Naval Surface Warfare Center, Code 1163, 300 Highway 361, Crane, IN 47522-5001

66 -- OSCILLOSCOPE SOL N00164-98-Q-0211 DUE 091098 POC Ms. Pat Sturgis, Code 1163W3, telephone 812-854-1826, FAX 812-854-1841, Mr. Richard Colvin, code 1163WC, Contracting Officer WEB: click here to download a copy of the RFP, http://www.crane.navy.mil. E-MAIL: click here to contact the contracting officer via, sturgis_p@crane.navy.mil. This is a combined synopsis/solicitation for commercial items prepared in accordance with the format in FAR Subpart 12.6, as supplemented with additional information included in this notice. This announcement constitutes the only solicitation; proposals are being requested and a written solicitation will not be issued. Solicitation Number N00164-98-Q-0211 is issued as a Request for Quotation. Solicitation document and incorporated provisions and clauses are those in effect through Federal Acquisition Circular 97-07 and Defense Acquisition Circular 91-13. This action is reserved for small business 52.219-6. The following is a list of the requirements: Line Item 0001: Qty. Two (2) each Oscilloscope, Digital Phosphor, Tektronix, Inc. P/N TDS-540D/OPT 13/OPT 2F or equal in Accordance With the following Specifications: channels: 4 minimum, Bandwidth: 500 MHz minimum, Sample Rate: 1-4 channels -- 1 GS/sec min., Record Length: 1-4 channels- 50K min., Sensitivity: 1mV/div to 10V/div at 1 Mohm min., VerticalResolution: 8 bits, 12 bits, with averaging/high resolution minimum, Offset range: 10 times greater than the volts/div setting minimum, Time base range: 500ps/div to 10s/div min., Time Base Accuracy: 0.003% minimum, Pre-trigger: 0% to 100% of record minimum, Input coupling: AC, DC, GND minimum, Input Impedance: 1 Mohm in parallel with 10pF or 50 ohms, Total height: 8 inches maximum, Total width: 17.5 inches maximum, Total Depth: 17.5 inches maximum, Trigger (main): Auto, normal, single minimum, Trigger (delayed): Delayed by time, events or both minimum, Trigger types: edge, logic, and pulse minimum, Acquisition modes: peak detect, sample, envelope, average, high resolution, single sequence minimum, Automatic Measurements: period, frequency, width, high, low, minimum, maximum, peak to peak, amplitude, minimum, Functions: Waveform processing, waveform math, FFT, minimum, Interface: GPIB, GPGL, RS-232C, and centronics hardcopy minimum, GPIB programmability: Full control of all modes, settings, and measurements,Storage: Non-volatile for waveform and set-ups, Floppy disk drive, Line input: 120V, 60 Hz. The shipping terms will be f.o.b. destination, Naval Surface Warfare Center, Crane, IN, with the inspection/acceptance at destination. Delivery of Line Item 0001 will be required within 30 days from contract award. FAR Clauses/Provisions 52.203-3 Gratuities, 52.212-1 Instructions to offerors -- Commercial Items, 52.212-4 Contract Terms and Conditions -- Commercial Items, 52.212-5 Contract Terms and Conditions Required to Implement Statutes or Executive Orders -- Commercial Items (incorporating FAR 52.222-35 Affirmative Action for Special Disabled and Vietnam Era Veterans, 52.222-36 Affirmative Action for Handicapped Workers, 52.222-37 Employment Reports on Special Disabled Veterans and Veterans of the Vietnam Era, 52.225-3 Buy American Act-Supplies, 52.225-21 Buy American Act-North American Free Trade Agreement Implementation Act-Balance of Payments Program), 52.219-14 Limitation on Subcontracting, DFARS Clause 252.227-7015 Technical Data -- Commercial Items apply to this acquisition. The contractor shall extend to the Government the full coverage of any standard commercial warranty normally offered in a similar commercial sale, provided such warranty is available at no additional cost to the Government. Offerors responding to this announcement must provide the information contained in 52.212-1, Instruction to Offerors -- Commercial Items and must include a completed copy of provision 52.212-3, Offeror Representations and Certifications -- Commercial Items. The offeror should also provide its Commercial and Government Entity (CAGE) code, Contractor Establishment code (DUNS Number) and Tax Identification Number. If a change occurs in this requirement, only those offerors that respond to this announcement within the required time frame will be provided any changes/amendments and considered for future discussions and/or award. The written quotes and the above required information must be received at this office on or before 9/10/98 at 3:00 PM. Eastern Std. Time. Point of contact for information regarding this requirement is Ms. Pat Sturgis, 812-854-1826, FAX 812-854-1841, or e-mail sturgis_p@crane.navy.mil. All responsible sources may submit a quote which will be considered by the agency. Posted 08/31/98 (W-SN243575). (0243)

Loren Data Corp. http://www.ld.com (SYN# 0294 19980902\66-0011.SOL)