U.S. Department of Justice, Federal Bureau Of Investigation, J. Edgar Hoover Building, Rm 6833, 935 Pennsylvania Ave., N.W., Washington, DC 20535-0001

J -- MAINTENANCE, REPAIR, AND REBUILDING OF EQUIPMENT SOL RFQ 858733A DUE 091099 POC Renee D. Dorsey, Contract Specialist, (202) 324-5821 The Federal Bureau of Investigation (FBI) has a need to remanufacture a Monarch 10" EE Precision Toolroom Lathe. This requirement is being issued under Simplified Acquisition Procedures (SAP) as a Request for Quotation (RFQ) and is a 100% Small Business-Small Purchase Set Aside. The Standard Industrial Classification (SIC) Code is 8999 and the Business Size standard is based on gross receipts of $5 million. Award will be made on a firm fixed-price basis. This is a one-time buy. The remanufacturing of this equipment shall bring the existing lathe into current compliance with new machine tolerances and performance characteristics, to include the spindle speed range of 42-4000 rpm, the latest 10 HP variable frequency, direct drive, and the high torque spindle drive system. The Contractor shall, upon arrival at their facility, perform operational tests and measurements that will determine the condition of the lathe and establish it to be remanufacturable. The condition of the lathe shall be fully documented and shall include; problems detected, repairs/replacements needed. The Contractor shall thoroughly check and evaluate equipment upon arrival at the contractor's facility for any uncertainties involved in performance and their possible cost impact in a written quote to the Contracting Officer. The Contractor shall perform the following re-manufacture services, on the Monarch 10" EE Precision Toolroom Lathe (S/N 50153): (a) All seals, gaskets, wipers, gibs, shims, shall be replaced (b) Machine lubrication components shall be thoroughly cleaned and/or replaced as needed (c) All bearings shall be examined and replaced as needed. Bearings deemed essential to achieving new machine performance standards shall be replaced (d) The bed, carriage and slides shall be reground and hand scraped to achieve alignment consistent with new machine standards (e) The headstock spindle shall be re-manufactured to achieve runout consistent with new machine standards (f) The apron worm, worm gear, rack pinion gear and shaft, half-nut, driver and drive plate shall be replaced (g) The leadscrew, crossfeed screw and nut, compound screw and nut and tailstock nut shall be replaced (h)The existing taper attachment and tailstock shall be reconditioned (I) The spindle drive system shall be replaced with at least a 7.5 HP solid state drive system with a new back gear unit. The new drive system shall fit into the machine space occupied by the original drive system to negate the need for the large electrical enclosure mounted behind the headstock (j)The lathe shall be painted NMTBA #7 Gray (k) The re-manufactured lathe shall be capable of proper operation when connected to a 208 vac, 3 phase, 60 Hz electric supply (l) The lathe shall be able to achieve the certified performance and accuracy standards of a new production for a Monarch 10" EE Precision Toolroom lathe, not that of a lesser standards of a rebuilt lathe. The above listed characteristics are intended to be descriptive, but not restricted. The purchasing activity is not responsible for locating or securing any information which is not identified in the quotation and reasonably available to the purchasing activity. Concerns having the ability to furnish the above service are to request in writing a copy of the RFQ or fax the request to the attention of the Contract Specialist on 202 324-8031 or 202 324-8040. No telephone inquiries will be accepted. Posted 08/27/99 (W-SN373679). (0239)

Loren Data Corp. http://www.ld.com (SYN# 0067 19990831\J-0016.SOL)