraft Division (NAWCAD), Lakehurst in support of the Prototype, Manufacturing, and Test Division intends to solicit, negotiate, and award, on a limited competition basis, the procurement of �seven (7) improved Low Loss Launch Steam Heads (ILLLV) (P/N 626755-2) and an additional quantity of seven (7).[SEMCUNN(1]� The Contractor shall meet all technical and quality assurance requirements detailed in the drawings listed below as well as the Technical Data Requirements (TDR) 21-17030 and (Quality Management 1006) QM1006. Drawing 626755 Revision J: Steam Head Assembly Drawing 425384 Revision D: End Cap Drawing 426586 Revision D: Orifice Plate Drawing C314120 Revision F: Flange Drawing A315225 Revision L: Elbow 90� Drawing A315226 Revision M: Tee Drawing A315230 Revision K: Elbow 45� Drawing A316316 Revision W: Pipe Drawing C402783 Revision K: Gasket Drawing A404736 Revision K: Stud The ILLLV Steam Head is a designated Aircraft Launch and Recovery critical safety item (CSI).� Public Law 108-136 Section 802 Paragraph 8(2) states, �The head of the contracting activity for an aviation CSI enter into a contract for the procurement, modification, repair, or overhaul of such item only with a source approved by the design control activity in accordance with section 2319 of Title 10, United States Code.""� Technical Data Requirements 21-17030 Rev K regarding the procurement of the ILLLV Steam Head identifies five approved source, The Entwistle Company located in Hudson, MA (CAGE: 20722); Major Tool and Machine located in Indianapolis, IN (CAGE: 01263); Penn State Tool & Die Corporation in North Huntingdon, PA (CAGE: 58974); Pre-Mach Inc. in York, PA (CAGE: 5S946); Duhadaway Tool & Die Shop Inc. in Newark, DE (CAGE: 1V517).� In order to award to any other company than the five listed above, an engineering and quality assurance audit would need to be performed on an interested company.� The audit process generally takes twelve (12) months, which is an unacceptable delay to contract award and delivery.� All responsible sources are encouraged to submit a proposal in writing that may be used by the Government in determining whether or not to conduct a competitive procurement.� A determination by the Government not to open the requirement to competition based upon the response to this notice is solely within the discretion of the Government.� Responses must be received within 15 days of publication of this notice.� �
- Web Link
-
SAM.gov Permalink
(https://sam.gov/opp/8be4a3faccc34816aa4423d2c6e341b0/view)
- Record
- SN06223726-F 20220127/220125230105 (samdaily.us)
- Source
-
SAM.gov Link to This Notice
(may not be valid after Archive Date)
| FSG Index | This Issue's Index | Today's SAM Daily Index Page |