Loren Data's SAM Daily™

SAMDAILY.US - ISSUE OF FEBRUARY 16, 2024 SAM #8116
SOLICITATION NOTICE

34 -- Deep Hole Boring Mill - with Amendments

Notice Date

2/14/2024 9:03:38 AM
 

Notice Type

Combined Synopsis/Solicitation
 

NAICS

333517 — Machine Tool Manufacturing
 

Contracting Office

W6QK ACC-RI ROCK ISLAND IL 61299-0000 USA
 

ZIP Code

61299-0000
 

Solicitation Number

W519TC-24-R-2022
 

Response Due

2/21/2024 8:00:00 AM
 

Archive Date

03/07/2024
 

Point of Contact

Heather Petersen, Cathy K. Mendoza
 

E-Mail Address

heather.j.petersen.civ@army.mil, cathy.k.mendoza.civ@army.mil
(heather.j.petersen.civ@army.mil, cathy.k.mendoza.civ@army.mil)
 

Small Business Set-Aside

SBA Total Small Business Set-Aside (FAR 19.5)
 

Description

PLEASE REVIEW ALL ATTACHMENTS 2/14/2024: RIPD Change see Amendments and new RIPD. 1/11/2024: It is our understanding that the drill tubes are tooling and in order to be prepared for possible scenarios, the request would be to have 1 each of drill tubes spanning from .551in � 1.693in. or whatever dimensional range is provided for the unit. It is our assumption that these items can be purchased from the vendor after contract award based on tooling requirements. This is the same for the guide bushings. Rock Island Arsenal JMTC has a tooling department that handles ordering tooling items, however, it is requested that a set be provided with the machine to ensure effective start up procedures. In regards to the centering cones versus the 8-in diameter chuck, The 8 in chuck is to be reflected. The centering cones were boiler plate material based on previous procurements of this type of equipment. It is unsure if our current cones would be compatible with this machine therefore it can be disregarded. Again, the assumption here is that after contract award, we can order tooling from the awarded vendor to supplement the equipment based on our tooling needs. ___________________________________________________ Additional Information: Currently workload is Alloy Steel but it would not be uncommon for there to be aluminum, and occasionally brass work. This is not an all encompassing list. If it can be drilled, bored on a deep hole, the potential for it to go on this machine exists. As for the runoff, part would be expected as part of the requirement. At this time, a part has not been identified, but per the RIPD the contractor would be responsible for a runoff part that showcases the capabilities of the equipment.
 

Web Link

SAM.gov Permalink
(https://sam.gov/opp/09d2abdc1ca24d0c90b1689554c8ca13/view)
 

Place of Performance

Address: Rock Island, IL 61299, USA

Zip Code: 61299

Country: USA
 

Record

SN06965970-F 20240216/240214230054 (samdaily.us)
 

Source

SAM.gov Link to This Notice
(may not be valid after Archive Date)

---

| FSG Index  |  This Issue's Index  |  Today's SAM Daily Index Page |