AFMETCAL Det 1/MLK, 813 Irving-Wick Dr W, Suite 4M, Heath, OH 43056-6116

66 -- RESISTANCE MEASUREMENT SYSTEM SOL F33660-99-R7006 DUE 040699 POC Buyer: Janet Casler, 740-788-5041, Contracting Officer: Glenna Pound, 740-788-5043 The Air Force Metrology and Calibration (AFMETCAL) program requires 35 each Resistance Measurement Systems in accordance with Directorate of Metrology Purchase Description 99MLEERSH01, Rev D, dated 15 Jan 99. Requirement includes a 5 year worldwide warranty and data with each unit. Options for 0-27 each in FY00 and 0-27 each in FY01 and an Option for Provisioning Data in FY01. General Description: The Resistance Measurement System shall be a medium performance system that may be used to measure low resistance to high resistance. This system shall be capable of measuring a variety of resistive type devices in both two terminal and four terminal modes. This system shall have the ability to perform automatic data acquisition, mathematical and graphical data analysis, graphical display of results, print data results and data storage of results. The measurement system shall have the ability to perform Turn-Key measurements of resistance devices at any point within the measurement range of 0.1ohm to 100 Megohm. Turn-Key measurements represents the ability of the system, after configuration setup, to make a non-stop resistance measurement or measurement sequence of resistors at a single value without the need for manual intervention or additional laboratory equipment. A Turn-Key measurement result will be displayed on a CRT type monitoring device and will be storable and transferable to standard internal memory/storage devices such as RAM and floppy disc. The contractor must provide all equipment necessary to make this a Turn-Key system. A resistance device will be defined as any electronic device or instrument that exhibits electrical resistance when a direct current is applied to it. This would include, but is not limited to, standard resistors and DC shunts. The complete system shall be capable of fitting on a benchtop not greater than 3 ft by 6ft and shall not require being stacked more than 3 ft high. Individual components shall be capable of fitting into a standard 19 inch rack width. Weight shall be a maximum of 300 lbs. Although a rack is not required for this system, the system shall be provided with all necessary accessories to enable maximum allowable rack mounting of its components in a standard 19 inch rack, including rack flanges and handles. As part of the delivery of this system the contractor will be required to provide training on the technical operation, physical operation and features as described in the purchase description. The training will be in the form of a CD that can be run on a PC. One CD will be required with each unit. A complete list of the performance/functional requirements is contained in the purchase description. Solicitation F33660-99-R7006. FOB Destination. Delivery to be a minimum of 3 each within 180 days after contract award and continue at a minimum rate of 3 each every 30 days thereafter until complete. All solicitation requests must be in writing. Written requests can be faxed to 740-788-5157. Oral request will not be accepted. Request for proposal will be issued approx. 8 March 1999. Closing date will be approx. 6 April 1999. All responsible sources may submit a proposal, which shall be considered. Special note to all prospective offerors: DOD will not award contracts to contractors that have not registered in the Central Contractor Registration (CCR) data base. Registration may be done by assessing the CCR via the Internet at http://ccr.edi.disa.mil or call the DOD electronic Commerce Information Center at 1-800-334-3414. See Note 26. Posted 02/17/99 (W-SN299224). (0048)

Loren Data Corp. http://www.ld.com (SYN# 0405 19990219\66-0013.SOL)