186th Air Refueling Wing/LGC, 6225 M St., Meridian, MS 39307-7112

54 -- HAZARDOUS MATERIALS STORAGE BUILDINGS (2 EA.) SOL DAHA2297Q7283 DUE 063097 POC SMSgt Gloria D. Jones, 601/484-9736, FAX 601/484-9539 E-MAIL: gjones@msmei.ang.af.mil, gjones@msmei.ang.af.mil. The 186th Air Refueling Wing is soliciting offers on a full and open competitive basis for hazardous materials storage buildings. This is a combined synopsis/solicitation for commercial items prepared in accordance with the format in FAR Subpart 12.6, as supplemented with additional information included in this notice. This announcement constitutes the only solicitation; offers are being requested and a written solicitation will not be issued. This solicitation number is DAHA2297Q7283, and is issued as a Request for Quotation (RFQ). The RFQ incorporates provisions and clauses as those in effect through Federal Acquisition Circular Number (FAC) 90-46. This solicitation is under the Simplified Acquisition Procedures (SAP) and is set aside totally for small business I.A.W. 52.219-6. The Standard Industrial Classification is 3448 and the Business Size Standard is 5.0 M. This solicitation is for the purchase of two prefabricated hazardous materials storage buildings to be used for oils, solvents, paints, etc. Both buildings must be completely self contained. This will be a Firm-Fixed Price Contract for two (2) line items as follows: Line item 0100 HAZARDOUS MATERIALS STORAGE BUILDING, a minimum of 215 Sq. Ft. This bldg. will be located outside an existing bldg. Features: Steel bldg., at least " thick tube steel skeleton clad with a minimum 10 ga. sump floor and minimum12 ga. walls and roof, at least (4) crane rooftop lifting lugs and base tiedown brackets, at least (2) 4" x 8" fork lift tubes under the bldg. for easy moving, painted steel grating bolted to floor supports welded to sump walls and floor. Sump floor shall be sloped toward middle of floor with a "N" (trench) sloped toward end of bldg., wall with a hand valve, minimum total sump capacity no less than 717 gallons, at least R-15 insulated 4 Heat Rated & Fire Rated (HRFR) walls and 3 HRFR ceiling, porcelain enameled steel interior finish with at least a15 year warranty, (1) 6' wide x 7' high R-15, 3 HRFR door with low profile panic door hardware, automatic fusible link door closer, no less than (4) explosion proof light fixtures, (1) crane hoist system with pallet grab to handle at least 2,400 lbs pallet loads, no less than (1) gravity or air intake vent with rain louver, bird screen and 3 HRFR fire damper, National Electrical Mfr. Association (NEMA) electrical entrance box, at least (1) float detector in drain pit and strobe alarm on roof with extra contacts for remote signaling, dry chemical fire suppression on ceiling with strobe alarm on roof with extra contacts for remote signaling outside wall( dry chemical fire suppression is required because no plumbing is available for a sprinkler system) no less than (1) explosion proof exhaust fan installed at top of outside and duct system, grounding devices, National Fire Protection Association (NFPA) placard, DOT decal, Factory Mutual Engineering and Research (FM) approved metal plate, at least a 6" red strip and FM and Fire Rated (FR) hourly marks. Offeror must advise total weight of bldg. and whether quote includes unloading and setup of bldg. If not, offeror must be able to provide 48 hours advance notice in order to arrange unloading by crane. Item No. 0200 Hazardous Materials Storage Bldg.,,a minimum of 313 sq. ft. outside. This bldg. will be located inside an existing structure, therefore, it must meet certain restrictions regarding dimensions. This building can be no longer than 24' long . Height and width of the building is critical. It must be delivered through a doorway which is 10' high (this will have to accommodate height of building plus and equipment necessary to move into existing building) and 10' 10" wide. Therefore, the offeror must provide dimensions with offer in order to evaluate whether bldg. can be delivered. Features: Steel bldg.,at least " thick tube steel skeleton clad with at least a10ga. sump floor and at least 12 ga. walls and no less than 4 roof crane rooftop lifting lugs, base tiedown brackets and no less than 2 4" x 8" forklift tubes under bldg( if bldg is in multi parts, forklift tubes must be per each module), painted steel grating bolted to floor supports welded to sump walls and floor, sump floors are sloped toward modular joint,sealed with at least a 10ga