Dahlgren Division, Naval Surface Warfare Center, 17320 Dahlgren Road, Dahlgren, VA 22448-5100

70 -- AEGIS COMBAT SYSTEM INTERFACE SIMULATION SYSTEMS SOL N00178-99-R-2038 POC Code SD12, (540) 653-7942 WEB: NSWCDD Procurement Homepage, http://www.nswc.navy.mil/supply. E-MAIL: Questions concerning this synopsis., SD12@nswc.navy.mil. The U.S. Navy, Naval Surface Warfare Center, Dahlgren Division intends to negotiate a sole source indefinite delivery/indefinite quantity (IDIQ) contract with COMPAQ Computer Corporation, 20555 SH249, Houston, Texas 77070-2698, for an estimated quantity of 4 AEGIS Combat System Interface Simulation (ACSIS) Systems, including software, installation, support and warranty. This requirement is a follow on to contract N00178-98-C-2020 awarded to Digital Equipment Corporation. Each system shall be delivered as an operational system and shall consist of commercial multi-vendor hardware from COMPAQ and other manufacturers, and commercial software from COMPAQ integrated into an operational system. Each system shall be delivered with documentation and on-site warranty. The systems shall be operational ACSIS configurations comprised of multi-vendor Virtual Machine Environment (VME) Naval Tactical Data Systems (NTDS) interfaces, VME interfaces, cable harnesses, connectors, and other miscellaneous commercial interfaces. The design is based on the Digital Equipment Corporation CT- ACSIS-01/02/03 customized systems. The contractor must provide software engineering services for update to the custom drivers, diagnostics and configuration utilities to provide an operational system. The systems as identified shall perform NTDS communication via the VME NTDS interfaces which must functionally pass data to and receive data from AN/UYK-43 Tactical computers to simulate AEGIS ship board functions. The host system shall consist of a rack mounted Alpha Server 8400 configuration with three dual processor CPUs at the most current operational level and at least two 512 MEGABYTE memory modules. The system shall be capable of high speed PCI to VME interface and FDDI interface. All electrical and interface cabling and adapters shall be incorporated. All components shall be supplied with the appropriate commercial documentation, i.e., user guides, installation guides, configuration guides, etc., any associated software and licenses as required. The intended vendors and make/model items are identified as follows: Host system COMPAQ ( formerly Digital Equipment Corporation), Bus Analyzer -- VMETRO VBT-325B with Cable Package, NTDS A/B with on board RAM (530-2013-001) by Visicom, NTDS E with on board RAM (530-2017-001) by Visicom, NTDS E A/B Sabtech Hawke, Eagle and CONDOR, HP743-RT Processor Card, option 203 -- 100MHZ, no graphics, Hewlett Packard, with 2 each 64 MB RAM card, RS232 cable, Ethernet LAN cable, and SCSI cable -- A4261A w/option 203 & 2 ea. A4266A, VME FDDI DAS I/F w/ST connector & cable by Performance Technologies -- PT-VME600A-10521, VME VIDEO and 75 ohm video cable by DY4 Corporation -- SVME-770-000. The Low Level Serial (LLS) Subpanel chassis mount connectors must be compatible to Trumpeter connector part number TL80-14A. All parallel chassis mount connectors must match militarized 92 pin M28840/16AG1 S1 and S2 connectors except for the NSCC system which is 85 pin. Note 22 applies. All responsible sources may submit a proposal which will be considered. Solicitations and amendments will only be available via the World Wide Web at http://www.nswc.navy.mil/supply. No hard copies will be provided. Vendors should access the NSWCDD web site to make sure they have downloaded all amendments. DOD will no longer award contracts to contractors who are not registered in the Central Contract Registration (CCR) database. Registration may be accomplished by accessing the CCR web site http://www.acq.osd.mil/ec or via dial up modem (614) 692-6788, (User ID ccrpub; password pub2ccri). Any certified value added network (VAN) can be used for registration. A paper registration form may be obtained from the DOD Electronic Commerce Information Center at 1 (800) 334-3414. The U.S. Navy, Naval Surface Warfare Center, Dahlgren Division intends to negotiate a sole source indefinite delivery/indefinite quantity (IDIQ) contract with COMPAQ Computer Corporation, 20555 SH249, Houston, Texas 77070-2698, for an estimated quantity of 4 AEGIS Combat System Interface Simulation (ACSIS) Systems, including software, installation, support and warranty. This requirement is a follow on to contract N00178-98-C-2020 awarded to Digital Equipment Corporation. Each system shall be delivered as an operational system and shall consist of commercial multi-vendor hardware from COMPAQ and other manufacturers, and commercial software from COMPAQ integrated into an operational system. Each system shall be delivered with documentation and on-site warranty. The systems shall be operational ACSIS configurations comprised of multi-vendor Virtual Machine Environment (VME) Naval Tactical Data Systems (NTDS) interfaces, VME interfaces, cable harnesses, connectors, and other miscellaneous commercial interfaces. The design is based on the Digital Equipment Corporation CT- ACSIS-01/02/03 customized systems. The contractor must provide software engineering services for update to the custom drivers, diagnostics and configuration utilities to provide anoperational system. The systems as identified shall perform NTDS communication via the VME NTDS interfaces which must functionally pass data to and receive data from AN/UYK-43 Tactical computers to simulate AEGIS ship board functions. The host system shall consist of a rack mounted Alpha Server 8400 configuration with three dual processor CPUs at the most current operational level and at least two 512 MEGABYTE memory modules. The system shall be capable of high speed PCI to VME interface and FDDI interface. All