NASA/George C. Marshall Space Flight Center, Procurement Office, Marshall Space Flight Center, AL 35812

66 -- HUMIDITY AND TEMPERATURE SYSTEM FOR PAIN SPRAY BOOTH SOL 8-1-8-21-B9945 POC Kimberly R. Day, Contract Specialist, Phone (256) 544-8999, Fax (256) 544-4080, Email kimberly.day@msfc.nasa.gov -- Teresa A. Foley, Contracting Officer, Phone (256) 544-0335, Fax (256) 544-4080, Email teresa.foley@msfc.nasa.gov WEB: Click here for the latest information about this notice, http://nais.nasa.gov/EPS/MSFC/date.html#8-1-8-21-B9945. E-MAIL: Kimberly R. Day, kimberly.day@msfc.nasa.gov. This notice is a combined synopsis/solicitation for commercial items prepared in accordance with the format in FAR Subpart 12.6, as supplemented with additional information included in this notice. This announcement constitutes the only solicitation; quotes are being requested and a written solicitation will not be issued. This procurement is being conducted under the Simplified Acquisition Procedures (SAP). Item No. 1, Quantity 1 ea. Humidity And Temperature System; Designed To Discharge 8,500 CFM Of Conditioned Air (Heating, Cooling, Humidifying, Dehumidifying, And Reheating). This Unit Is Designed To Comply With A Temperature Range From 65 To 85 Degrees F And A Humidity Range From 45 To 60% Relative Humidity. This Unit Is Designed For To Set Outside The Paint Spray Booth And Ducted To The Booth. This Unit Is Of Single Wall Galvanized Construction With A 1" X 1.5# Mat Faced Insulation. Electrical To Be 460 Volt/3 Phase. This Unit Includes The Following: (a) 20" Fan With 8,500 CFM @ .25 Discharge S.P.; (b) 5 Hp ODP Motor With Efficiency And Adjustable Sheaves; (c) 3 Access Doors; (d) Fresh Air Intake Damper With Parallel Blades; (e) 2-Position Ielectric Discharge Damper; (f) 2" Pre-Filter (30% Efficient); (g) Heating Coil Section With Face And Bypass Dampers With Actuator; (h) Steam Distribution Coil; (i) Cooling Coil Section With Stainless Steel Drain Pan; (j) Electrical Control Panel With Strater, Temperature Control And On/Off Switches; (k) Fused Disconnect Switch; (l) Steam Injection Humidifier With Control Valve; (m) 3-Way Modulating Chilled Watervalve With Actuator; (n) On/Off Steam Valve With Actuator; (o) Outdoor Vestibule To Enclose Valves, Traps, Etc.; and (p) Intake/Discharge Ductwork Includes A Stand To Support Humidity And Temperature System, An Intake Hood, A 90 Degree Horizontal Discharge Elbow And A Straight Discharge Duct. The provisions and clauses in the RFQ are those in effect through FAC 97-04. This procurement is a total small business set-aside. See Note 1. The SIC code and the small business size standard for this procurement are 3829 and 500, respectively. The quoter shall state in their quotation their size status for this procurement. All qualified responsible business sources may submit a quotation which shall be considered by the agency. Delivery to MSFC is required within 30 days ARO. Delivery shall be FOB Destination. The DPAS rating for this procurement is DO-C9. Quotations for the items(s) described above may be mailed or faxed to the identified point of contact by the date/time specified and include, solicitation number, FOB destination to this Center, proposed delivery schedule, discount/payment terms, warranty duration (if applicable), taxpayer identification number (TIN), identification of any special commercial terms, and be signed by an authorized company representative. Quoters are encouraged to use the Standard Form 1449, Solicitation/Contract/Order for Commercial Items form found at URL: http://procure.arc.nasa.gov/Acq/Standard_Forms/Index.html to submit a quotation. Quoters shall provide the information required by FAR 52.212-1 with the exception of (d), (h), and (i). If the end product(s) quoted is other than domestic end product(s) as defined in the clause entitled "Buy American Act -- Supplies," the quoter shall so state and shall list the country of origin. The Representations and Certifications required by FAR 52.2l2-3 may be obtained via the internet at URL: http://ec.msfc.nasa.gov/msfc/pub/reps_certs/sats/ FAR 52.212-4 is applicable. Addenda to FAR 52.212-4 are as follows: MSFC 52.211-90-90, MSFC 52.232-90, NFS 1852.246-71, FAR 52.204-4, 52.211-15 and 52.247-34. FAR 52.212-5 is applicable and the following identified clauses are incorporated by reference: 52.222-26, 52.222-35, 52.222-36, 52.222.37, and 52.225-3. Questions regarding this acquisition must be submitted in writing no later than July 13, 1998. Quotations are due by July 17, 1998 to the address specified above. Selection and award will be made (on an aggregate basis) to the lowest priced, technically acceptable quoter. Technical acceptability will be determined by information submitted by the quoter providing a description in sufficient detail to show that the product quoted meets the Government's requirement. Quoters must provide copies of the provision at 52.212-3, Offeror Representation and Certifications -- Commercial Items with their quote. See above for where to obtain copies of the form via the Internet. An ombudsman has been appointed -- See Internet Note "B". It is the quoter's responsibility to monitor this site for the release of amendments (if any). Potential quoters will be responsible for downloading their own copy of this combination synopsis/solicitation and amendments (if any). Posted 07/06/98. (0187)

Loren Data Corp. http://www.ld.com (SYN# 0393 19980708\66-0004.SOL)