Arnold Engineering Development Center, ATTN: PKP, 100 Kindel Drive, Suite A332, Arnold AFB TN 37389-1332

34 -- IRONWORKER SOL F40650-96-B-0030 DUE 061796 POC Sue Tate, Contract Specialist, (615)454-7841 Universal ironworker, equal to a Buffalo universal iron worker Model #2 1/2 with the following features: punch station with single lpunch tool for structural sections or plate; 2 round punches and one each flat and bevel die. Bar cutter station with knives for angle (square and miter cuts) rounds and squares. Flat bar shear station with reversible shear blades. Built-in notcher at punch end. Built-in coper at shear end. Work support for flat bar shear station. Bijur manual central lubrication system. Pneumatic anti-repeat foot controls. Fully enclosed combination gear and flywheel guard. Slug chutes at punch and coper stations. 7 1/2 HP normal torque motor, 208-230/460-550 volt, 3 phase, 60 HZ, 1800 rpm, nema, design ''B'' totally enclosed, fan cooled, horizontal ball bearing. Magnetic combination full voltage starter in automotive nema type 12 enclosure, with 110 volt control circuit transformer and fused disconnect switch and heavy duty oil tight start-stop push-button and gound indicating pilot light in cover. Unit must have a minimum 110 tons punch ram pressure and a throat depth of at least 20 inches. Unit to also include one special die block for 3'', 4'', 5'' beams and channels; one set of round punches and matching dies, sizes 3/6'' to 1 7/16'', in 1/32'' increments (41 sizes); one set of round dies for use with special die block, sizes 7/32'' to 27/32'', in 1/32'' increments (21 sizes). The due date given above is an estimated date and should not be considered a firm due date for receipt of bids. Firms responding to this synopsis should do so in writing and indicate whether they are a minority business. You may send requests by facsimile to (615)454-7330. Foreign participation is allowed. (0124)

Loren Data Corp. http://www.ld.com (SYN# 0195 19960506\34-0001.SOL)