Social Security Administration, Region II, 26 Federal Plaza, Room 4010, New York, NY 10278

28 -- GEAR MOTORS USED IN MOSLER TELELIFT MODEL 1700 SOL SSARFQ-99-52003 POC Andrew Argiro, Contract Specialist, Tel: 212-264-2766, Fax: 212-264-2964 The Social Security Administration (SSA), Region II, seeks a contractor to supply and install approximately 160 replacement gear motors used in the Mosler Telelift Model 1700 self-propelled car (vehicle). The vehicles are used in the Automated Mail Distribution System at the Adabbo Federal Building in Jamaica, New York. The contractor shall remove and dispose of existing motors, and provide, install and test new motors. Request for Quotations is scheduled to be issued approximately March 15, 1999 with quotations due approximately April 8, 1999. This is a 100 % small business set aside. All responsible sources may submit a quotation which shall be considered by the agency. All requests for RFQs must be submitted in writing. The following is a general description of the characteristics of the motors to be supplied. It is intended for informational purposes only. The RFQ will contain the updated and final technical specifications. The following is not all-inclusive and is subject to change upon reevaluation by SSA: 1.1 The gear motor shall consist of a gear box with a "Spiroid" type gear design attached to a high torque 1/6HP permanent magnet 24 volt DC monitor. 1.2 The "Spiroid" type gear drive shall be self-locking. Provision for an externally mounted electrical brake will not be acceptable. 1.3 The motor shall not draw in excess of 12 amperes under full load and shall be capable of propelling the car containing the 25 lb payload over unrestricted vertical and horizontal distances. 1.4 The continuous duty gear motor shall produce 40 inch pounds of torque and an output RPM of 90. 1.5 The steel pinion and steel gear wheel shall be protected by an extreme pressure lubricant for increased thermal capacity and extended service life. 1.6 Motor Armature brushes shall be designed for replacement and extended service life. 1.7 Seals shall be of "Viton" for high temperature and extended service life. 1.8 The motor bell housing shall provide mounting holes for an externally mounted thermal and current detector. 1.9 The mounting position shall be both horizontal and vertical. Posted 02/25/99 (W-SN302538). (0056)

Loren Data Corp. http://www.ld.com (SYN# 0190 19990301\28-0009.SOL)