Directorate Of Contracting, Oo-Alc 6050 Gum Lane/Bldg 1215, Hill Air Force Base, Ut 84056-5825

16 -- PIN DRAGSTRU SOL F42630-96-Q-67816 DUE 050796 POC For copy, PKX-2/Pamala Chaffee/(FAX)801-777-7522, For additional information contact Landing Gear/Photo/Likl/(801)777-6501 Item 0001 NSN 1620-00-863-2680 P/N: 388045-3, Steel pin beveled at one end stepped down at opposite end. Drilled through in two places at right angles to pin body. Hole in beveled end. 300'' deep. 250 finish on all machined surfaces. 6.08'' long, 1.4360 plus or minus. 0005'' dia. 4340 steel rod 1 1/2'' X 7''. H.T. 260,000 - 280,000 P.S.I. item lock the gear in position to prevent castoring of the gear when extended. Mates with shelf brkt. 1873ea. Applicable to: C130. Destn: Hill Air Force Base, Ut 84056-5825. Delivery: 27 Feb 98 1873 ea Item 0002 data, 1 lot Qualification requirements: Sources must be qualified prior to being considered for award. The solicitation will contain instructions for obtaining further information on this requirement. The requirements of FAR 9.202(A) have been completed and copies of the qualification requirements and standards may be obtained as described in the solicitation. These qualification requirements apply to line item(s) all The approximate issue/response date will be 15 Apr 96. The anticipated award date will be 07 May 96. Written procedure will be used for this solicitation. To: A And M Aerospace Inc, Denver Co 80173 4321. To: The Freeman Co, Yankton Sd 57078 0057. First article test required. No telephone requests. Only written or faxed requests received directly from the requestor are acceptable. All responsible sources solicited may submit a bid, proposal, or quotation which shall be considered. Award will be made only if the offeror, the product/service, or the manufacturer meets qualification requirements at the time of award in accordance with FAR clause 52.209-1. The solicitation identifies the office where additional information can be obtained concerning qualification requirements is cited in each individual solicitation. It is suggested that small business firms or others interested in subcontracting opportunities in connection with the described procurement make contact with the firm(s) listed. Requests for copies of solicitations must reference the entire solicitation number, including purchasing office identification number. To expedite your request, limit the number of individual solicitation numbers requested per letter to not more than 10. Don't request information on this requirement until after the issue date. This proposed procurement is under a 100 percent small business set aside, the size standard for which is 1,000 employees. An Ombudsman has been appointed to hear concerns from offerors or potential offerors during the proposal development phase of this acquisition. The purpose of the Ombudsman is not to diminish the authority of the program director or contracting officer, but to communicate contractor, concerns, issues, disagreements, and recommendations to the appropriate government personnel. When requested, the Ombudsman will maintain strict confidentiality as to the source of the concern. The Ombudsman does not participate in the evaluation of proposals or in the source selection process. Interested parties are invited to call Jack S. Jones if your concerns are not satisfied by the contracting officer (801)777-6991. See Note (s) 1. (0086)

Loren Data Corp. http://www.ld.com (SYN# 0167 19960327\16-0001.SOL)