Department of the Treasury (2024), Federal Law Enforcement Training Center (FLETC), Procurement Division, Bldg. 28, Glynco, GA 31524

13 -- AMMUNITION AND EXPLOSIVES SOL FTC 99-8 POC Darlene Thompson, Procurement Technician (912) 267-2449, Patricia Newman, Contract Specialist (912) 267-3171 NON-TOXIC training ammuition for Department of Treasury, Federal Law Enforcement Training Center, Glynco (Brunswick), GA. Indefinite Quantity contract for estimated annual quantities, calibers, and garges shown herein, FOB Destination, and four anual option periods for shipment of similar quantities. SIC 33292 and 332993. There is a $25.00 (non-refundable) charge for the RFP; make checks payable to: "Federal Law Enforcement Training Center" RFP to be issued o/a April 15, 1999. Proposals due approximately 30 days later. Funds are not currently available for this procurement (see FAR 52.232-18). Possible calibers.garges and estimated quantities: .38 Special/625,000 rounds, .357 Magnum/95,000 rounds, .380 Cal/26,000 rounds, .45 ACP/240,000 rounds, .40 S&W/3,500,000 rounds, 9MM/5,200,000 rounds, 10MM/13,500 rounds, .223 Cal/675,000 rounds, .308 Cal/26,000 rounds, 7.62X39MM/10,000 rounds, and 12 GA(various loads)/325,000 rounds. Performance of this training ammunition must reasonably replicate interior and exterior ballistic qualities of leaded ammunition and be made to SAAMI specification for dimension and pressure. Ammunition must be within the permissible exposure limits established by the Occupational Safety and Health Administration (OSHA)and the Environmental Protection Agency (EPA), and, when fired, will not generate a hazardous waste as listed under 40 CFR. Reloaded ammunition is unacceptable. Must be suitable for use on indoor or outdoor ranges and velocity of handgun ammo may not exceed 1,700 feet per second, must function normally in all common law enforcement weapons without a requirement to alter such weapons, must not damage such weapons, shall not expose the shooter to toxic materials listed by the American Conference of Government Industrial Hygienists (ACGIH) threshold limit values or OSHA as listed in 29 CFR 1910. Any proposer will be required to provide testing data verifying compliance with detailed performance specifications listed in RFP. Proposers will be given the broadest possible latitude for the design of propellant, primer and bullet consistent with safety and performance requirements; ammunition may be subject to testing by the FLETC or other designated testing facility. Posted 04/06/99 (W-SN316666). (0096)

Loren Data Corp. http://www.ld.com (SYN# 0282 19990408\13-0001.SOL)