Commander, U.S. Army Missile Command, Acquisition Center, Redstone Arsenal, AL 35898-5280

66 -- DIAPHRAGM CAPACITANCE GAUGE W/DIRECT PRESSURE DIGITAL READOUT (DCG/DPDR) (0.0001-1.0000); (0.01-100.00); (0.001-10.000); (0.1-1000.0); (0.01-100.0) SOL DAAH01-96-T-0585 DUE 052096 POC Lana P. Decker, Contract Specialist, AMSMI-AC-CFFA, (205) 842-7331, Gary Poolos, Contracting Officer, AMSMI-AC-CFFA, (205) 876-4153, PCF. Synopsis Number 0152-96. (i) This is a combined synopsis/solicitation for commercial items prepared in accordance with the format in subpart 12.6, as supplemented with additional information included in this notice. (ii) The solicitation number DAAH01-96-T-0585 is hereby issued as a Request for Quotation (RFQ). (iii) The solicitation document and incorporated provisions and clauses are those in effect through Federal Acquisition Circular 90-32. (iv) This acquisition is unrestricted. (v) All items shall be delivered within 90 days after contract award. Earlier delivery is acceptable and desirable at no additional cost to the Government. Deliveries shall be made F.O.B. Destination to Redstone Arsenal Support Activity, Installation Supply Activity Account, Bldg. 8022, Redstone Arsenal, AL 35898-5330. Inspection and acceptance shall be at destination. (vi) FAR 52.212-1, Instructions to Offerors-Commercial Items is applicable. (vii) FAR 52.212-2, Evaluation - Commercial Items is applicable. (viii) The offeror shall include a complete copy of the FAR provisions at 52.212-3, Offeror Representations and Certifications - Commercial Items. (ix) FAR 52.212-4, Contract Terms and Conditions - Commercial Items is applicable. The Government intends to award a contract resulting from this solicitation to the responsible, responsive, technically acceptable, and lowest priced offeror whose offer conforms to the solicitation and will be most advantageous to the Government. (x) FAR 52.212-5, Contract Terms and Conditions Required to Implement Statutes or Executive Orders - Commercial Items is applicable. (xi) An evaluation shall be performed to determine if each quote is technically acceptable. A technically acceptable quote must clearly show that the offeror can meet the minimum requirements of the Government. Each quote will be reviewed to assure that each function included in the specification is addressed in the quote. Therefore, each offeror must respond to each functional requirement of the specification. (xii) Bar code marking is not required. (xiii) Offers are due 20 May 1996, 2:00 p.m. local time. The proposal must be signed by an official authorized to bind your organization. You must submit two (2) copies to: U.S. Army Missile Command, AMSMI-AC-CFFA/Ms. Lana P. Decker, Redstone Arsenal, AL 35898-5280, Solicitation Number DAAH01-96-T-0585. Offers may be submitted on letterhead stationary and, at a minimum, must show: (1) the solicitation number; (2) the time specified in the solicitation for the receipt of offers; (3) the name, address, and telephone number of the offeror; (4) a technical description of the items being offered in sufficient detail to evaluate compliance with the requirements of the solicitation. This may include product literature, or other documents, if necessary; (5) terms of any express warranty; (6) price and discount terms; (7) ''remit to'' address, if different from mailing address; (8) a completed copy of the representations and certifications; (9) if the offer is not submitted on the SF 1449, include a statement specifying the extent of agreement with all terms, conditions, and provisions included in the solicitation. Offers that fail to furnish required representation or information, or reject the terms and conditions of the solicitation may be excluded from consideration. Information regarding this solicitation can be obtained from Ms. Lana Decker, (205) 842-7331. (xiv) DESCRIPTION OF REQUIREMENTS FOR THE ITEMS TO BE ACQUIRED: DIAPHRAGM CAPACITANCE GAUGE WITH DIRECT PRESSURE DIGITAL READOUT. NOMENCLATURE: Absolute Pressure Capacitance Manometer QUANTITY: 1 PRESSURE RANGE: 0.0001-1.0000 torr absolute OVERPRESSURE RATING: 120% full scale ACCURACY: to hold +/- 0.05% of reading across entire pressure range for a one year interval FITTINGS: CAJON 4 VCR-female OUTPUT: 0-10 VDC OPERATING TEMPERATURE: 15 to 40 Degrees Celsius (gauge will have internal heater regulated to +/- 1 degrees Celsius) MEDIA COMPATABILITY: Air, Nitrogen REFRENCE PRESSURE: Refrence side of diaphragm maintained at 1E-7 torr or better DIGITAL READOUT: 5 1/2 Digit LCD RANGE SELECTIONS ON READOUT: X1, X.1, X.01 