GSA/ITS/6KE, 1500 E. Bannister Road, Kansas City, MO 64131-3088

70 -- GENERAL-PURPOSE AUTOMATED DATA PROCESSING EQUIPMENT (INCLUDING FIRMWARE), SOFTWARE, SUPPLIES, AND SUPPORT EQUIPMENT SOL 6TSA-97-DJH-0053 DUE 120696 POC CONTACT DELTA HELM BY FAX (816)823-3322 This is a combined synopsis/solicitation for commercial items prepared in accordance with the format in Federal Acquisition Regulations document (FAR) subpart 12.6, as supplemented with additional information included in this notice. Thisannouncement constitutes the only solicitation: proposals are being requested and A WRITTEN SOLICITATION WILL NOT BE ISSUED. Solicitation number 6TSA-97-DJH-0046 is being issued as a request for proposals (RFP). The solicitation document andincorporated provisions and clauses are those in effect through Federal Acquisition Circular (FAC) 90-38. CLIN 1. 2-Strand tight buffered fiber optic cable, riser rated, multimode, zipcord, flexible PVC (OFNR). Must have 62.5/125 micron corediameter/cladding diameter, primary buffer of UV cured acrylate material to a diameter of 250 micron and a secondary buffer of PVC material of 900 micron. The outer sheath must meet all non plenum application requirements of the 1993 NationalElectrical Code (NEC Article 770-51B). part number AX02-030N-W3SB/1UC-900-R, Qty. 1420 ft. CLIN 2. 24 strand hybrid tight buffered fiber optic cable. Riser Rated. Indoor/Outdoor. Flame retardant PVC (OFNR rated) outer jacket. Must have; 12 tightbuffered multimode strands with a 62.5/125 micron core diameter/cladding diameter and 12 tight buffered single-mode strands with a 9/125 micron core diameter/cladding diameter, 250 micron acrylate primary buffer coating over each buffer, 900 micron PVCsecondary tight buffer coating over each cable, dielectric central member, surrounded by an aramid yarn strength member. The outer sheath must meet all non-plenum application requirements of the 1993 National Electrical Code (NEC Article 770-51B).part number DX024-080D-12W3SB/1UC/12SYMC/YMD-900-R, Qty. 2525 ft. CLIN 3. Unshielded twisted pair, category 5. (Non-Plenum) Must have identical jacketing materials on all pairs, 4 pair PVC. Packaged in rolls of 1000 ft. part number CM-00009/4, Qty.16,665 ft. CLIN 4. Tool for connecting SC and ST Unicam type connectors, part number TKT-Unicam, Qty. 2. CLIN 5. SC Duplex Clip, 100 per package, part number 95-400-01-BP, Qty. 2 packages. CLIN 6. Unicam, ST compatible multimode connector for 62.5micron fiber with composite ferrule and rotating cam, part number 95-0200-50, Qty. 228. CLIN 7. Unicam St compatible single mode connector for 9 micron fiber with composite ferrule and rotating cam. Part number 95-0200-51, Qty. 156. CLIN 8. PatchPanel, wall mount, multimode fiber optic, 24 port, dual door, pre-loaded with ST type connectors, dimensions: 16''W x 16''H x 3''D, color IBM beige/light tan, part number 02213ZL-2240, Qty. 9. CLIN 9. Patch Panel, 48 port, EIA-568B, 110-Clip, RJ-45, Cat5/100 Mhz, 3.5'' x 19'', part number 49484-B48, Qty. 4. CLIN 10. Patch Panel, 24 port, EIA-568B, 110-Clip, RJ-45, Cat 5/100 MHz, 1.75'' x 19'', part number 49484-B24, Qty. 10. CLIN 11. Bracket, wall mount, 2 position, 3.5''H x 6.0''D, hinged wall mountbracket, part number 49251-W62, Qty. 14. CLIN 12. Patch cord, jumper, Cat 5, 568B, RJ45 to RJ45, 7 ft. part number PCSTC5B07F, Qty. 205. CLIN 13. Patch cord, jumper, cat 5, 568B, RJ45 to RJ45, 10 ft. part number PCSTC5B10F, Qty. 7. CLIN 14. PatchCord, jumper, cat 5, 568B, RJ45 to RJ45, 25 ft. part number PSCTC5B25F, Qty. 177. CLIN 15. Flush mount wallplate, quickport, single gang, four-port wallplate with 1 blank filler for use with quickport snap-in modules. Ivory color, part number41080-41P, Qty. 190. CLIN 16. Blank filler, quickport, 10 per bag, fits 41080-41P and 41080-61P, part number 41080-B1B, Qty. 20. CLIN 17. Surface mount box, quickport, 6 port, uses three 1-unit high inserts, providing from 1 to 6 fiber or copperports, dual fiber storage & management rings protect and store fiber, dimensions: 8'' x 5.325'' x 1.33''D Ivory color, part number 41296-MMI, Qty. 1. CLIN 18. Blank insert (module), quickport, 1-unit high for Leviton part #41290-SMI and 41296-MMI Ivorycolor, part number 41291-1BI, Qty. 2. CLIN 19. Jack, quickport snap-in category 5, RJ45 (WE8W/568A) Ivory color, part number 41108-RI5, Qty. 382. CLIN 20. Cable ties, Ties must have diameter range from 1/16 inch to 2 inch, total length of 8 inches.Must be able to accommodate 40 lbs of tension. 100 per pack. White in color, part number PLT2M-C, Qty. 10. CLIN 21. Cable ties. Ties must have diameter range from 1/16 inch to 3 inch, total length of 11.25 inches. Must e able to accommodate 50 lbsof tension. 