AFMETCAL Det 1/MLK, 813 Irving-Wick Dr W, Suite 4M, Heath, OH 43056-6116

66 -- PORTABLE INSTRUMENT CONTROLLER SYSTEM SOL F33660-99-Q7510 DUE 070999 POC Jim Hood,Contract Specialist, 740-788-5046 or Glenna Pound,Contracting Officer, 740-788-5043 AFMETCAL DET 1 intends to purchase ten (10) each Portable Instrument Controller Systems using Simplified Acquisition Procedures IAW FAR parts 12 and13.Portable Instrument Controller System. It shall be a high performance system such that it may be used in a portable measurement station. This system, when properly programmed shall have the ability to perform automatic data acquisition, mathematical and graphical data analysis, data display of results, print data results, data storage of results and transfer of data via modem and ethernet network interfacing. This system shall improve and expand the U.S. Air Forces capability to measure voltage parameters. The purchase description and the RFQ list the Air Force minimum (but, not limited to) functional requirements which are to be satisfied. This Controller System shall have the ability to control Turn-Key measurements of voltage devices as required by a portable measurement station. Turn-Key measurements represents the ability of the Controller System,after configuration setup and programming, to make a non-stop voltage measurement or measurement sequence of voltage references at a single value without the need for manual intervention. This process will result in a Turn-Key measurement result. A Turn-Key measurement result will be displayed on a LCD type monitoring device and will be storable and transferable to standard internal memory/storage devices such as RAM, hard disc, floppy disc and remotely via modem and ethernet network interfacing. All equipment necessary to make this a Turn-Key Controller System must be provided by the contractor. This Controller System shall be compatible and capable of being programmed to control electronic equipment such as a Keithley 181/182M nanovoltmeter and a Data Proof 160A/320A low thermal scanner via the IEEE-488.2 format interface bus. Rack Mounting: A rack is required for this system, the system shall be provided with all necessary hardware and accessories to enable maximum allowable rack mounting of its components in a standard 19 inch rack, including rack flanges and handles. It is preferred that the rack mounting hardware utilize a two-tier drawer/tray system, one for the controller and one for the printer. Each component will be secured to the drawer/tray. When in storage mode there will be a securable flip up front panel that will conceal and hold the drawer(s)/tray(s) in place. When in operational mode the drawer(s)/tray(s) may be pulled outward for easy access to and operation of the controller and printer. This system shall be delivered with the controller and printer mounted as stated. Physical Requirement: The above hardware will be required to fit into a standard 19-inch rack assembly. The total combination of the controller, printer and rack mounting hardware shall fit into a space confined to 6 inches in height by 16 inches in depth and the standard 19 inch rack width, when in transport or storage mode. FOB destination pricing is desired. Delivery will be required 75 days after receipt of order. All responsible sources may submit an offer which will be considered. All solicitation requests must be submitted in writing. Written requests can be faxed to 740-788-5157. Oral requests will not be accepted. All quotes must submitted to this office no later than 4:00 PM (EDT) July 9, 1999. Special note to all prospective offerors: DOD will award contracts to contractors that have not registered in the Central Contractor Registration (CCR) data base. Registration may be done by accessing the CCR via the Internet at http://ccr.edi.disa .mil or call the DOD Electronic Commerce Information Center at 1-800-334-3414. Posted 06/18/99 (W-SN344591). (0169)

Loren Data Corp. http://www.ld.com (SYN# 0331 19990622\66-0008.SOL)