C1, 14, F210, OIC of NAVFAC Contracts, 1 Simonpietri Dr., NETC Newport, RI 02840

Z -- PROVIDE AND INSTALL A NEW BULLET TRAP IN BLDG 440, CODDINGTON POINT, NAVAL EDUCATION AND TRAINING CENTER, NEWPORT, RI SOL N62472-96-Q-6950 DUE 092696 POC Ms. East, ROICC, NAVFAC Contracts, Bldg 1, Simonpietri Dr., NECT, Newport, RI. The work consists of removing and disposing of the existing bullet trap and installing a new Granular Rubber Bullet Trap, Model LE 6500P, manufactured by Caswell International Corporation, under a Firm Fixed Price Simplified Acquisition. BULLET TRAP, GRANULATED MATERIAL - A full size, full-service bullet trap shall be provided that will terminate the travel of all properly directed bullets normally expected for a range of this class of service. Type of System - The trap shall be an elastic belting type with Grantex material. This is comprised of overlapping elastic belts that allow the projectile to penetrate, Grantex material to stop projectiles with little or no fragmentation and a steel back plate for additional safety. Manufacturer of System - Notwithstanding any other provision of this contract, including but not limited to the material and workmanship clause, no other product, except the following will be accepted. (a) The bullet trap shall be a Granular Rubber Bullet Trap, Model LE6500P, as manufactured by Caswell International Corporation. SPATIAL REQUIREMENTS - The trap shall shelter the butts end of the range from wall to wall and from floor to the highest bullet path that can be expected from the firing line as shown on the shop plans. Additional baffling and protective guards shall be provided by the trap supplier to protect against damage from high and wide shots. Critical Height of Trap - The critical height of the trap shall be 96 inches maximum. This is the highest distance above the floor that an incoming bullet can directly strike the elastic belting. (Any higher shots strike the overtrap baffling). OVERALL HEIGHT OF TRAP - The overall height shall be 118 inches maximum from floor to the top of the overtrap unless otherwise shown on the shop plans. Depth of Trap - The depth of the trap shall be minimized to conserve floor space and provide for maximum target distance. In no event shall the trap require more than 7 feet from the back wall of the room unless otherwise shown on the shop plans. FUNCTIONAL REQUIREMENTS - The trap shall be capable of full-time service of the type normally experienced for ranges of the specified class of service. Design - The bullet trap shall be designed for use with all handgun, rifle, shotgun and machine gun ammunition (jacketed, semi-jacketed, or non-jacketed), all shot-shell ammunition including slugs. It shall withstand use of soft-point rifle and sub-machine-gun ammunition with muzzle velocity between 900 and 2,000 feet per second and energy to 2,200 foot-pounds. Patent - The trap shall recover the spent rounds largely intact for periodic salvage. THIS PRODUCT IS LICENSED AND MANUFACTURED UNDER PATENT #5-171,020 AND OTHER PATENTS PENDING. The SIC code is 1799 and the small business size standard is $7.0 million. This solicitation will be issued unrestricted. The estimated cost is $25,000 - $100,000. The date quotes are due will be indicated on the Standard Form 18 included in the solicitation package. Quoters may request solicitation packages in writing to ROICC, NAVFAC Contracts, NETC, Building 1, Simonpietri Dr., Newport, RI 02841-1712 or Fax (401) 841-1349. State your name, address and solicitation number by 16 Sep 1996. The RFQ packages will be available on a first come first served basis. NOTE 22 APPLIES. (0234)

Loren Data Corp. http://www.ld.com (SYN# 0146 19960822\Z-0027.SOL)