steel cap, each sump shall have a drain pit and hand valve, total sump capacity no less than 1043 gallons, R-15 insulated 4 HRFR walls and 3 HRFR ceiling, porcelain enameled steel interior finish with at least a 15 year warranty (1) 3' wide x 7' high R-15, 3 HRFR door with low profile panic door hardware, automatic fusible line door closer, no less than (4) explosion proof light fixtures, approximately 304 lin ft. of suspended shelving, (1) 3' wide x 6' long steel ramp, (1) set of safety hand rails for ramp at least(1) gravity or air intake vent with rain louver, bird screen and 3 HRFR fire damper, NEMA electrical entrance box no less than(2) float detectors in drain pits and strobe alarm on roof at least (4) head sprinkler piping system on ceiling with "R" (fire) alarm strobe on roof and extra contacts for remote signaling, (1) roof mounted explosion proof A/C unit to maintain no less than 70degree F. at least (4) head sprinkler piping system on ceiling with five alarm strobes on roof and extra contacts for remote signaling, no less than (1) explosion proof exhaust fan and outside wall duct system prepared to be ducted to the outside of the existing bldg., grounding devices, NFPA placard, DOT decal, FM approved metal plate, bldg. exterior painted with acrylic enamel and inside floor with two component polyamide epoxy, at least 6" red stripe with FM and FR hourly marks. Offeror must quote delivery will be responsible for setting up this bldg. Award will be based on all or none. No multi award contract is anticipated. All responsible offers will be considered. The following provisions apply to this acquisition: FAR 52.212-1 Instructions to Offers -- Commercial Items, with no addendum, Offerors responding to this announcement must provide information contained in this clause, FAR 52.212-4 Contract Terms and Conditions -- Commercial Items, with no addendum, 52.212-5 Contract Terms and Conditions Required to Implement Statutes or Executive Orders-Commercial Items, 52.222-3 Convict Labor, 52.233-3 Protest After Award, 52.203-6 Restrictions on Subcontractor Sales to the Government, with Alternate 1, 52.219-8 Utilization of Small Business Concerns and Small Disadvantaged Business Concerns, 52.219-14 Limitations on Subcontracting, 52.222-35 Affirmative Action for Special Disabled and Vietnam Era Veterans, 52.222-36 Affirmative Action for Handicapped Workers, 52.222-37 Employment Reports on Special Disabled Veterans and Veterans of Vietnam Era, 52.225-3 Buy American Act- Supplies, 52.225-18 European Union Sanctions for End Products, 52.225-21 Buy American Act-North American Free Trade Agreement Implementation Act-Balance of Payments Program. 52.203-10, Price of Fee Adjustment for Illegal or Improper Activity, 52.219-9, Small, Small Disadvantaged and Women-Owned Small Business Subcontracting Plan, 52.222-26, Equal Opportunity, 52.222-21 Certification of Nonsegregated Facilities, 52.222-22, Previous Contracts and Compliance Reports, 52.222-25, Affirmative Action Compliance. The Offeror shall extend to the Government the full warranty coverage of commercial sale, provided such warranty is available at no additional cost to the Government. Offeror must provide information on warranty being offered. Offerors responding to this announcement must include a completed copy of provision 52.212-3, Offeror Representations and Certifications Commercial Items. The offeror shall also provide its Commercial and Government Entity (CAGE) code, Contractor Establishment Code (DUNS number) and Tax Identification number. Delivery must be FOB Dest -- Meridian, MS and setup must be accomplished by 1 Dec 1997. Offers will be evaluated for fair and reasonable price and technical acceptability which will be determined solely on the content and merit of information submitted by the offeror in response to this notice. All offers must provide descriptive literature I.A.W. 52.214-21. All offerors must provide no less than 4 references within the last two years for the same type requirement which must meet or exceed all federal, state and local regulations and codes. All responsible sources may submit a quotation which shall be considered by this agency. However, this agency has the right to reject any offer. Written offers are due no later than 4:00 PM Central Day Light Savings Time, June 30, 1997. Offers sent my UPS, Federal Express etc. must be sent to 186th ARW/LGC, Bldg. 105, RM 115, 6225 M St., Meridian, MS 39307-7112. (0169)

Loren Data Corp. http://www.ld.com (SYN# 0264 19970620\54-0005.SOL)