of Full Scale READOUT ACCURACY: .001% full scale READOUT PRESSURE UNITS: mmHg, Kpa, Inche Hg, Inches Water, psi OPERATING TEMPERATURE (READOUT): 15 to 40 Degrees Celsius ELECTRONIC ZERO ON FRONT PANEL OF READOUT READOUT POWER REQUIREMENTS: 115-120 VAC, 60 HZ CABLES: If cable hookup between gauge and readout is required, a cable with minimum length of 6 feet is required. DIAPHRAGM CAPACITANCE GAUGE WITH DIRECT PRESSURE DIGITAL READOUT NOMENCLATURE: Absolute Pressure Capacitance Manometer QUANTITY: 1 PRESSURE RANGE: 0.01-100.00 torr absolute OVERPRESSURE RATING: 120% full scale ACCURACY: to hold +/- 0.05% of reading across entire pressure range for a one year interval FITTINGS: CAJON 4 VCR-female OUTPUT: 0-10 VDC OPERATING TEMPERATURE: 15 to 40 Degrees Celsius (gauge will have internal heater regulated to +/- 1 degrees Celsius) MEDIA COMPATABILITY: Air, Nitrogen REFRENCE PRESSURE: Refrence side of diaphragm maintained at 1E-7 torr or better DIGITAL READOUT: 5 1/2 Digit LCD RANGE SELECTIONS ON READOUT: X1, X.1, X.01 of Full Scale READOUT ACCURACY: .001% full scale READOUT PRESSURE UNITS: mmHg, Kpa, Inche Hg, Inches Water, psi OPERATING TEMPERATURE (READOUT): 15 to 40 Degrees Celsius ELECTRONIC ZERO ON FRONT PANEL OF READOUT READOUT POWER REQUIREMENT: 115-120 VAC, 60 HZ CABLES: If cable hookup between gauge and readout is required, a cable with a minimum length of 6 feet is required. DIAPHRAGM CAPACITANCE GAUGE WITH DIRECT PRESSURE DIGITAL READOUT NOMENCLATURE: Absolute Pressure Capacitance Manometer QUANTITY: 1 PRESSURE RANGE: 0.001-10.000 torr absolute OVERPRESSURE RATING: 120% full scale ACCURACY: to hold +/- 0.05% of reading across entire pressure range for a one year interval FITTINGS: CAJON 4 VCR-female OUTPUT: 0-10 VCD OPERATING TEMPERATURE: 15 to 40 Degrees Celsius (gauge will have internal heater regulated to +/- 1 degrees Celsius) MEDIA COMPATIBILITY: Air, Nitrogen REFRENCE PRESSURE: Refrence side of diaphragm maintained at 1E-7 torr or better DIGITAL READOUT: 5 1/2 Digit LCD RANGE SELECTIONS ON READOUT: X1, X.1, X.01 of full scale READOUT ACCURACY: .001% full scale READOUT PRESSURE UNITS: mmHg, Kpa, Inche Hg, Inches Water, psi OPERATING TEMPERATURE (READOUT): 15 to 40 Degrees Celsius ELECTRONIC ZERO ON FRONT PANEL OF READOUT READOUT POWER REQUIREMENT: 115-120 VAC, 60 HZ CABLES: If cable hookup between gauge and readout is required, a cable with a minimum length of 6 feet is required. DIAPHRAGM CAPACITANCE GAUGE WITH DIRECT PRESSURE DIGITAL READOUT NOMENCLATURE: Absolute Pressure Capacitance Manometer QUANTITY: 1 PRESSURE RANGE: 0.1-1000.0 torr absolute OVERPRESSURE RATING: 120% full scale ACCURACY: to hold +/- 0.05% of reading across entire pressure range for a one year interval FITTINGS: CAJON 4 VCR-female OUTPUT: 0-10 VDC OPERATING TEMPERATURE: 15 to 40 Degrees Celsius (gauge will have internal heater regulated to +/- 1 degrees Celsius) MEDIA COMPATABILITY: Air, Nitrogen REFRENCE PRESSURE: Refrence side of diaphragm maintained at 1E-7 torr or better DIGITAL READOUT: 5 1/2 Digit LCD RANGE SELECTIONS ON READOUT: X1, X.1, X.01 of Full Scale READOUT ACCURACY: .001% full scale READOUT PRESSURE UNITS: mmHg, Kpa, Inche Hg, Inches Water, psi OPERATING TEMPERATURE (READOUT): 15 to 40 Degrees Celsius ELECTRONIC ZERO ON FRONT PANEL OF READOUT READOUT POWER REQUIREMENT: 115-120 VAC, 60 HZ CABLES: If cable hookup between gauge and readout is required, a cable with a minimum length of 6 feet is required. DIAPHRAGM CAPACITANCE GAUGE WITH DIRECT PRESSURE DIGITAL READOUT NOMENCLATURE: Differential Pressure Capacitance Manometer QUANTITY: 1 PRESSURE RANGE: 0.01-100.00 torr differential OVERPRESSURE RATING: 120% full scale ACCURACY: to hold +/- 0.05% of reading across entire pressure range for a one year interval FITTINGS: CAJON 4 VCR-female OUTPUT: 0-10 VDC OPERATING TEMPERATURE: 15 to 40 Degrees Celsius (gauge will have internal heater regulated to +/- 1 degrees Celsius) MEDIA COMPATABILITY: Air, Nitrogen REFRENCE PRESSURE: Refrence side of diaphragm maintained at 1E-7 torr or better DIGITAL READOUT: 5 1/2 Digit LCD RANGE SELECTIONS ON READOUT: X1, X.1, X.01 of Full Scale READOUT ACCURACY: .001% full scale READOUT PRESSURE UNITS: mmHg, Kpa, Inche Hg, Inches Water, psi OPERATING TEMPERATURE (READOUT): 15 to 40 Degrees Celsius ELECTRONIC ZERO ON FRONT PANEL OF READOUT READOUT POWER REQUIREMENT: 115-120 VAC, 60 HZ CABLES: If cable hookup between gauge and readout is required, a cable with a minimum length of 6 feet is required. (0088)

Loren Data Corp. http://www.ld.com (SYN# 0263 19960329\66-0001.SOL)