electrical and interface cabling and adapters shall be incorporated. All components shall be supplied with the appropriate commercial documentation, i.e., user guides, installation guides, configuration guides, etc., any associated software and licenses as required. The intended vendors and make/model items are identified as follows: Host system COMPAQ ( formerly Digital Equipment Corporation), Bus Analyzer -- VMETRO VBT-325B with Cable Package, NTDS A/B with on board RAM (530-2013-001) by Visicom,NTDS E with on board RAM (530-2017-001) by Visicom, NTDS E A/B Sabtech Hawke, Eagle and CONDOR, HP743-RT Processor Card, option 203 -- 100MHZ, no graphics, Hewlett Packard, with 2 each 64 MB RAM card, RS232 cable, Ethernet LAN cable, and SCSI cable -- A4261A w/option 203 & 2 ea. A4266A, VME FDDI DAS I/F w/ST connector & cable by Performance Technologies -- PT-VME600A-10521, VME VIDEO and 75 ohm video cable by DY4 Corporation -- SVME-770-000. The Low Level Serial (LLS) Subpanel chassis mount connectors must be compatible to Trumpeter connector part number TL80-14A. All parallel chassis mount connectors must match militarized 92 pin M28840/16AG1 S1 and S2 connectors except for the NSCC system which is 85 pin. Note 22 applies. All responsible sources may submit a proposal which will be considered. Solicitations and amendments will only be available via the World Wide Web at http://www.nswc.navy.mil/supply. No hard copies will be provided. Vendors should access the NSWCDD web site to make sure they have downloaded all amendments. DOD will no longer award contracts to contractors who are not registered in the Central Contract Registration (CCR) database. Registration may be accomplished by accessing the CCR web site http://www.acq.osd.mil/ec or via dial up modem (614) 692-6788, (User ID ccrpub; password pub2ccri). Any certified value added network (VAN) can be used for registration. A paper registration form may be obtained from the DOD Electronic Commerce Information Center at 1 (800) 334-3414. The U.S. Navy, Naval Surface Warfare Center, Dahlgren Division intends to negotiate a sole source indefinite delivery/indefinite quantity (IDIQ) contract with COMPAQ Computer Corporation, 20555 SH249, Houston, Texas 77070-2698, for an estimated quantity of 4 AEGIS Combat System Interface Simulation (ACSIS) Systems, including software, installation, support and warranty. This requirement is a follow on to contract N00178-98-C-2020 awarded to Digital Equipment Corporation. Each system shall be delivered as an operational system and shall consist of commercial multi-vendor hardware from COMPAQ and other manufacturers, and commercial software from COMPAQ integrated into an operational system. Each system shall be delivered with documentation and on-site warranty. The systems shall be operational ACSIS configurations comprised of multi-vendor Virtual Machine Environment (VME) Naval Tactical Data Systems (NTDS) interfaces, VME interfaces, cable harnesses, connectors, and other miscellaneous commercial interfaces. The design is based on the Digital Equipment Corporation CT- ACSIS-01/02/03 customized systems. The contractor must provide software engineering services for update to the custom drivers, diagnostics and configuration utilities to provide an operational system. The systems as identified shall perform NTDS communication via the VME NTDS interfaces which must functionally pass data to and receive data from AN/UYK-43 Tactical computers to simulate AEGIS ship board functions. The host system shall consist of arack mounted Alpha Server 8400 configuration with three dual processor CPUs at the most current operational level and at least two 512 MEGABYTE memory modules. The system shall be capable of high speed PCI to VME interface and FDDI interface. All electrical and interface cabling and adapters shall be incorporated. All components shall be supplied with the appropriate commercial documentation, i.e., user guides, installation guides, configuration guides, etc., any associated software and licenses as required. The intended vendors and make/model items are identified as follows: Host system COMPAQ ( formerly Digital Equipment Corporation), Bus Analyzer -- VMETRO VBT-325B with Cable Package, NTDS A/B with on board RAM (530-2013-001) by Visicom, NTDS E with on board RAM (530-2017-001) by Visicom, NTDS E A/B Sabtech Hawke, Eagle and CONDOR, HP743-RT Processor Card, option 203 -- 100MHZ, no graphics, Hewlett Packard, with 2 each 64 MB RAM card, RS232 cable, Ethernet LAN cable, and SCSI cable -- A4261A w/option 203 & 2 ea. A4266A, VME FDDI DAS I/F w/ST connector & cable by Performance Technologies -- PT-VME600A-10521, VME VIDEO and 75 ohm video cable by DY4 Corporation -- SVME-770-000. The Low Level Serial (LLS) Subpanel chassis mount connectors must be compatible to Trumpeter connector part number TL80-14A. All parallel chassis mount connectors must match militarized 92 pin M28840/16AG1 S1 and S2 connectors except for the NSCC system which is 85 pin. Note 22 applies. All responsible sources may submit a proposal which will be considered. Solicitations and amendments will only be available via the World Wide Web at http://www.nswc.navy.mil/supply. No hard copies will be provided. Vendors should access the NSWCDD web site to make sure they have downloaded all amendments. DOD will no longer award contracts to contractors who are not registered in the Central Contract Registration (CCR) database. Registration may be accomplished by accessing the CCR web site http://www.acq.osd.mil/ec or via dial up modem (614) 692-6788, (User ID ccrpub; password pub2ccri). Any certified value added network (VAN) can be used for registration. A paper registration form may be obtained from the DOD Electronic Commerce Information Center at 1 (800) 334-3414. Posted 04/22/99 (W-SN323417). (0112)

Loren Data Corp. http://www.ld.com (SYN# 0312 19990426\70-0003.SOL)