|
COMMERCE BUSINESS DAILY ISSUE OF APRIL 6,2000 PSA#2573Supply Department NAVSEA Indian Head, 101 Strauss Ave, Indian Head, MD
20640-5035 36 -- TPE ROCKET PROPELLANT CONTINUOUS MOLDING SYSTEM SOL
N00174-00-R-0029 POC Donna M. Chaney, Contract Specialist, Code 1142B,
(301) 744-6656, Fax (301) 744-6547 IMPORTANT NOTICE: To register for
this solicitation, you must email the following directly to Donna
Chaney at Chaneydm@ih.navy.mil: Solicitation Number (in subject line of
your email); Name of the requestor, Organization name, address,
telephone and fax numbers; and your E-mail Address. Use your email read
notification feature to confirm the contract specialist's receipt of
your registration. The government is not responsible for any
undelivered e-mail transmissions. It's the requestor's responsibility
to periodically check the IHDIV Contracts Division website for current
status of solicitation and amendments. Once the solicitation has been
issued on the Internet, the contract specialist will send an e-mail
message to the registered requestors informing them that the
solicitation is now available for downloading off the Internet. Copies
of issued solicitations can only be obtained by downloading them from
the IHDIV Contracts Division website at
http://www.ih.navy.mil/contracts (copies of solicitations will not be
e-mailed, faxed, mailed, or provided in person, these types of requests
WILL NOT BE ACKNOWLEDGED.) NOTE: All offerors will be ineligible for
award unless they have registered in DOD's Central Contractor
Registration database. Offerors and contractors may obtain information
on registration and annual confirmation requirements by calling
1-888-227-2423, or via the Internet at http://ccr.edi.disa.mil. This
requirement will be available for downloading from our website
beginning approximately 19 April 2000. Prior to this date you will not
be able to access this solicitation. The requirement is a 100% small
business set-aside. The SIC code is 3769, sixe standard is 1000
employees and FSC Code is 3690 This requirement is for the fabrication
of a Thermal Plastic Elastomer (TPE) Rocket Propellant Continuous
Molding System. The design for this equipment shall be provided by the
government. The system is intended to load ERGM motor cases, which are
approximately 4 inches in diameter and 14 inches long, under vacuum,
with propellant produced continuously on a twin screw extruder. The
system shall be controlled remotely from a distance of approximately
500 feet. The required delivery date is 120 days after date of
contract. This requirement will be awarded as a Best Value based on a
tradeoff of price and other factors as setforth in the solicitation.
Posted 04/04/00 (W-SN440917). (0095) Loren Data Corp. http://www.ld.com (SYN# 0163 20000406\36-0001.SOL)
36 - Special Industry Machinery Index Page
|
|