Commander, Naval Air Warfare Center, Weapons Division, Code 230000E, 521 9th Street, Point Mugu, CA 93042-5000

T -- RANGE PHOTO INSTRUMENTATION SERVICES-POTENTIAL SOURCES SOUGHT-SECOND NOTICE SOL N68936-00-R-0108 DUE 061600 POC Nancy Garza, Contract Specialist, (805) 989-1880 This is a sources sought synopsis. If you have previously submitted your interest, you need not reply to this second notice. This sources sought synopsis requests information needed prior to release of any resultant solicitation. This is not a request for proposals and in no way obligates the Government in an award of any contract. A SOLICITATION DOES NOT EXIST AT THIS TIME. The Naval Air Warfare Center Weapons Division (NAWCWD), Range Instrumentation Division is seeking a Commercial Source, under a Commercial Activity A-76 study, to provide photographic optic labor and support services for the Point Mugu Sea Range, for the China Lake Land Range. It is intended to perform a cost comparison, pursuant to OMB Circular No. A-76 Commercial Activities Studies, in order to determine the most efficient and cost effective performing activity. Accordingly, a contract may or may not ultimately be awarded as a result of the study/cost comparison. The period of performance for this work is projected to be five years. Potential Contractor's must have experience in creating and executing photo plans to meet test objectives similar to those of NAWCWD. Typical test scenarios include: 1. Missile egress from US Navy ships and aircraft; 2. Missile or drone tracks from launch to impact; 3. Missile impacts on remote land-based targets, target vessels, and airborne targets; 4. Re-entry and launch vehicles; 5. Seat ejections; 6. Parachutes; 7. High-speed projectiles. Scenarios include the acquisition of both documentary and photogrammetric data, and are often run concurrently. These scenarios sometimes require the Contractor to install photographic optic equipment within the hazard footprint of weapon systems under test and to provide operational support under adverse environmental conditions. The Contractor shall develop and implement the photo plans for these scenarios. The Contractor shall develop cost estimates for implementing the photo plans to meet the test objectives. The Contractor shall: Generate flight profiles and brief and direct flight crews to meet test plan objectives for stabilized optical systems; Install and fabricate unique camera mounts on targets, surface vessels, and remote land sites; Transport equipment on foot, by helicopter, by 4-wheel drive vehicles, by barges, and by small craft; Setup and calibrate equipment, some of which may be located at surveyed land sites and on airborne platforms under adverse conditions; Run the photo optic portion of the tests and acquire the data, which includes Time Space Position Information data, documentary data, scoring data, and laser measurement and designation data on film and video media. Recover photo resources after completion of tests; Distribute real-time data via microwave and fiber-optic links and near real-time photo and video products; Produce and distribute post-test edited videos in formats such as analog and digital videotape and digitally compressed files for CD-ROM and the intranet; Produce photo lab products and services. The Contractor shall: Provide on-location and in-studio photography services; Develop 16/35mm motion picture film and 35mm, 120, 220, and 70mm still film; Print still photographs in sizes ranging from 2 x 3 inches to 30 x 40 inches; Create graphics and digital image designs in sizes up to 500 sq. ft; Mat, frame and mount photographic and digital images; Operate and maintain a customer service desk and photographic/video archival library; and Operate and maintain photo lab computerized billing system. The Government will provide (as Government Furnished Equipment) Kineto Tracking Mounts (KTM), Automated Laser Radar Instrumentation Tracking Equipment (ALRITE), Airborne stabilized optical systems (CAST GLANCE and CAST EYES systems), M-45 tracking mounts, a Cine-Sextant mount, airborne photographic pods, Metric Infrared Instrumentation System (MIRIS), Infrared and laser optical systems. The Government will also provide documentary film and video cameras, still and motion picture film processing and printing equipment, and video editing systems for analog and non-linear editing. The Contractor