100 per pack. Black in color, part number PLT2S-C, Qty. 5. CLIN 22. Tie mount. Must be adhesive mountable. Must work with panduit part number PLT2M-C, PLT3S-c and PLT4M-C. 100 per pack, Natural in color, part number ABM2S-AT-C, Qty.11. CLIN 23. Surface raceway latching duct, adhesive backed latching duct with integral cover. 6 foot lengths, color: electrical ivory, size: 46''H x 77''W x .62''T, part number LD3E116-A, Qty. 2. CLIN 24. Type E slotted wall duct, rigid polyvinylchloride (PVC), screw mounting, light gray color, 4''W x 5''H, 6 ft. lengths, part number E4X5LG6, Qty. 13. CLIN 25. Cover to fit panduit part number E4X5LH6 slotted wall duct, 6 ft. length, light gray color, part number C4LG6, Qty. 13. CLIN 26. Couplerfitting, used to connect two latching raceways together, must fit panduit part number LD3E16-A, color: electrical ivory, part number CF3EI-E, Qty. 2. CLIN 27. End cap fitting, used to cap the end of latching raceway, must fit panduit part numberLD3E16-A, color: electrical ivory, part number ECF3EI-E, Qty. 2. CLIN 28. Drop ceiling fitting used for latching raceway ceiling drops. Must fit panduit part number LD3E16-A, electrical ivory in color, part number DCF3EI-E, Qty. 2. CLIN 29.Innerduct, 1'', orange corrugated, part number 4404-R6-1000, Qty. 3,925 ft. CLIN 30. Wall mount cabinet, 19'' mounting on a swing frame, dimensions: 48''H x 28''W x 18''D, plexiglass door with lock, fan assembly with fan guard (3-100 CFM per fan), 6position power strip with circuit breaker and 12 ft. cord, IBM white, part number GLPP-48-18, Qty. 1. CLIN 31. Marker dispensing rolls used to dispense numbered, self stick markers for numbering of cables, contains on roll each of numbers 0 - 9, eachroll must contain fifty stickers, part number STD-0-9, Qty. 11. CLIN 32. Maker tags, self laminating, legend must be UV resistant with black on yellow background. Must have temperature range between -50 degrees F and 200 Degrees F, contains 100 tagsper pack, part number PST-FO, Qty. 11. CLIN 33. Black electrical tape, 1 inch wide, part number 33+SUPER, Qty. 12 rolls. CLIN 34. Ethernet port interface module. Provides one multimode ST connection for EPIM ports, 10 Base FL/FOIRL multimode fiberoptic port interface with ST connectors. Part number EPIM-F2, Qty. 15. CLIN 35. Fiber Optic Media Interface Module, 12 Port St, part number FOMIM-22, Qty. 1. CLIN 36. Manageable remote office hub, provides twelve RJ-45 ports, one modular EPIM port,two COM ports, and one BRIM port for additional bridging or Feeder Node Routing. SNMP complaint. Dimensions are 2.8 inches high by 17 inches wide by 13.5 inches deep. Capable of supporting four SHE hubs, part number MicroMMAC-22E, Qty. 5. CLIN 37.Manageable remote office hub provides twenty four RJ-45 ports, two modular EPIM ports, two COM ports, and one BRIM port for additional bridging or Feeder Node Routing. SNMP compliant. Dimensions are 2.8 inches high by 17 inches wide by 13.5 inchesdeep, capable of support four SHE hubs, part number MicroMMAC-24E, Qty. 8. CLIN 38. Power Supply Module, enhanced p/s module for the MMAC-M8FNB. One required, second provides redundancy and load sharing, part number MMAC-M8PSM-E, Qty. 1. CLIN 39.Clamp tie, manufacturer panduit, white color, screw-hole mounting, length 7.35'', 2 packages of 100 per package, part number SSC2S-S10-C. CLIN 40. Patch Cord, manufacturer premium wire & cable, multimode, 3 meter length, part number STZ/62CR03M, Qty.22. FOB Kelly AFB. The provision at FAR 52.212-1, instructions to offerors, applies to this acquisition. Evaluation is based on best value, cost and ability to meet service requirements. Offerors shall include a completed copy of the provision atFAR 52.212-3, offeror representation and certification - commercial items with its offer. The clause at FAR 52.212-4, contract terms and conditions - commercial items applies to this acquisition. In addition to the guidance contained in FAR 52.212-4,contractors shall submit proof of delivery with their invoices. Proof of delivery may be in the form of a bill of lading or other shipping document signed by the receiving office. Invoices received without proof of delivery will not be accepted. Theclause at FAR 52.212-5, contract terms and conditions required to implement statutes or executive orders - commercial items applies to this acquisition. Offers are due by close of business December 6, 1996, at the address shown above Attn: Delta Helm. Inquiries will only be accepted by FAX at the number shown above. (0323)

Loren Data Corp. http://www.ld.com (SYN# 0238 19961119\70-0001.SOL)