DOE/Federal Energy Technology Center, P.O. Box 10940, MS 921-143, Pittsburgh, PA 15236-0940

61 -- ELECTRIC HEAT TRACING POWER CONTROL PANEL FOR 50 CIRCUITS POC Robert L. Mohn, Contracting Officer, (412) 892-4963 E-MAIL: rmohn@fetc.doe.gov, rmohn@fetc.doe.gov. 1. SCOPE: Furnish eletric heat tracing power control panel for 50 circuits. 2. ENVIRONMENT: The panel will be installed indoors and experience temperature between -20 deg F and 100 deg F. 3. SPECIFICATIONS: The panel shall be supplied with the following features: (1) 1 each NEMA-12 enclosure (72"W x 60"H x 10"D) with heat sinks. (2) 1 each 200A 3-pole KAL breaker. (3) 1 each Power distributor block. (4) 2 each 54 Space panelboard, 208/120, 3 phase, 4 wire. (5) 50 each Square D QOB130EPD-2100 breakers (or approved substitute). (6) 50 each Square D 240D110SP, 110A solid state relays (or approved substitute), 25 on each side wall. (7) 1 lot terminals, SSR gate power, heat trace power out. (8) 1 Power available indicating light. (9) 1 Door mounted disconnect switch. All components must be new. Certificates of Compliance must be furnished for all circuit breakers. 4. CODES AND STANDARDS: The panel and all components shall be manufactured in accordance with the requirements of the latest editions of applicable Codes and Standards published by the following Societies: ANSI -- American National Standards Institute. ASTM -- American Society for Testing and Materials. IEEE -- Institute of Electrical and Electronics Engineers. NEMA -- National Electrical Manufacturers Association. NFPA -- National Fire Protection Institute (NFPA 70, "National Electric Code"). All electrical components shall be suitable for use in the environment specified, and must be listed by Underwriter's Laboratories (UL), Factory Mutual (FM), or another nationally recognized testing authority except where such approvals have not been established. 5. INSPECTION: All components will be inspected upon receipt to ensure the parts are not suspect or counterfeit. 6. DELIVERY: Equipment must be received no later than 10 weeks after receipt of order. 7. SUBMITTALS: Vendors who respond to the Request for Quotations (RFQ) must meet the specifications without exception. You may request exceptions or deviations in advance by submitting them to the procurement office by 28-Nov-97 for DOE consideration and approval. The RFQ will be issued on 08-Dec-97. Once the RFQ is issued, no exceptions will be granted. NOTICE TO ALL VENDORS: WRITTEN (FAX) REQUEST FOR RFQ ACCEPTED ONLY, NO TELEPHONE CALLS. FAX NUMBER IS (412) 892-6216. SEE NOTE(S) -- 1. (0317)

Loren Data Corp. http://www.ld.com (SYN# 0233 19971118\61-0001.SOL)