Department of Transportation, Federal Aviation Admin. (FAA), Contracts and Acquisition Management Branch, AWP-55, P.O., BOX 92007, WWPC., Los Angeles, CA. 90009-2007

Z -- REMOVAL AND DISPOSAL OF ENGINE GENERATOR AND ASBESTOS CONTAINING FLOOR TILE FROM E/G ROOM AT PHOENIX, AZ. (ATCT) SOL DTFA08-95-B-03282 POC Michelle H. Turner Provide all necessary labor, equipment and materials required to perform the work as described in FAA specifications and drawings. The work includes but is not limited to the following: (1) Provide a new diesel engine generator set. (2) Provide an automatic closed transition and bypass-isolation switch. (3) Provide accessories, including load bank, day tank batteries and battery charger, exhaust system and dampers, control devices and other equipment. In addition install a visible blade, heavy duty, 3-pole, non-fused, 600 VAC, 400A, lockable switch. (4) Construct new concrete pads for engine generator and remote radiator. (5) Provide proper branch circuits, as necessary, to provide power for the EGS, battery charger and other specified accessory equipment. (6) Remove and dispose the existing EGS, batteries, automatic transfer switch, manual bypass switch, two 480/277-208V transformers (T1 and T2), concrete slab in E/G room, conduits, 100KW load bank, remote radiator, and the evaporative cooler in E/G room. (7) Connect new EGS using existing underground conduits and new above ground conduits. (8) Ground all conduits, raceways and all other equipment according to FAA standard FAA-STD-091b. (9) Provide a 200KW (minimum), 480V, 3-phase temporary EGS and an automatic transfer switch. Automatic transfer switch shall be a closed transition transfer switch. EGS shall be provided with sufficient fuel for continuous 72 hour operation. (10) Obtain all necessary certifications and permits. (11) Test the EGS upon completion of the project. (12) Installation of cables between panel SB-1 and the engine generator room shall require working in an underground tunnel which can be classified as a confined space. (13) remove asbestos floor tiles and other asbestos containing material-ACM from engine generator room. The IFB DTFA08-95-B-03282 will be available approximately 30 days after the date of this publication with a public bid opening 30 calendar days from date of issuance. Estimated price range is between $100K and $250K. Standard Industrial Classification (SIC) Code is 1542. Requests for the IFB shall be made in writing to the aforementioned address or FAX to: (310)297-0056, Attn: Michelle Turner. This notice BELOW is for informational purposes for Minority, Women-Owned and Disadvantaged Business Enterprises: The Department of Transportation (DOT), Office of Small and Disadvantaged Business Utilization (OSDBU), has programs to assist minority, women-owned and disadvantaged business enterprises to acquire short-term working capital and bonding assistance for transportation-related contracts. This is applicable to any eligible prime or subcontract at any tier. The DOT Bonding Assistance Program enables firms to apply for bid, payment, and performance bonds up to 1.0 million per contract. The DOT provides an 80 percent guaranty on the bond amount to a surety against losses. Loans are also available under the DOT Short Term Lending Programs (STLP), at prime interest rates to provide accounts receivable financing. The maximun line of credit is $500,000. For further information regarding the bonding and lending programs, please call the DOT Office of Small and Disadvantaged Business Utilization at (800) 532-1169. For information concerning the acquisition, contact the contracting official listed above. (0093)

Loren Data Corp. http://www.ld.com (SYN# 0215 19950404\Z-0001.SOL)