SOLICITATION NOTICE
A -- Gionometer Stage Design
- Notice Date
- 7/11/2024 4:25:58 PM
- Notice Type
- Solicitation
- NAICS
- 3332
—
- Contracting Office
- SLAC Natl Accel Lab -DOE Contractor Menlo Park CA 94025 USA
- ZIP Code
- 94025
- Solicitation Number
- SLAC_347858_GionometerStage
- Response Due
- 7/26/2024 5:00:00 PM
- Archive Date
- 08/10/2024
- Point of Contact
- Katherine Jill A. Coh, Phone: 6509262770
- E-Mail Address
-
kcoh@slac.stanford.edu
(kcoh@slac.stanford.edu)
- Description
- SLAC National Accelerator Laboratory is operated by Stanford University for the Department of Energy.� As a management and operating contractor, subcontracts awarded by the Laboratory are not Federal procurements, and are not directly subject to the Federal Acquisition Regulations in 48 CFR. Nonetheless, certain Federal laws, Executive Orders, and regulations may affect our DOE approved purchasing system, as required by statute, regulation, or contract terms and conditions. The follow has been attached for you to complete and review: 1.) (BAA) Buy American Act Certification 2.) Reps and Certs-Rider 3.) FP Commercial Supplies-Services T&Cs (August 2023) 4.) Round Carousel Goniometer Stage Design 5.) Required item(s) listed below: 1.����������� Qty 1 - Goniometer - 270 deg Semi-Circle, 3 Carriages, 2-Phase Stepper Motors with Gear Reduction, Worm & Worm Wheel Drive, Recirculating Bearings, Aluminum Structure with Customer Defined Location Hole & Slot, Motor & Sensor Connector at the Carriage, Full Cable Management for VDFM & Payloads, Atmospheric System, Table Mounted 2.����������� Qty 1 - Controller - (Primary), 2-Axis Control, coordinates up to 32 Axis, No Built-in Drivers, Software Included 3.����������� Qty 1 - Controller - (Secondary), 2-Axis Control Add-On, No Built-in Drivers 4.����������� Qty 2 - Driver - DC, 2-Axis for the primary Controller, 2-Phase Stepper Motors Notes: 1. 5.����������� Qty 3 - Cable - Jumper, Primary Controller or Secondary Controller to Driver, 1m 6.����������� Qty 3 - Cable - Stepper Motor, 5 Lead, Circular Housing for Motor, Controller Connector Other End, 15m 7.����������� The inner radius is 372.5mm, outer radius is 542.5mm in the step file (similar as that in the pdf 36.8cm inner radius and 53.5 cm outer radius). The carriage dimensions will be 20cmx15cm and embedded on the carousel. Carousel height is 80 mm. Quote is for product only; no on-site services permitted. Source selection will be based on Lowest Priced Technically Acceptable and best Lead-Time. Please provide a price and lead time quotation by COB 7/26/2024. Technical evaluation criteria are as follows: 1.����������� Qty 1 - Goniometer - 270 deg Semi-Circle, 3 Carriages, 2-Phase Stepper Motors with Gear Reduction, Worm & Worm Wheel Drive, Recirculating Bearings, Aluminum Structure with Customer Defined Location Hole & Slot, Motor & Sensor Connector at the Carriage, Full Cable Management for VDFM & Payloads, Atmospheric System, Table Mounted 2.����������� Qty 1 - Controller - (Primary), 2-Axis Control, coordinates up to 32 Axis, No Built-in Drivers, Software Included 3.����������� Qty 1 - Controller - (Secondary), 2-Axis Control Add-On, No Built-in Drivers 4.����������� Qty 2 - Driver - DC, 2-Axis for the primary Controller, 2-Phase Stepper Motors Notes: 1. 5.����������� Qty 3 - Cable - Jumper, Primary Controller or Secondary Controller to Driver, 1m 6.����������� Qty 3 - Cable - Stepper Motor, 5 Lead, Circular Housing for Motor, Controller Connector Other End, 15m 7.����������� The inner radius is 372.5mm, outer radius is 542.5mm in the step file (similar as that in the pdf 36.8cm inner radius and 53.5 cm outer radius). The carriage dimensions will be 20cmx15cm and embedded on the carousel. Carousel height is 80 mm. Send quote to emezzett@slac.stanford.edu Is there any room for additional discount such as for Academic, ICPT, GSA, or Government Institutions? Buy American Act Certification (BAA) applies to awards that are over $10,000. Representations & Certifications Rider is required. Once completed the Reps and Certs is valid for one year until renewal. If you have already completed one within the year, please disregard. Otherwise, please complete and return. All subcontractors are required to register in the System for Award Management (www.sam.gov ). If possible, please provide a link to your webpage for published price list to substantiate for the prices quoted. The resulting purchase order will be issued on a fixed price basis. SLAC National Accelerator Laboratory Terms and Conditions for Fixed Price Commercial Supplies and Services (Rev. August 2023) will be made a part of the resulting. order. Payment Terms will be NET-30 Freight terms will be FOB Destination Prepaid and Add You are requested to mark and identify proprietary/confidential information provided in response to the solicitation. Contact me directly with any questions. Kind regards, Edward Mezzetta Procurement Commodities Team SLAC National Accelerator Laboratory 2575 Sand Hill Road Menlo Park, CA 94025 Email: emezzett@slac.stanford.edu
- Web Link
-
SAM.gov Permalink
(https://sam.gov/opp/2eab6e10bab948808bff52a68111c30e/view)
- Place of Performance
- Address: Menlo Park, CA 94025, USA
- Zip Code: 94025
- Country: USA
- Zip Code: 94025
- Record
- SN07124348-F 20240713/240711230111 (samdaily.us)
- Source
-
SAM.gov Link to This Notice
(may not be valid after Archive Date)
| FSG Index | This Issue's Index | Today's SAM Daily Index Page |