Loren Data's SAM Daily™

SAMDAILY.US - ISSUE OF AUGUST 10, 2024 SAM #8292
MODIFICATION

49 -- F-22 Horizontal Stabilator Fixture Load Cell Upgrade

Notice Date

8/8/2024 2:48:07 PM
 

Notice Type

Solicitation
 

NAICS

541420 — Industrial Design Services
 

Contracting Office

FA8224 OL H PZI PZIM HILL AFB UT 84056-5805 USA
 

ZIP Code

84056-5805
 

Solicitation Number

FA822424R0018
 

Response Due

9/8/2024 4:00:00 PM
 

Archive Date

09/23/2024
 

Point of Contact

Kevin Hutchison, Phone: 8017774449, Shelly Bachison, Phone: 8015868606
 

E-Mail Address

kevin.hutchison.2@us.af.mil, shelly.bachison@us.af.mil
(kevin.hutchison.2@us.af.mil, shelly.bachison@us.af.mil)
 

Small Business Set-Aside

SBA Total Small Business Set-Aside (FAR 19.5)
 

Description

The F-22 depot facility on Hill AFB, UT needs to add time-savings and labor-saving functions and capabilities to (8) Government Furnished horizontal stabilator fixtures. These fixtures are used for the USAF�s F22 aircraft maintenance and production processes. This fixture is used to hold and manipulate the F-22 horizontal stabilator during production processes.� These processes include paint/coatings removal and paint/coatings spray and replacement.� The HS fixtures allow technicians to raise, lower and rotate the F-22 workpiece, which enables technicians to reach all surfaces of the work piece without the use of elevated work stands, platforms or ladders. The weighing operation occurs when technicians record the total static weight of horizontal stabilator.� The current process requires the work piece to be removed from the HS fixture by overhead crane, to perform required weight measurements.� A handling crew is assembled to perform a crane-assisted move, which suspends the workpiece for the hanging weight scale measurements.� A built-in weight scale will eliminate the work required by a handling crew. The contractor will modify and install upgrades to 8 GF fixtures per the accepted design. The contractor will have the option to perform work at the contractor�s facility, or at a location TBD on Hill AFB. If work is to be performed at the contractor�s facility, the contractor shall be responsible for all equipment and cost associated with the transportation of the 8 GF fixtures. The contractor will be allowed to perform work on a maximum of 2 GF fixtures at a time. The contractor�s initial proposal shall indicate where work will be performed. The Statement of Work (SOW) specifies the requirements to design, validate, fabricate, install, and verify the new capabilities and functions of the horizontal fixture. These new functions and capabilities are listed in the Statement of Work. The SOW is a controlled document and will only be distributed to small business contractors able to work under NAICS 541420 (Industrial Design Services). Please provide a current form DD 2345 and your CAGE CODE when requesting the SOW to review from the POC kevin.hutchison.2@us.af.mil�
 

Web Link

SAM.gov Permalink
(https://sam.gov/opp/17985a448ef3430c81242e58ea893dbc/view)
 

Place of Performance

Address: Hill AFB, UT 84056, USA

Zip Code: 84056

Country: USA
 

Record

SN07161669-F 20240810/240808230113 (samdaily.us)
 

Source

SAM.gov Link to This Notice
(may not be valid after Archive Date)

---

| FSG Index  |  This Issue's Index  |  Today's SAM Daily Index Page |