SOURCES SOUGHT
59 -- Auxiliary Power Unit
- Notice Date
- 3/29/2022 6:58:47 AM
- Notice Type
- Sources Sought
- NAICS
- 335312
— Motor and Generator Manufacturing
- Contracting Office
- DLA LAND WARREN WARREN MI 48092 USA
- ZIP Code
- 48092
- Solicitation Number
- SPRDL1-21-R-0072
- Response Due
- 4/14/2022 10:00:00 AM
- Archive Date
- 06/26/2021
- Point of Contact
- Tanya Karasavvas, Phone: 5864671149, Source Approval Officer
- E-Mail Address
-
tanya.karasavvas@dla.mil, usarmy.detroit.tacom.mbx.lcmc-market-surveys@mail.mil
(tanya.karasavvas@dla.mil, usarmy.detroit.tacom.mbx.lcmc-market-surveys@mail.mil)
- Description
- The Auxiliary Power Unit (APU) for the M1A2 SEPv3 consists of a belt-driven 28-volt (V) generator, a 2-cylinder air-cooled diesel engine, a control box assembly, and a self-contained fuel supply. Power from vehicle batteries is used to drive the APU generator (in starter mode) through controls on the control box assembly. When in starter mode, the generator turns over the engine through a set of drive V belts. The engine is permitted to warm up, and then the generator is manually switched to load mode to produce electrical charge to vehicle batteries. The 28V Direct Current (DC) generator, driven by the diesel engine, produces an output of 154 to 204 amperes to maintain vehicle battery charge without vehicle engine operation. The APU is a 28V DC nominal power generation subsystem located in the rear left sponson of the M1A2 SEP V3 developed for the purpose of supporting 12 hours continuous silent watch or engine off operation. The Government currently does not have a Technical Data Package (TDP) to purchase this part from other than the current source(s). Only Marvin Land System has the requisite technical and engineering expertise to perform all efforts required to provide the supplies and services identified for this item. A substitute item can't be used without prior approval by TACOM. It is a critical item of the M1 Abrams electrical system and must meet the requirements specific to its intended function in accordance with Source Control Drawing 12591274/19207. This item assembly must meet the requirements and demonstrate compliance to performance, design, test, manufacture, and acceptance as specified in the Product Fabrication Specification (PFS) document SC-SA20450, including testing for compliance with electromagnetic interference and electromagnetic compatibility (EMI and EMR) shielding and nuclear hardening. This product is a survivability item and critical for Soldier safety. PLEASE NOTE: - This notice is not an open solicitation i.e., Invitation for Bid (IFB) or Request for Proposal (RFP). - Technical data is not available for this item. - Qualification testing and evaluation is required to become an approved source. - Source approval does not guarantee business. - Qualifying as an approved source only provides the opportunity to compete on future solicitations.
- Web Link
-
SAM.gov Permalink
(https://sam.gov/opp/d715cd48bfda4c438e73240f3968f4c9/view)
- Record
- SN06283197-F 20220331/220329230107 (samdaily.us)
- Source
-
SAM.gov Link to This Notice
(may not be valid after Archive Date)
| FSG Index | This Issue's Index | Today's SAM Daily Index Page |