Phillips Laboratory/PKOE, Directorate of Contracting, Operational Contracting Division, 2000 Wyoming Blvd SE, Kirtland Air Force Base, NM 87117-5606

58 -- OC12 MULTIPLEXER SYSTEM SOL F29650-OC12 POC Lorraine Otero, Contract Specialist, 505/846-2659 Mhynard Wink, Contracting Officer, 505/846-6898. The Air Force Phillips Laboratory, Directorate of Contracting, Kirtland AFB, NM, has a requirement for purchase of a Fujitsu OC12 Multiplexor System, or equal. The components of the system are as follows: 1) Shelf Assembly, Fujitsu P/N FC9616SF11-103, or equal, quantity 3; 2) HC6A-6LR1 HS Optical 1xOC-12 interface, Fujitsu P/N FC9616H6L1-103, quantity 7; 3) MC6A-D3 Electrical 3 X DS3 Interface, Prot.1:1, Fujitsu P/N FC9616MD31, quantity 5; 4) HS6A- AD1 Hi Speed Switch-Overhead Access, Fujitsu P/N FC9616SAM1-103, quantity 4; 5) TCA Timing Control Unit, Protected, Fujitsu P/N FC9616TCA1, quantity 7; 6) MP6A-ADM Microprocessor Unit, Fujitsu P/N FC9616MPA1-107, quantity 4; 7) SV6a-TL2 Supv EPROM based Interface for TL1x.25, Fujitsu P/N FC9616SVL2-102, quantity 4; 8) AW6A-BSC Alarm/Orderwire Unit, Basic, Fujitsu P/N FC9616AWB1-102 or equal, quantity 4; 9) PW6A Power Unit, Fujitsu P/N FC9616PW61-103 or equal, quantity 7; 10) Univ FiberTray Heat Shield & Fiber Storage, Fujitsu P/N HA15B-5101-B178 or equal, quantity 3; 11) EMI Shelf Cover, Fujitsu P/N FC9612FAC1-103 or equal, quantity 3; 12) FLEXR-600ADM Software Package, Fujitsu P/N SP60AR06-101 or equal, quantity 1. The minimum specifications for the OC12 mulitplexer system are as follows: 1. The multiplexer must a. be a synchronizer Optical Network (SONET) OC12 type, b. support terminal, hubbing, add/drop, and 2-fiber ring applications, c. be in service upgradeable to OC48, d. be configurable using ASCII or PC based terminal, e. be remotely accessible over an embedded SONET data communication channel for single ended maintenance, f. support remote software download providing a centralized approach to system updates, g. operate using standard 115 volt 60 Hz power, h. fit in a standard 21 inch Telco rack with a max height of 24 inches, i. optical units must operate on standard 1310 nm optical wavelength single mode fiber for spans exceeding 90 km in length between nodes, j. be an optical system that processes combinations for up to twelve DS3, or STS-1, or four OC-3 tributary signals, and multiplexes them into one STS-12. The STS-12 signal is then converted to an optical OC 12 signal and transmitted. 2. The Middle-speed Channel Unit DS3 must support the following: a. Interfaces with three DS3 signals and form three SONET STS signals, b. drops/inserts path, line and section overhead bytes, c. provides path switching function for ring application. 3. The Middle-speed Channel Unit STS1 must support the following: a. Interfaces with three STS1 signals, b. Drops/Inserts Path, Line and Section overhead bytes, c. Provides Path Switching function for ring application; 4. The Middle-speed Channel Unit Long Reach must a. support the OC 3 tributary interface as follows: (1) 155.52 Mb/s optical signal, (2) 1310 nm optical wavelength, (3) 40 km span length. b. Multiplexes and demultiplexes three STS-1 signals to/from STS-3 signals, c. available with FC, SC, ST, or D4 optical connectors; 5. The High-speed Channel Unit Long Reach must: a.support terminal, ADM and Ring Configuration, b. multiplexes and demultiplexes three STS-1 signals to/from STS-12 signals, c. Drops/Inserts Path, Line and Section overhead bytes, d. Provides STS-1 TSA function, e. support the OC12 interface as follows: (1) 600 Mb/s optical signal, (2) 1310 nm optical wavelength, (3) 40 km or more span length, f. available with FC, SC, ST, or D4 optical connectors; 6. Transmission Interface Specifications: a. DS3 Low Speed Interface: (1) conform to CB-109, ANSI T1 102-1992 (draft), TR-449 Issue 5 (VMR, VM, or clear channel), (2) Bit Rate: 44.736 Mb/s+ 20ppm, b. EC1 Low Speed Interface must conform to ANSI T1 102-1992 (draft), TR-253 Issue 2, c. OC3 Interface (1310 nm): (1) conform to ANSI TI 108/88, ANSI T1 105/88, T1 105a/90, TR-253 Issue 2, SONET LR-1 MLM, TR-496 Issue 3, (2) Transmitter Type: InGaAsP laser, (3) Receiver type: InGaAsP or InGaAsP PIN, d. OC12 Interface (1310nm): (1) conform to ANSI T1 106/88, ANSI T1 105/88, and T1 105a/90, TR-253 Issue 2, SONET LR-1 MLM, TR-496 Issue 3, (2) Transmitter Type: InGaAsP laser, (3) Receiver type: Ge APD or InGaAs APD, (4) BER: 10-10 (1 repeater). The following acronym information is provided: STS-1 = Synchronous Transport Signal with a data rate of 51.84 Mb/s. OC-3 = Optical Carrier with a rate of 155.52 Mb/s. OC-12 = Optical Carrier with a rate of 622.08 Mb/s. DS-3 = Digital Standard for asynchronous data with a rate of 44.736 Mb/s. TSA = Time Slot Assignment. ADM = Add Drop Multiplexer. NOTE: All other acronyms and abbreviations are Industry Standard Terms. Firms proposing on an ''or equal'' item shall submit technical documentation, brochures, schematics, etc, so that the item can be evaluated for compliance with specifications. Solicitation for this requirement will be issued on or about 12 Jun 95 and will close 30 days thereafter. The Government reserves the right to consider this acquisition for the 8(a) program, small disadvantaged business set-aside, small business set-aside, historically black colleges and Universities or minority institutions set-asides based upon responses to this synopsis. Foreign-owned firms will not be precluded from participating on this acquisition. Firms responding to this synopsis should indicate whether they fall into these categories. SIC Code: 3669, Size Standard: 750 employees. An ombudsman has been appointed to hear concerns from offerors or potential offerors during the proposal development phase of this acquisition. The purpose of the Ombudsman is to receive and communicate serious concerns from potential offerors when an offeror prefers not to use established channels to address concerns during the proposal development phase of this acquisition. Potential offerors should use established channels to request information, pose questions, and voice concerns before contacting the ombudsman. For serious concerns only, potential offerors are invited to contact Bruce Grunsten in the Directorate of Contracting, at 505/846-8273 or at 3651 Lowry Ave SE, Kirtland AFB, NM 87117-5777. (0130)

Loren Data Corp. http://www.ld.com (SYN# 0456 19950511\58-0001.SOL)