|
COMMERCE BUSINESS DAILY ISSUE OF JUNE 3,1996 PSA#1607Department of the Treasury, United States Mint, Office of Procurement,
Room 200, 633 Third Street, N.W., Washington, DC 20220 95 -- COPPER PLATED ZINC (CPZ) BLANKS SOL USM-96-023 DUE 061496 POC
Debi Kearns, Contract Specialist, (202) 874-6298, Len H. Postman,
Contracting Officer (202) 874-6243. This is a request for information
(RFI) and market survey to determine if there are any responsive and
responsible private sector offerors which are interested in providing
copper plated zinc (CPZ) one-cent blanks to support the manufacture of
pennies for the United States Mint. CPZ blanks weigh approx. 2.50
grams with a diameter of 18.75mm and a maximum overall thickness of
1.626mm. The copper plating shall be approx. 0.008mm thick. The scope
of the requirement will include fabrication of (a) standard and
uncirculated CPZ blanks for delivery (F.O.B. Destination) to the U.S.
Mints in Philadelphia, PA. and Denver, CO., (b) proof CPZ blanks for
delivery (F.O.B. Origin) to the U.S. Mint located in San Francisco, CA.
At this time, the U.S. Mint has no firm requirement for this
acquisition. THIS IS A REQUEST FOR INFORMATION AND MARKET SURVEY ONLY.
The U.S. Mint will use the information obtained from this notice to
understand the capabilities of the marketplace. All interested parties
should provide, at no cost to the Mint, full descriptive literature
demonstrating their capabilities to provide the above requirements
within 14 days after publication of this notice. To be considered
capable, parties must demonstrate the following: (1) technical
knowledge/experience in fabrication of blanks; (2) past/current
performance as it pertains to relevant experience in fabrication; (3)
corporate capabilities in the areas of technical, quality assurance,
and fabrication of blanks as described above. Literature provided shall
be limited to twenty (20) pages; contractor format acceptable. All of
the literature provided in response to this synopsis will become the
property of the U.S. Mint and will not be returned. It is anticipated
that a draft solicitation will be issued for any resulting requirement.
Interested offerors may request to be included on the source list for
that draft document by providing a written request to the above
address, noting the title of this synopsis. (0151) Loren Data Corp. http://www.ld.com (SYN# 0437 19960531\95-0004.SOL)
95 - Metal Bars, Sheets and Shapes Index Page
|
|