shall: Perform preventive maintenance and repairs for Government Furnished Equipment (GFE) down to the component level; Make real-time repairs in the field during tests; Build and upgrade KTMs, ALRITE laser trackers, M-45 tracking mounts, and CAST GLANCE airborne optics systems; Convert KTM-As to KTM-Bs. This conversion requires modification of the electronics, mount hardware, system software, sensor upgrades, and acceptance testing; Perform configuration management services on all equipment. Configuration Management includes writing change proposals, participating in the Configuration Control Board, and implementing approved changes. To provide these services, Contractor personnel shall possess California Class A driver's licenses and aircrew certification capability (according to Naval Air Training Operating Procedure (NATOPS), OPNAVINST 3710.7, and NAVAIR 01-75PAA-1.1 P-3A/P-3B certification manuals). The support requires Top Secret and Top Secret SBI clearances for roughly 25% of the Contractor's workforce and Secret Clearances for the rest. Contractor personnel must be able to transfer from ship to ship, from helicopter to ship, and from ship to helicopter. Contractor personnel must be laser safety and respirator certified. Contractor personnel must possess or be able to obtain Navy Crane and hoist certification, California license to operate a forklift, medical certification (sight and hearing), and CPR certification. Fitness for duty is required for employees whose duty station is offshore. Contractor personnel must be able to lift equipment up to 50 pounds. The Sea Range at Point Mugu, California, consists of 36,000 square nautical miles of controlled operational airspace and a sea surface operations area. It is bordered by coastal mountains and includes a chain of islands. Point Mugu is approximately 50 miles northwest of Los Angeles. Work sites at the Sea Range include Point Mugu, San Nicolas Island (SNI), San Clemente Island, Santa Cruz Island, and LagunaPeak. The Land Range is located at China Lake, California, near the city of Ridgecrest, in the upper Mojave Desert of Southern California, approximately 160 miles northeast of Los Angeles. The terrain includes dry flat lakebeds, large dry washes, alluvial fans, open desert, and pine-covered mountains. The Land Range is used exclusively for testing and evaluating missiles, aircraft, and bombs. Temperatures range from 25 degrees F in the winter to 120 degrees F in the summer. Other operational locations include US Navy ships, small crafts, aircraft, helicopters, and other platforms; Edwards Air Force Base (AFB); Vandenberg AFB; Construction Battalion Center (Port Hueneme); White Sands Detachment in New Mexico; the Pacific Missile Range Facility in Hawaii; and sites in other states, US Territories, Canada, Europe, South America, and Asia. If you are interested in competing for this requirement, please indicate your interest by sending an email to Ms. Nancy Garza at garzan@navair.navy.mil. You will be required to complete a Contractor Profile Questionnaire. Responses are due by 3 August 2000, therefore you are encouraged to request the questionnaire as soon as possible in order to have sufficient time to prepare your responses. Questionnaires will be sent via email. Responses may be made via email to Ms. Garza. Faxed requests and responses are acceptable and should be sent to Ms. Garza at (805) 989-0561. Ultimately, the solicitation will be available over the Internet in Microsoft Word format and will reside upon the NAWCWD Contracts Homepage, located on the World Wide Web at www.nawcwpns.navy.mil/~contract/homepubl.htm. An Industry Brief Day will be held on 21 September 2000 at NAWCWD China Lake, CA. Exact location and times will be published at a later date. It is anticipated that the solicitation will be released in November 2000. All companies indicating interest in this procurement will have their company name, address and telephone number posted on an Interested Parties List. This list will be posted with the solicitation on the NAWCWD World Wide Web page at the address listed above. All interested parties must check the NAWCWD World Wide Web Page to obtain a copy of the solicitation. Posted 07/20/00 (W-SN476958). (0202)

Loren Data Corp. http://www.ld.com (SYN# 0103 20000724\T-0004.SOL)

| T - Photographic, Mapping, Printing and Publication Services Index  |  Issue Index |