SOURCES SOUGHT
61 -- 6110 Contactor, Aircraft
- Notice Date
- 1/25/2022 7:06:53 AM
- Notice Type
- Sources Sought
- NAICS
- 335312
— Motor and Generator Manufacturing
- Contracting Office
- DLA LAND AND MARITIME COLUMBUS OH 43218-3990 USA
- ZIP Code
- 43218-3990
- Solicitation Number
- SPE7M922R0003
- Response Due
- 1/31/2022 12:00:00 PM
- Point of Contact
- Ken Pliska614-692-5373, Herman Poe614-692-2865
- E-Mail Address
-
Ken.Pliska@dla.mil, Herman.Poe@dla.mil
(Ken.Pliska@dla.mil, Herman.Poe@dla.mil)
- Description
- CONTACTOR, AIRCRAFT/CXN/AIRCRAFT, OSPREY V-22A, MARINE Review the below NSN and provide us with any sources that are able to manufacture the item. Please provide the POCs for these manufacturers, if available. All of this information can be submitted to Ken Pliska at ken.pliska@dla.mil, Phone (614) 692-5373on the attached market survey form. Thank you for your time and cooperation. NSN��� 6110014634433 CONTACTOR, AIRCRAFT RQ032: EXPORT CONTROL OF TECHNICAL DATA This item has technical data some or all of which is subject to export-control of either the International Traffic in Arms regulations (ITAR) or the Export Administration Regulations (EAR), and cannot be exported without prior authorization from either the Department of State or the Department of Commerce. Export includes disclosure of technical data to foreign persons and nationals whether located in the United States or abroad. This requirement applies equally to foreign national employees and U.S. companies and their foreign subsidiaries. DFARS 252.225-7048 is applicable to this data. The Defense Logistics Agency (DLA) limits distribution of export-control technical data to DLA contractors that have an approved US/Canada Joint Certification Program (JCP) certification, have completed the Introduction to Proper Handling of DOD Export-Controlled Technical Data Training and the DLA Export-Controlled Technical Data Questionnaire (both are available at the web address given below), and have been approved by the DLA controlling authority to access the export-controlled data. Instructions for obtaining access to the export-controlled data can be found at:�� https://www.dla.mil/HQ/LogisticsOperations/EnhancedValidation/ To be eligible for award, offerors and any sources of supply proposed for use are required to have an approved JCP certification and have been approved by the DLA controlling authority to access export-controlled data managed by DLA. DLA will not delay award in order for an offeror or its supplier to apply for and receive approval by the DLA controlling authority to access the export-controlled data. RD002, COVERED DEFENSE INFORMATION APPLIES RA001: THIS DOCUMENT INCORPORATES TECHNICAL AND/OR QUALITY REQUIREMENTS (IDENTIFIED BY AN 'R' OR AN 'I' NUMBER) SET FORTH IN FULL TEXT IN THE DLA MASTER LIST OF TECHNICAL AND QUALITY REQUIREMENTS FOUND ON THE WEB AT:� http://www.dla.mil/HQ/Acquisition/Offers/eProcurement.aspx FOR SIMPLIFIED ACQUISITIONS, THE REVISION OF THE MASTER IN EFFECT ON THE SOLICITATION ISSUE DATE OR THE AWARD DATE CONTROLS.