Naval Surface Warfare Center, Code 1163, 300 Highway 361, Crane, IN 47522-5001

58 -- COMMUNICATION CONTROL SOL N00164-98-Q-0137 DUE 051498 POC Contact Ms. Diane Pearson, Code 1163W7, 812-854-5201, e-mail pearson_d@crane.navy.mil/Ms. Teresa Brough, Contracting Officer WEB: Naval Surface Warfare Center, Crane Division's homepage, www.crane.navy.mil. This requirement is reserved for small business. The US Navy has a requirement for the fabrication of 10 each Radome Lens Polarizer Assemblies, Band 3 Receivers. Fabrication will be in accordance with Raytheon Drawing G256363. The following is a brief description of what is required: Interpret drawing per DOD-D-1000; Front surface skin to be quartz glass/epoxy single layer laminate per G277028, Sidewall, flange and inner surface multilayer skin to be fiberglass epoxy laminate with 35-55% resin content per MIL-P-2541, glass cloth per MIL-C-9084, Weave Optional, Dielectric filler may be used in sidewalls, flange and where shown; Lamination of polarizer shell including sidewalls, flange, grid sheets (FN 6, 7 and 8) and core material (-11 and -12) shall be per G27619; There shall be no sharp edges or corners; Mask interior surfaces and flange mounting surfaces and paint exterior surfaces only. Apply primer MIL-P-85582 Type 1 Class N, or MIL-P-23377 Type 1, Color 16473, top coat .001-.002 thick. Apply primer and paint per process specification G636625; acceptance inspection criteria shall be based on the following: measurement of at least all of the noted dimensions; use of fixture G276969-1. Fixture shall be placed along radome flange a minimum of 5.30 inside of flange edge (both ends) as shown in section A-A and also be placed at approximate center of radome. Radome interior contour is acceptable if fixture does not tough it when laying against radome flange and surface of radome is no more than .125 from surface of fixture. Also, there shall be no more than .060 variance with all three measurements taken into account. A firm fixed price contract will be awarded utilizing Simplified Acquisition Procedures. Delivery is required March 1999, with shipping terms FOB Destination, NAVSURFWARCEN DIV., Crane, IN. Inspection and acceptance of the repaired unit(s) shall be performed by a representative of DCMC at source, prior to shipment. FAR Part 12 procedures will not apply. The Request for Quote will be posted on or about April 30, 1998 and will be available to be downloaded at www.crane.navy.com/Supply. The drawing package will be sent out separately. All responsible sources may submit an offer which will be considered by the agency. Inquiries may be submitted to Diane Pearson via e-mail pearson_d@crane.navy.mil or fax number 812-854-3805. Note 26 applies. (0106)

Loren Data Corp. http://www.ld.com (SYN# 0310 19980421\58-0004.SOL)