� FOR LARGE ACQUISITIONS, THE REVISION OF THE MASTER IN EFFECT ON THE RFP ISSUE DATE APPLIES UNLESS A SOLICITATION AMENDMENT INCORPORATES A FOLLOW-ON REVISION, IN WHICH CASE THE AMENDMENT DATE CONTROLS. RP001: DLA PACKAGING REQUIREMENTS FOR PROCUREMENT RQ011: REMOVAL OF GOVERNMENT IDENTIFICATION FROM NON-ACCEPTED SUPPLIES MIL-STD-130N(1) DATED 16 NOV 2012. IDENTIFICATION MARKING OF U.S. MILITARY PROPERTY SAMPLING: THE SAMPLING METHOD SHALL BE IN ACCORDANCE WITH MIL-STD-1916 OR ASQ H1331, TABLE 1 OR A COMPARABLE ZERO BASED SAMPLING PLAN UNLESS OTHERWISE SPECIFIED BY THE CONTRACT. IF THE APPLICABLE DRAWING, SPECIFICATION, STANDARD, OR QUALITY ASSURANCE PROVISION (QAP) SPECIFIES CRITICAL, MAJOR AND/OR MINOR ATTRIBUTES, THEY SHALL BE ASSIGNED VERIFICAITON LEVELS OF VII, IV AND II OR AQLS OF 0.1, 1.0 AND 4.0 RESPECTIVELY. UNSPECIFIED ATTRIBUTES SHALL BE CONSIDERED AS MAJOR UNLESS SAMPLING PLANS ARE SPECIFIED IN APPLICABLE DOCUMENTS. FOR MIL-STD-1916, THE MANUFACTURER MAY USE THE ATTRIBUTE OR VARIABLE INSPECTION METHOD AT THEIR OPTION OR PER THE CONTRACT. MIL-STD-105/ASQ Z1.4 MAY BE USED TO SET SAMPLE LOT SIZE, BUT ACCEPTANCE WOULD BE ZERO NON-CONFORMANCES IN THE SAMPLE LOT UNLESS OTHERWISE SPECIFIED IN THE CONTRACT. RQ017: PHYSICAL INDENTIFICATION/BARE ITEM MARKING NOTE:� THE CITED DRAWING IS A SOURCE CONTROLLED DRAWING AND AS OF THE DATE OF THIS SOLICITATION ONLY THE SOURCE(S) CITED ON THE DRAWING HAVE BEEN APPROVED.� EVEN THOUGH SOURCES AND APPROVED PART NUMBERS ARE PROVIDED, THE ITEMS FURNISHED MUST MEET THE REQUIREMENTS OF THE CITED DRAWING.� OFFERORS WHO ARE INTERESTED IN QUALIFYING THEIR PRODUCT FOR PURPOSE OF FUTURE ACQUISITION MUST CONTACT THE COGNIZANT DESIGN ACTIVITY SPECIFIED ON THE SOURCE CONTROLLED DRAWING.� ALSO, MAY INCLUDE ADDITIONAL APPROVED SOURCES THAT HAVE NOT BEEN REFLECTED ON THE DRAWING AT THIS TIME. RQ001: HIGHER LEVEL CONTRACT QUALITY REQUIREMENTS (MANUFACTURERS AND NON-MANUFACTURERS) A QUALITY MANAGEMENT PROGRAM MEETING THE REQUIREMENTS OF ISO 9001:2008 OR A PROGRAM COMPARABLE TO ISO 9001:2008� (EX. SAE AS 9100). MERCURY OR MERCURY CONTAINING COMPOUNDS SHALL NOT BE INTENTIONALLY ADDED TO, OR COME IN DIRECT CONTACT WITH, ANY HARDWARE OR SUPPLIES FURNISHED UNDER THIS CONTRACT. EXCEPTION: FUNCTIONAL MERCURY USED IN BATTERIES, FLUORESCENT LIGHTS, REQUIRED INSTRUMENTS; SENSORS OR CONTROLS; WEAPON SYSTEMS; AND CHEMICAL NALYSIS REAGENTS SPECIFIED BY NAVSEA. PORTABLE FLUORESCENT LAMPS AND PORTABLE INSTRUMENTS CONTAINING MERCURY SHALL BE SHOCK PROOF AND CONTAIN A SECOND BOUNDARY OF CONTAINMENT OF THE MERCURY OR MERCURY COMPOUND. (IAW NAVSEA 5100-003D).� CRITICAL APPLICATION ITEM� LEACH INTERNATIONAL CORPORATION 58657 P/N W-X9N-039 IAW BASIC DRAWING NR 77272 901-375-008 REVISION NR R�� DTD 01/21/2016 PART PIECE NUMBER: -103 IAW REFERENCE DRAWING NR 77272 901-375-008 REVISION NR G�� DTD 01/21/2016 PART PIECE NUMBER: IAW REFERENCE DRAWING NR 77272 901-375-008 REVISION NR P�� DTD 01/21/2016 PART PIECE NUMBER:
- Web Link
-
SAM.gov Permalink
(https://sam.gov/opp/f29ffab7a4cb425da0dd9e764490aa84/view)
- Place of Performance
- Address: OH 43218, USA
- Zip Code: 43218
- Country: USA
- Zip Code: 43218
- Record
- SN06224517-F 20220127/220125230111 (samdaily.us)
- Source
-
SAM.gov Link to This Notice
(may not be valid after Archive Date)
| FSG Index | This Issue's Index | Today's SAM Daily Index Page |